Woche 11

So this week I am starting to notice some watering issues I have cause early in the veg cycle I should have a payed a little more attention but noticed that I habe water logged my soil in a single plant causing soil lock and not completely drying out like the others between watering I will try to correct course this finally week of veg before changing over to flower. But the smells are definitely stronger excited to see this last bit of growth and it's time to start taking clones for another run

They are stretching their legs now, explosive pre flower stretch is happening. They are doing well now

they now started turning pur

✋Wk 7: Will the size difference begin to fall in line with the predictions, and rearranging the wind. 👉 This week is Day 48 thru Day 54 total. (Feb 16 thru 22). Today (day 54ttl) the 1 gallon plant is at day 21 flower and the 3 gallon is at day 9 flower. 👉 This week has shown some interesting things. The 1 gallon plant is still ahead in the physical timeline, and has also started to demonstrate how the smaller pot is limiting its size. The 1 gallon has been ahead of the 3 gallon plant in size and stature, until this week. The 1 gallon has stopped stretching and is beginning to develop its flowers. I was worried it would continue to get bigger and may become an issue vertically as well as horizontally. The 3 gallon plant has grown a few inches and isn’t really stretching up yet, but it is growing overall in size. It’s a big dome of leaves right now. Its main cola is same height as a couple of the secondary branches. I doubt the main cola will remain the same but this plant hasn’t been typical from its germination so only time will tell. 👉 The other interesting thing has actually been trending this way for a couple of weeks…the run-off for both plants has been lower than the inflow and no low EC fertigation has been needed. The 1 gallons roots are undoubtedly densely packed in the pot. It takes several minutes to apply the nutrient solution. The volume needed has also increased. The 3 gallon still readily accepts the solution, but it takes more every day and the run off takes longer to start running out of the bottom. The saturation level of both pots has increased, and the 3 gallon especially. The EC for both has stayed below the inflow EC. This is unusual because part of the volume of water in the pot when saturated isn’t absorbed by the plant, it evaporates on all sides of the pot and the top of the media. This would leave the dried nutrients wich would rinse off at each fertigation adding to the TDS. The reduction of EC in the run-off means the nutrients are being utilized by the plant. I have dropped the inflow EC of the 3 gallon a little because I was worried about burn. I have kept the EC of the 1 gallon plant at the low end of the recommended EC range of the General Hydroponics drain to waste nutrient schedule chart for the Flora series of nutrients. I use the entire line of these nutrients. For the one gallon I had been giving it only the “simple program”, and the 3 gallon the “expert” (entire line). This week when I noted that the stretch has pretty much ended for the 1 gallon, and decided that I will go ahead and give it the expert mixture as well but given at the low end of the EC range still. Ive included the Fertigation log for the week. It shows the tent temps, the outdoor temps and HVAC setting. Also, I note when a fresh batch is made and what week on the schedule it is. Each pot has the recorded time of fertigation, volume, pH, and EC of the solution given and the corresponding run-off. I mix the solutions at full strength and use a solution with just silica and Cali-magic to reduce the EC to the desired EC. I mix that in at fertigation time. I also adjust the pH if necessary at this time. 👉 The structure of the 1 gallon is very stout main trunk, and each branch is very sturdy. The bigger fan leaf production has given way to smaller leaves. The structure of the 3 gallon also has a very stout main trunk and each branch is very sturdy. The 3 gallon has some very large fan leaves and it has lots of vegetation. Its very dense and hard to peer inside. For both plants I have begun to selectively remove branches that would not be producing anything but larf. The 1 gallon only needed the lowest main branches trimmed. I also removed some of its smaller shaded secondary branches and leaves inside the canopy. The trimming on the 3 gallon is similar, however its much harder to get inside. I just do a little at a time at each fertigation. Im not sure if the first set of branches on the 3 gallon will be tall enough to keep but I want to wait till the plant starts stretching to see what they will do. Ive left as many leaves as possible in the 3 gallon…a lot of really nice fat food factories. This plant may go very large, or it may stay somewhat stunted as it did during the early veg phase. 👉 I positioned the plants I closer to the back wall. I bought a oscillating tower fan and was hoping it would be a good addition to the tent. Alas, it had too strong of a wind current (on the lowest speed) and the 1 gallon was showing signs of wind stress after 2 days. So I removed the fan and re-positioned the smaller fans I had clipped up top of the tent. Both fans are now hanging lower on adjustable ropes and point toward the plants. They are working well like this and the air flow is good. I may modify the oscillating fan and install a variable resistor to the fan motor to reduce the flow. I have added the branch support to the legs of the stand the 1 gallon is on. These posts will be used to support the weight of buds or position them as needed. I will add the support posts to the 3 gallon plant after it has gone thru its stretch, maybe another 2 weeks for that.

Day 55 of flower. I think she will need another 2 weeks.. dont know if I should harvest already...I´m scared ... 😱😬 I removed all the leaves with crispy ends the smell is still amazingly sweet and there willl be a little bit of a yield I just hope she will survive. see ya next week my friends 👌

Привет Садоводы и огорники !!!

Good morning I germinated my seeds for 24 hours in water and then in an airtight paper towel bag. 48 hours everything has germinated 8/8. thank you for taking a look at my profile, kisses see you soon

i love the flowering stage .........im new to this site i love to get or give advice very open minded into new styles of growing!!!!!!!!!!.....................i kept up my lst 5th day 2nd week of flower im all caught up on my update!!!

FLOWERING IS UPON US for all of the strains I wanted to let the 2 purple berry Kush veg for another week but forgot to put them under the TS-1000 but hopefully there still gone grow fine it is experiment achter all. Have made the switch for 12/12 couple day's ago and i see them all developing 😍 hopefully by the end of next week it will get interesting 👌🏻 visit www.marshydro.eu for your best gear and use the PROMO CODE: DEVILSBUD Some info about the Marshydro FC-4800 Superb Quality LED Chips: The whole light is composed of 1206 pcs Samsung lm301b and Osram 660nm chips. More than two times as many LEDs are used to drive the grow lights at low currents and to avoid overdrive. Quality is guaranteed and efficiency is up to 2.8 μmol/j. Even PAR Distribution and High PPFD Output: The multi-light bar design and the densely distributed light chips enable the LED grow lights to achieve the optimum PPFD required for plant growth over the entire effective coverage area. Specifically Designed Spectrum: To ensure even plant growth, blue and red light are enhanced on the basis of a full spectrum combination. Not only does this accelerate plant growth, but it also improves the yield and quality of the plants at the same time. Dimming Daisy Chain Function: The dimming function saves on electricity costs and enables brightness from 10% to 100% for the different stages of plant growth. A single master light can connect up to 30 lights in a daisy-chain system. Business LED Grow Light: The light's wavy heat sink dissipates heat quickly and the IP65 waterproof allows the light to operate in humid conditions. 180° collapsible feature for easier installation. All these features provide favorable assistance for commercial cultivation. And some tent info ●【Lock All Light Insid】MARS HYDRO Grow Tent Interior is made of diamond mylar. Non-toxic to the environment, no harm to plants. High-quality 1680D canvas being double stitched, (ALL OTHERS BRAND grow tent is 601D canvas) which is tear-proof for perfect light locking, No light leaks or rips at all. ●【Durability Grow Tent】Stable Metal corner adapters and poles are the trustful supporters of the tent. No rusting nor paint-falling. Quick easy tool-free installation. Carries strong heavy-duty SBS zippers, double layer lining to create a light-proof seal. ●【Easy Observation of your Plants】Special peeks window made by double layers of cloths. Observe the growing conditions of your plants without opening the tent and avoid disturbing plants. The peek window also serves to dissipate heat and ventilate air. ●【Removable Tray Keep Clean】The package includes a removable waterproof floor tray to hold soil and fallen leaves. The tray can be taken out easily to wash. Removable and water-proof makes cleaning easy. ●【Good Ventilation&Fast Assembly】 Circular double-sleeved vent holes with adjustable nylon strap for air circulation by exhaust fan, ducting, carbon filter, or reflector. Better allows proper light, heat, and airflow. Quick tool-free installation. Reinforced by a sturdy metal frame to ensure security and stability, supports up to 140lb. Perfectly safeguard your plants to thrive even in winter

Sept 04, 2020 Hi, Thanks for checking out this diary from beginning to almost its end. The plants stood Under hard rain, strong twistering wind and took a beat from the Zizzling summer’s Sun but today they couldn't stand under the cold sharp metal blades of the pruners. We started to cut down plants. Their beginning was in a moist but no so wet paper towel, Transition into a 2” pot, grow medium was a mixuture of Re-used pro-mix with organic material And some gaia green bloom. They grew and were transferred to 5 gallon pots and were given nutri Authentik until week 2 of flowering. They grew and grew, some of them started to show signs of gender. males were taken from the pack To succumbed in the hands of the garbage can. The surviving female were fed Alaska morbloom Gaia green for flowering feeding. Unfortunately, some of the plants got pollinated so Today we started to chop the plants. 3 of them at first and 7 more to go. Thanks for checking out this diary. Keep it growing!!!!!

Could of flowered 2 more weeks but I had to make room, Growing 2 more

😇 😇 😇 Hi to all growers 😁 😁 😁 So let's start !! The first day of the girls' first week of life is a fact 💪 💪 💪 Some technical details: - Light cycle 20.5h on 3.5h off - Mars TSW first week set to 50% power - Ventilation RAM 4" 165m3 / h - Air humidifier from China ( doing job!! ) - 3x AutoPot + 3x AirDome See you soon, You Lovely Girls Growers 😇 😉 🙌

.

Still have these ladies in there Solo cups will most likely pot these girls this week Finally moved these ladies over to there pots looking good for now Oh yea no nuts just yet still going with PH bal water

Week 0 marks the start of the Wedding Cake grow. The seed germinated successfully and emerged cleanly from the medium. Early development looks healthy and balanced, with the seedling standing upright and showing no signs of stress or stretching. The cotyledons opened properly, and the first signs of true leaf development are beginning to appear. At this stage, the plant is focusing mainly on root establishment, laying the foundation for strong vegetative growth later on. ⸻ 💧 Watering • Very light watering only • Medium kept slightly moist, never saturated • No nutrients added yet 🌡️ Environment • Temperature: ~24–25 °C • Humidity: ~70–80% • Gentle airflow to support stem strength

I should’ve scrog’ed with my strongest two plants. Trying to pull some very heady buds so went all out on Advsnced Nutrients. Going to A/b test with budget synthetics next grow