Likes
22
Share
Due to prolonged bad weather, I decided to harvest them to avoid mold and other damage. There were three of us, and it took around 6 hours to trim about 80% of both plants. I ended up with a yield of 205 grams dry per plant. I'm more than satisfied with the plants. For my first grow, I couldn't be happier.
Likes
21
Share
This plant is really starting to bulk up now. I just drove to a few different places before j found the nutrients I ran out of. I found those and some additives along the way. I've heard really good things about both tasty terpenes and bud factor x from advanced nutrients. Now I get to try them. The plants just got their first feeding tonight so we will see how they respond to the new nutrients.
Likes
9
Share
@BLAZED
Follow
Week 1 (17-6 to 23-6) 17-6 Temps: 23.8 to 27.8 degrees Humidity: 46% to 74% Watering: #1: 73 ml. #2: 76 ml. 18-6 Temps: 24.4 to 28.1 degrees Humidity: 56% to 75% 19-6 Temps: 23.1 to 26.9 degrees Humidity: 53% to 69% 20-6 Temps: 23.4 to 27.7 degrees Humidity: 46% to 73% Watering: #1: 96 ml. #2: 93 ml. 21-6 Temps: 23.4 to 27.8 degrees Humidity: 46% to 82% 22-6 Temps: 24.2 to 28.2 degrees Humidity: 53% to 76% 23-6 Temps: 24.9 to 29.1 degrees Humidity: 45% to 76% Watering: #1: 108 ml. #2: 98 ml. They seem happy and growing quite fast!
Likes
43
Share
~Entry for the 'Best Rarest & Smallest Pot by Seedsman' contest~ Starring 🤩.... ~ Seedsman Zkittlez Auto ~ Zkittlez (Grape x Grape Apple) Auto x Auto Fruit (Auto Fruit Cheese x Auto Blueberry) Zkittlez Auto is one of the very sweetest-tasting auto strains available anywhere. It is a sativa-dominant (60%) strain that was bred from Zkittlez (Grape x Grape Apple) Auto crossed with a male Fruit Kush Auto, the latter a remarkable fruity strain bred from Fruit Cheese Auto and Blueberry Auto. Growers can expect to harvest some good yields of high-THC buds. Zkittlez Auto remains a fairly short plant, rarely exceeding 120 cm. in height wherever it is grown. This is a vigorous plant which is able to metabolize a high level of nutrients and she's a thirsty girl too! If growing indoors close to neighbors it is strongly advised to ensure good and effective carbon air-filtration in order to neutralize powerful odors. This strain's life-cycle is approximately 90 days from seed to harvest. The leaves on this plant are big and wide serving to convert every lumen available into Zkittlez goodness. Indoor growers should obtain between 400 - 500 gr/m2 while plants cultivated outdoors will produce slightly more at 500 - 600 gr/m2. Lateral branching is very good and it is recommended to use supports/ties to prevent snapping and keep buds close to the light source. This strain's scent is sweet and fruity with candy and berry notes. Its high-THC has been measured at between 21 - 24% with less than 1% CBD. The effect is well-balanced, cerebral and euphoric, and is very good for social situations as well as for relaxing in front of the TV either alone or with company. It also has the added effect of helping to relieve chronic pain, helping with nausea, insomnia and depression as well as stimulating the appetite.** **Credit to Seedsman.com ________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________ ~ The Setup ~ ~ Grown in a 2qt plastic popcorn pot filled with Mother Earth Grow 70/30 Coco/Perlite with Xtreme Gardening Mykos added. ~ Seed was germinated directly in the medium without any 'pre-soak' ~ Feeding will be by Dutch Pro Nutrients ~ 24hr light cycle while germinating ~ 20/4 light cycle after first leaves appear. ~ 4x8 Gorilla Tent ~ HLG 650R w/ 30w Supplemental UVA Bar controlled by a Trolmaster Hydro X controller set for a 15min Sunrise/Sunset simulation. (also a HLG Blackbird for additional side lighting if necessary) ~ Supplemental co2 controlled by an AutoPilot APC 8200 co2 controller ~ AC Infinity Cloudline T6 with Controller 67 using a Terrabloom 6x24" carbon filter ~ De-Humidifier and Humidifier when needed. ~ 14k BTU IdealAir portable A/C unit plumbed into tent for temperature control. ~ BlueLab testing instruments ~ Two Hurricane 18" oscillating fans ~ Two 6" Clip-on fans ~ Two 10" floor mounted fans ________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________ Weekly Update: 11/29- Here we go into the Zkittlez beginning stages of flowering... How exciting is this! Today when I checked her pot it was light so I went ahead and watered/fed her with 0.25g of well water with a base ppm of 100 that I allowed the excess to drain to waste. To the well water I added the following Dutch Pro nutrients: Grow 'A' & 'B' @ 10ml/g (I'll be switching to the "Bloom" next feed), Multi Total @ 7.6 ml/g, Take Root @ 3.8 ml/g, Silica Von Liebig’s Special @ 1.2 ml/g along with Earth Juice's Oily Can @ 5 ml/g to end up with a total 850ppm nutrient solution. After adding the nutrients and checking the EC, I ph'd the solution to 6.0 @ 74℉. 12/1- Today after doing some HST (twisting and bending branches), I went ahead and watered/fed her with 0.25g of well water with a base ppm of 100 that I allowed the excess to drain to waste. To the well water I added the following Dutch Pro nutrients: Bloom 'A' & 'B' @ 10ml/g each, Multi Total @ 7.6 ml/g, Silica Von Liebig’s Special @ 1.2 ml/g along with Earth Juice's Oily Can @ 5 ml/g to end up with a total 900ppm nutrient solution. After adding the nutrients and checking the EC, I ph'd the solution to 6.3 @ 73℉. 12/3- Today I let her dry out a bit more and will be watering/feeding her tomorrow after 'lights on'. Today all I did was take a quick video of her, check and rotate her pot and do a little HST on her main branches to keep her canopy as even as possible. 12/5- Well this little lady is getting big enough now to require daily watering as she's a very thirsty girl! I'm now watering until runoff daily with 0.25g of well water with a base ppm of 100 to which I added the following Dutch Pro nutrients: Bloom 'A' & 'B' @ 10ml/g each, Multi Total @ 7.6 ml/g, Silica Von Liebig’s Special @ 1.2 ml/g along with Earth Juice's Oily Can @ 5 ml/g to end up with a total 900ppm nutrient solution. After adding the nutrients and checking the EC (1.9 EC), I ph'd the solution to 6.3 @ 73℉. I also kept up on canopy maintenance by doing some lite bending of her main branches and ended with giving her pot 1/4 turn... See you next week! 😎❤️ ~ Thank you from the bottom of my heart for following my grows and for all the ❤️and support you give! 💚What you grow - Grow what you💚
Likes
Comments
Share
Week 3 is starting off busy. Day 14 I finally got some Bone Meal. So, I added 2 more inches on topsoil. 1st I added 1/4 cup of Bat Guano ea., 1/3 cup Bone Meal ea., 2tbsp of Potassium Nitrate and Calcium Nitrate ea. Lightly mixed into top 1" of coco. Then I added 1-1/2" of Canna coco mix (perlite10%, worm casting25%) over top of soil. Then, I topped it of with cedar chips spread over both surfaces. Day 15, 12noon I watered both girls with 1/2Lt of 6.4PH water only. 8pm I decided to LST a couple of umbrella leaves each. Hope it helps with light penetration. There's a bunch of new growth under those two leaves. How does it look so far.... Day 18: Lot of changes... Switched my lights around. The TS-1000 made heat where the Pro2 Epistar 400W didn't. Was just a hunch but as soon as I changed the temp of the room went down 8degrees. The TS-100 was directly under the exhaust fan. Cool... Took the fan out and modified the base to give some more floor room, then added a humidifier. Was going to install a DIY Co2 generator but my silicone must he too old and didn't dry. I'll clean off, fix and install tomorrow. Ladies look great, I removed the LST wires from the two umbrella leaves. 2 days were enough to get the under foliage to grow past them. Watered 1Lt "water only" PH 6.2 each plant. Added some Epson Salt to foliar spray and cleaned off the leaves on each plant.
Likes
12
Share
This girl was a fast finisher harvested on day 46 of flower, nearly 7 full weeks.
Likes
33
Share
good evening to all, brothers of the weed! Welcome back to the PEAKY gardens where it is grown for passion A good perfume all made in Holland comes out of the tent! The beautiful Punch are the ones that surround the whole tent, while the barneys cookies are the purple ones in the center of the tent! They seem to travel quite well and without irregularities ! We begin to see the first little heads of trichomes
Processing
Likes
18
Share
@CANNASIM
Follow
The flower tent is almost up and ready to go. Girls are responding well to the training and the new cob. Got a reverse osmosis filter running! Ec gets filtered and reads 0.0/0.01, its crazy, water gets normally out at .28 - .3 ec tap. I’m suplementig with calmag but woul like to run some tests with the new water.
Likes
4
Share
In der zweiten Blütewoche läuft alles ohne Probleme. Die Pflanzen zeigen weiterhin gesundes Wachstum und reagieren sehr gut auf die Bedingungen. Wir haben langsam begonnen, die Nährstoffzufuhr auf Blüte-Dünger umzustellen, um die Entwicklung optimal zu unterstützen. Gleichzeitig wurde die Lichtleistung schrittweise von 50 % auf 75 % erhöht, um den Pflanzen mehr Energie für die Blüte zu geben. Zudem wurde eine leichte Entlaubung durchgeführt, um die Luftzirkulation zu verbessern und den Fokus der Pflanze auf die Blütenbildung zu lenken. Alles in allem verläuft die zweite Woche der Blütephase sehr vielversprechend. Der Stretch ist fast nicht zu merken
Likes
18
Share
@BlumenBot
Follow
She's starting to show progression up top in the big pot, things are looking good 3/7 - more progress up top, hoping things dry up so I can feed
Likes
28
Share
Venga familia que ya viene la cosecha de estas Apple Fritter de ZamnesiaSeeds, que ganas que tenia ya de darles machetazo. No veas que pinta que tienen estas plantas. Las flores aparte de prietas se ven bien resinosas. a sido una genética con la que disfruté mucho cultivarla, es algo complicada cultivarla pero merece la pena si eres cultivador con experiencia no te será problema cosechar. Agrobeta: https://www.agrobeta.com/agrobetatiendaonline/36-abonos-canamo Mars hydro: Code discount: EL420 https://www.mars-hydro.com/ Hasta aquí es todo , espero que lo disfrutéis, buenos humos 💨💨.
Likes
14
Share
Another week and she is getting nice and fat
Likes
2
Share
Processing
Likes
7
Share
Week 3 is here and all is going well. The girls look good, but 2 are bushier and bigger than the other two. Still on straight water this week, and slowing adding more time to the water pump and keeping an eye on things. I did my first clipping this week, and since then, they have bunched up in the middle a bit. I am going to do some lst this week, and continue to keep them growing. I am also going to be adding nutes this coming week so hopefully they really start to flourish. On the time lapse, there seems to be less up and down with the leaves and now it seems more consistent. Hopefully this is a good sign on the watering schedule. Well see how it looks next week. Thanks for checking out my grow and see you all next week.