The Grow Awards 2026 🏆
Likes
Comments
Share
Firstly, the video of the popcorn bud from the mother plant, is showing what’s known as xylem sap from a process known as guttation. I never new that until this. Additionally, I am sorry to have missed out on so much documentation. I can talk forever about my plants so this will be short and to the point. Fast vigorous growth. Very resilient and hardy strain able to shrug of cold damp conditions, and freezing nights down to 32 Fahrenheit. The immune system seemed to be very strong. Never did I find any pathogens or even pests! A few but those little ghost spiders really helped out. During harvest, a thorough inspection resulting in surprisingly clean product! Finishing with large “airy” buds with fat bracts covered in trichomes. A rich musky cheese smell that surprisingly tastes of berries! I suppose I’m getting ahead of myself. But I was able to finish cure and smoke test the mom before harvesting the clone. Finally: this fast 50-60 day pheno will continue popping new bracts up to 90 days!!!! Or at least the mother in the tent did. Also, the dry weight is an approximation as I’m not finished with trim.
Likes
12
Share
The 34 street seed Cookies had Lot’s of LST and training this week! The girls did very well overall after being topped, and have recovered very nicely. I also finished up my drying my last harvest, so after a cleanup session, my big tent was ready to go again! This week was pretty easy, just watching the girls and adjusting the ties to keep the side branching going. I like to come in regularly and bend and twist the shoots between my fingers encouraging healthier stems. While I’m in there I’ll adjust the wire ties a bit to keep things even. After 2-3 days with the tie downs on, I’ll take them off and let the plant recover. With the environment dialled in at 79 degrees and 63% RH, it’s giving me a VPD of 1.0-1.1 , great for optimal growth. 💪 I think I am going to split the girls up, 4 (2 of eachin the one tent, 2 in my small tent, both with a Scrog in place. I’ll be transplanting this weekend, It won’t be long before these girls are ready for flower, October is a busy month for me so I may wait until the beginning of November to switch to flower light timing. Happy Gardening 🇨🇦❤️🌱😎💨
Processing
Likes
4
Share
Had a bit of a bad week with the girls in flower tent also had few issues with the ph @6.3 been to high causing a few problems had to defoliate all affected leaves hopefully they will bounce back
Likes
7
Share
One of them could be a keeper.
Processing
Likes
17
Share
Likes
13
Share
Created this diary for the video—- soon to be harvested ✌️🏻💚🌱🌿
Likes
20
Share
@Theia
Follow
Week 4 Flower Diary: The Generative Pivot & Structural Reinforcement ​Phase: Mid-Flower / "The Bulking Engine" Light Intensity: 950 µmol/m²/s Environment: 28°C / 52% RH (1.56 kPa VPD) ​1. Environmental Governance: Chasing the VPD ​The primary focus this week has been the pursuit of the "Perfect VPD". As the Invisible Sun intensity was pushed to 950 µmols, the atmospheric pressure was increased to match the metabolic demand. ​The 1.56 kPa Target: Raising the VPD at this stage is a form of Generative Steering. By increasing the "atmospheric pull," we maximize transpiration velocity, ensuring the raw materials from the Biotabs and Bactrex are pulled efficiently into the developing flower sites. ​Heating Optimization: Introduced a Vivosun W70 heater to replace the bar radiator. This provides a more distributed thermal lift, eliminating the risk of localized root zone damage on inner-facing pots while maintaining the 21.2°C root-floor temperature needed for microbial stability. ​2. Nutrient Strategy: Structural Reinforcement ​With the PK Tea currently on a 36-hour bubble, the substrate was buffered today to support the high light load. ​Silicium Flash Top-Dress: Applied a top-dress of Silicium Flash to provide a slow-release mineral foundation. The added Silicon is critical at 950 µmols; it reinforces cell walls and helps the plant regulate its stomatal aperture under high-intensity stress. ​Top-Watering Protocol: Established a weekly 500ml top-watering routine. This serves two clinical purposes: it washes the Silicium Flash into the rhizosphere and prevents the accumulation of salts in the top inch of the media—a common issue in bottom-fed Autopot systems. ​Microbial Maintenance: Integrated a monthly Bactrex recharge into this top-watering schedule to maintain the microbial density required to process organic inputs. ​3. Photobiological Log: Spectral Steering ​The 13/11 photoperiod continues to drive high efficiency via the "Sleep Hack". ​Emerson Effect Efficiency: Running the Deep Red (680nm) and Far-Red (730nm) channels mid-day allows both photosystems (PSII and PSI) to operate in a synergistic series. This prevents the metabolic "bottleneck" that occurs when plants are pushed near their saturation point of 1000 µmols. ​UV Status: While the Solacure Flower Power arrival was delayed, the room is being coaxed into high gear at 1.56 kPa in preparation. Once the bar is deployed, we will initiate the UVR8 process, where the plant perceives 280nm radiation and responds by increasing glandular trichome density as a biological defense.its some interesting science goes on when you blast 280nm photons at a plant. Proteins do mad stuff which I look forward to going on about once the damn light arrives.. ​4. Observations & Baseline ​New flower site photos taken today establish the Pre-UV baseline. Stacking is dense due to the high Phytochrome Photostationary State (PSS) maintained by tmynlighting rig and the plants are currently praying to the light gods, indicating they have fully acclimated to the current 950 µmol load. ​Weekly Tasking: In 36hr Check PK Tea oxygenation and apply at the end of the brew cycle. ​UV Arrival: Inspect Solacure bulbs and program the 15-minute "Acclimation Pulses" for the mid-day peak. ​VPD Check: Ensure RH doesn't climb above 55% during the dark transition. Thanks for looking. Grow well.🌿💚🇬🇧
Likes
2
Share
Here we goooo! Etsy seeds here we come. So far have been happy with them.
Likes
4
Share
Got some Nute burn my fault, caught it to late thought it was something else but do beleieve it was Nute burn. The high ppfd didn’t help either. They all bolted and are now flowering beautifully.
Likes
20
Share
30 días para las 16 Frutangie de @barbaseeds El día 26 se cambió a macetas de 7L En los próximos días ya nos vamos a flora 😁
Likes
18
Share
@Canadian
Follow
The plants seem to be growing very fast very strong. thank you for reading I will continue to update have a happy grow
Processing
Likes
7
Share
Likes
5
Share
@BombBuds
Follow
Die Farben werden immer spektakulärer es ist der Wahnsinn! Schädlingsbefall geht wieder zurück. Es wurden ein zweites Mal nemathoden ausgebracht und ab dieser Woche die umluftventilatoren stärker eingestellt.
Likes
13
Share
Day 149: last day of flowering Day 150 (01 October 2021): End! Now the Harvest begins
Processing
Likes
67
Share
@Ageddd
Follow
This week gaver the plant nutes each 2 irrigations (WATER/NUTRIENTS): using a high dose of Top Bloom, (maximum is 4 ml/l, using 4.5 ml/l at the moment,), Top Candy 2ml/l which adds carbohydrates, and Big One which gives the plant extra PK to help developing new hairs what means more budding sites.. Good Vibes !! - 20/08/2018 -
Likes
9
Share
@NanoLeaf
Follow
End of Week 8 (First week of flower) Increased the CO2 to 1200ppm and the ladies love it, already started stretching within the first 3 days of flower which shows that CO2 definitely boosts the grow cycle of cannabis. The main top-sites are popping up everywhere and everything looks evenly spread out. I defoliated again because the fan leaves are growing so fast and blocking bud sites. I also did one last lower canopy maintenance and removed small and stalky bud sites and stems below the trellis net to make sure I get maximum energy distribution to the main colas. I also added some GHF BioEnhancer to make sure the soil-microbes are happy and that the plants reach their maximum potential. Pest Report: EXTERMINATED! Thrips VS Ladybugs VS Neem Oil... I decided to fight fire with fire - I purchased Swirski-Mites from Koppert (They are beneficial insects that feed on the eggs and larvae of thrips and other unwanted pests). As for the adult thrips - I got very lucky and found about 10 Ladybugs in my garden and decided to introduce them into my grow room as they will feed on adult thrips and any other unwanted pests. Then to be extra sure I know that neem oil hinders the life cycle of pests like thrips causing them to stop colonising in my grow room. So I sprayed the ladies every day during the dark period to make sure there are no pests that I or the Ladybugs have missed. Mission accomplished. No more wilting and definitely no more thrips.
Likes
4
Share
@myketb
Follow
Week 1 Day 1 - Clones #1 and #2 are looking alright, not super strong and slight nutrient deficiency issues, but OK. Will just observe for now. - These clones are currently under a very mild CFL light (20 cm away and about 200 ppfd measured roughly by phone app - Tent Buddy.) - Clone #3 still need to be covered to maintain moisture. Yesterday I un-cupped the clone and it wilted a lot. This morning it looks better again after a night of rest under the plastic cup. - I've checked the run off and these clone's pH are so low, while TDS are so high (pH 5.7 and TDS 800pm). This evening, I flushed them with pH 6.5 water and brought the runoff to about pH 6.0 and 350 ppm) Week 1 Day 2 - Just foliage spray with mild CalMag this morning. Soil is still moist, so no watering. Week 1 Day 3 - Just minor watering today. Glad to see the clones are doing well as they are growing a bit everyday. Will transfer them to 3 gallon airpots with new soil mix soon. Week 1 Day 4 - Foliage spray with mild CalMag and Seaweed. Add 5ml of 250 ppm of balanced NPK nutrients AN B52 for each plant. Week 1 Day 5 - Foliage spray with mild CalMag and Seaweed. Transfer them to 3 gallon airpots. Week 1 Day 6 - Foliage spray with mild CalMag and Seaweed. Skip watering. The clones responded OK to the new airpots. Week 1 Day 7 - TBA