Likes
Comments
Share
@Naujas
Follow
this is my 6th week video, because for some reason the video didn't load :(
Likes
6
Share
Es wird langsam großartig🌱🌿 Die Trichome Entwickeln sich immer intensiver. Mein Bonsai im Living Soil. 🌿🌱🐛
Likes
Comments
Share
@Lynx_361
Follow
29.06.2025 Took a clone from each of my Plants on day one of flower. 30.06.2025 Did some LST..
Likes
1
Share
Happy this grow cycle is over. I will give more attention and focus next time I work with these
Likes
2
Share
Her stem is almost firm. I gave her 100ml of phd water before I repotted her and she looks like she is taking to the natural sunlight where she will remain for the meantime. For now I will wait until the pot is almost completely dry before I feed her!
Likes
2
Share
@ukojesita
Follow
Zdarec pěstiči, tak 8 týden za náma a konečně povyrostla kukuřice tak sem mohl nainstalovat pletivo proti srnám a nasypat granule na slimáky. Holky dostali 5l zálivku s naloží fishmixu ať se zase pěkně Zelenají. Zatím Čus.
Likes
14
Share
Great week put them on bloom food at around 40% strength, calmag at 25% strength and pk boost at 50% they had 1 feeding of formula at 1litre per plant the bud sights are exposed too light after the defoiliation at around day 29 plant was fed just water with the transition too bloom feed at Day 34 lights are at full spectrum so red light has been introduced at Day 29 . All plants are a nice size 1 still slacking but catching up hear we go full on flower mode :)oh PH in range 6.2-6.5 threw out the 5weeKs grow.
Likes
27
Share
3/18/2023 Week 5- Day 1 of Veg (Day 45 overall) First day of Week 5 Water change day. 36 Gallons in Mammoth Silica = .5Mil/Gal = 18Mil CalMag = .5Mil/Gal =18Mil Root Drip = 1Mil/Gal =36Mil FLoraMicro = 4.8Mil/Gal = 173Mil FLoraGro = 4.0Mil/Gal = 144Mil FLoraBLoom = 3.8Mil/Gal = 137Mil ORCA = .5Mil/Gal =18Mil PH = 5.85 PPM = 576 I adjusted the lights to final position for grow the lights are now 45" from the top of the plants. PPFD= 450 Tent Temp = 78.3 Water Temp = 73.2 3/19/2023 Week 5- Day 2 of Veg (Day 46 overall) Not much to report.. Did some defoliation and some topping. The humidifier was not cutting it by itself to keep the humidity around 60 so I added a bigger humidifier today on a second InkBird Controller. Lets see if it can help control the environment a little better and keep me from having to refill 3 times a day. 3/20/2023 Week 5- Day 3 of Veg (Day 47 overall) Just let them be today. We all took the day off and just grew!! 3/21/2023 Week 5- Day 4 of Veg (Day 48 overall) Nothing much to report they continue to do good.. I topped a little I fim'ed a little and I defoliated a little. Everything seems to be on point still... 3/22/2023 Week 5- Day 5 of Veg (Day 49 overall) Did a little bit of daily maintenance by adding 6mil of PH Up to bring my PH from 5.80 to 5.89, I refilled my humidifier. I topped a little, I FIMed one and I defoliated a little bit. 3/23/2022 Week 5- Day 6 of Veg (Day 50 overall) Regular maintenance conducted. The PH was down to 5.80 so I added 8mil of PH UP bringing the PH to 5.91. I topped where it was needed, I also defoliated some to allow light to hit lower nodes as well as allow a good air flow. 3/24/2023 Week 5- Day 7 of Veg (Day 51 overall) Last Day of the week time for measurements: #3 = 1 foot #2 = 11 and 1/2 Inches Tomorrow I will try to just add a SILICA top off to my Res.. I hope it doesn't call any gumming and me to drain and restart my Res.. this will be my first time topping off SILICA.
Likes
43
Share
Hey everyone . This week she has developed further :-). They look beautiful and are bursting at the seams 😅. The water tank was also completely reprocessed and replaced. Next week something will be cleaned and trimmed below. As usual, it smells very good 😍. I wish you all a lot of fun with the new update, stay healthy and let it grow 🙏🏻👍 You can buy This Strain at : www.Zamnesia.com ☝️🏼☝️🏼☝️🏼☝️🏼☝️🏼☝️🏼 Strain Gelato clone from mother (Zamnesia ) ☝️ Genetics: Wedding Cake x Gelato x Gelato 33 👍 Vega lamp: 2 x Todogrow LED CXB3590 COB 55 W 1 x Sanlight S2W 62 W 💡 Flower lamp : 2 x Todogrow LED CXB3590 COB 55 W 1 x Sanlight S2W 62 W 💡 ☝️ Grow Aero System : Growtool 0.8 ☝️ Fertilizer: Canna Aqua Vega A + B , Canna Aqua Flores A + B , Rizotonic, Cannazym, CANNA Boost, Pk 13/14, Canna Cal / Mag, Canna Ph - Grow, Canna Ph-Bloom ☝️🌱 Water: Osmosis water mixed with normal water (24 hours stale that the chlorine evaporates) to 0.2 EG. Add Cal / Mag to 0.4 Ec Ph with ph- to 5.5 - 5.8 💦 💧
Processing
Likes
2
Share
@Vet4weed
Follow
NOTE: Measuring light distance from top of net rather than top of plants for consistency. - Plant were developing nice broad leaves, but were refusing to grow any taller to push through the netting. So, I raised the light 3 inches and switched on both blue and red lights to allow them to stretch through, which did the trick! - Placed a lot of stress on the plants this week trimming and training them to grow throughout the ScrOG netting and removing lower branches that were not receiving as much light to allow the top leaves to get more nutrients. - NEGATIVE: switched off the grow lights to get natural color photos and forgot to turn them back on until several hours later! :-O My babies are too young to flower at this point. Hope they stay in vegetative state without any serious impact. Fingers crossed! - Been experimenting with clones from clippings. Last week didn't do to hot, but this time I got two nice long pieces and trimmed off the majority of leaves to give the roots a chance to develop without fighting over nutrients from the leaves. The trick this time was 1) sufficient size of clipping, 2) minimal leaves, 3) dipping the base in mycorrhizal fungi concentrate, and 3) placement near the humidifier to ensure leaves get sufficient moisture. So far so good. Check them out in the time lapse video.
Likes
25
Share
week intel: its time to harvest top buds! because my base nutrients and one of boosters was salt based, i'll do flushing this week to get some relieve to plants in the last days stresses : flushing Drought stress via watering only one time with flushing this week feeding: day 1 : i flushed them with Advanced Nutrients Flawless finish and adjusted ph day 3 : no more feeding from now on day 5 : no more feeding from now on guide of the week : i harvest in 2 parts : first i harvest top of the branches and will let the lower buds to ripe another week then ill harvest the second wave. its crucial to get uniformed buds in terms of quality that you let the lower buds to get some extra air and especially light! then the pop corn buds quality will reach the top buds. my dry and cure style is this: 3 days of hanging upside down to get water activity lower to around 0.6 in 50% humidity and 26 C temp (i know its a little high but we are in a hot summer right now and i cant get it lower even with air conditioner) and then after 3 days of drying i remove leaves and stalks, trim buds and move them to jar for the rest of their life :D . and in the first 4 days of curing i open the jar door and let hem get some fresh air in the jar for about 5 minutes and close the jar door again, after 4 days of curing like that buds are smokable but they will get better as they getting cured about 1 month. im happy as hell with this harvest :D.
Likes
30
Share
@Suemchen
Follow
Sanlight evo at 100% Day 64: flushed yesterday. One week now and then 72 hours of darkness. Looks and smells really good 🤙 Day 67: looking good 👍 a couple of days now, then darkness 🤙 Day 69: well, that's IT🤗 The Journey Has come to an end.... 😢 Today I turned off the lights, sprayed purolyt. She will get 48 hours of darkness and then cut and hung.. Get 15% Off Fast Buds with Code: FBSUMO https://2fast4buds.com/
Likes
4
Share
Plant is growing well. Transplanted them from a 1 gallon pot into a 3 gallon pot this week.
Likes
21
Share
@Dunk_Junk
Follow
16cm vertical growth this week, but she's bushed out a lot.
Likes
9
Share
@Changman
Follow
28/05/2024 - seeds were placed in a shot glass of water to for 18 hours 29/05/2024 - all seedlings except the Auto Power Plant were showing signs of a tap root and were transfered onto paper towels and placed inside a dark cool space. 30/05/2024 - of the 3 Power plant seedlings only one showed signs of a tap root so they were transfered to a paper towel on a plate and placed with the others. 02/06/2024 - one day behind but thankfully we got our seedlings into their grodan blocks and into their dome with a mars hydro heat mat set to 85F to speed up the process, we also have our 500w led set 24 inches away from the dome lid and will be updating 18 hours from now at 7am. 03/06/2024 - Seedlings are looking healthy and have been given some "Plagron Power roots" liquid nutrients. We shall keep our eyes closely on them.
Likes
26
Share
my first ever harvest went great. looking forward to plenty more.
Likes
6
Share
Likes
14
Share
Super cropped today soon few more weeks and in to flower
Likes
12
Share
@OGbros
Follow
I hung all the branches upside down in the closet. Thanks to the help of an air conditioner I keep the temperature at 23C and the humidity at 50%. When after a bending the branches will break (prematurely bend) then the drying will be complete and the tanning phase will begin. Initially I had problems with Ca and Mg deficiency, in fact the plant has grown less than the other, but I am still satisfied with the result. I usually don't weight buds when they are wet because it's just a waste of time. When they are dry I will update the diary with the precise weight. PS the same day I harvested my country rejected the decriminalization of cultivation of weed (referendum of popular origin). I want to say to my politicians: You will never stop me from doing what I love most. that said, see you soon for the upcoming updates😈