Likes
Comments
Share
@Autower
Follow
End off week 10 start off week 11 gave them a feed today think this will be the last feed of nutrients maybe a week to two left what’s everyone’s thoughts start flushing now or give another feed of nutrients then flush the next feed thanks for viewing happy growing :)
Likes
36
Share
@GYOweed
Follow
This is week 1 almost. Went 13/11 recently and did a major defol. Gonna give it some cheat codes and let it flower 3 weeks before next defol. Taking 2 clones each.
Likes
2
Share
Mid week last week I cut down the inferior PGC. I needed some and it looked done and wasn’t responding to water really. Anyway the buds looked good and get me kinda high. About 1oz smokable buds. This was in 2 gal so not very big. Curing will help. I pressed some into rosin at about day 6 of drying and turned out pretty well. The plant still alive is much better imo and buds should be fire , prob won’t press it
Likes
3
Share
She has become a beautiful little bush full of fat dense nuggets completely covered in fruity and sweet resin glands with some purple no tones in the buds. Love It!
Likes
21
Share
A-Day 81, B&C-Day 77 A- Is already 1/2 way through week 12, she almost all cloudy, with some amber tricomes now. I have started her “flush” just water for two feeds now. I’m going to keep watch, and see when is the right time, no rushing this go around . 🌱😎💨 B- is doing great, fattening up daily. A few more weeks at least, I hope she gets as big as her sister A 😍she got a full strength dose of nutrients twice this week and a water only feed in between. PPM was close to 1000 . C- is thickening up, I have her a slight defoliation and tied her down a bit to spread her branches. She is turning into a beast 🤩she also got 2 full dose feeds, and a water in between. Just keep spinning them around to get the even coverage.
Likes
4
Share
@UncleJono
Follow
Hey y'all! This is how the girls look at the end of flower -week 2! I tried my best to let them grow out but I did some light defol throughout the week, mainly on large leaves covering bud sites and to help with circulation on permanent marker. Most of the plants are now touching the screen and branches can be tucked/manipulated as needed. I began taking clones to help with canopy management and for genetic retention if they end up being great! So far 6 of 13 have been cloned. I have moved on from Jacks 321 and will now add MKP to the mix and adjust the formula accordingly (2-2-1.2-2). The plants were fed this flowering formula yesterday (Sunday) I am excited to see how these plants look at the end of this week. I was nervous going into this grow as this is pretty much my first grow of my adult life. I am still pretty nervous as I enter bloom and there are some things i would do differently (like this many plants in a small space...) Thank you for everybody who has engaged with my diary so far! Any tips and feedback welcome! See you guys next week!
Likes
16
Share
I just entered flowering stage, I switched to the bloom nutrients and I've stopped putting Rhino Skin like 2weeks ago and now am adding NIRVANA to help with the phosphorus I've also gave them a well needed defoliation try to focus all the energy in the pistils I've dropped my lights as well and my I've been keeping an eye for my temp. Don't want it to go above 80° The order am mixing my nutrients are: •hydroguard •Nirvana •CalMag •Bloom A •Bloom B • pH balance to 5.8 So far their pryin' up wards after I dropped the lights the seem to respond well.
Likes
5
Share
7ft tall doing high stress training to bend down. Tent is maxed. All under control day21 frosty oh my!
Likes
29
Share
This is my fav strain for now. I love the taste more than anything. Take a vape hit and exhale through the nose. Oh god, this is good. Despite the low light intensity, The BUDS ARE TIGHTER THAN THE FIST OF A FIGHTER.
Likes
32
Share
This week i will flush the plants, meaning i will only give them tapwater with the right ph and with around 450-500ppm. I have overwatered some of the plants under the LED so i will let them dry almost out before giving them water next time.. I have made alot of mistakes i think in this grow but they seem to be doing okay, i have a goal of atleast 50g from each plant, so we will see if thats realistic. Please comment if you have any advise for me or any feedback, thank you and peace out Day 29 the plants are just doing their thing and im waiting for them to dry out before i will give them water again Day 31 Giving the plants water, they are growing quick now though i have some small problems with some deffereinces caused by overwatering i think, because i started the seeds in so big a container it was hard not to. But for my expercince autoflowers dont like to be transplanted Will update doing the week
Processing
Likes
6
Share
SATURDAY 9/21: After having had my entire rig and all my cured produce stolen from me by my pardner in crime, I'm starting from scratch. (That f**king asshole!) Special thanks to the fabulous folks at Fastbuds for sending me some replacement beans!!! I mylar'ed up a closet and got a little light to get them started with. It's 3500k with some extra 660nm and draws about 200w from the wall. I am going old-school this time around..no pre-soak and no paper towels. I bought some soluble myco + tricho + all the good beneficial bacteria and mixed a little into a liter of distilled water and wetted rapid rooter plugs. I planted all three Stardawg beans in the rapid rooter plugs and put them in a little humidome under 9w of pink light. TUESDAY 9/24: All three emerged with no problems, but one is still wearing a "hat".. THURSDAY 9/26: All three had taproots sticking out a few inches, so I planted them in their 3 gallon pots and put little mini-domes over them. FRIDAY 9/27: I knew better than to try to start some seedlings with no humidifier, but the asshole stole mine, so I tried it anyway..I have several seedlings that probably aren't gonna make it, but so far all 3 x Stardawgs look fine. I wet them down and put some trays of water in the closet to try and bring up the RH. TUESDAY 10/1: Okay, so only one survived, and she's starting to grow.👍 My soil mix was too hot for them...rookie mistake... I finished working on my homemade frame and mounted 6 x 120w quantum boards to it, but one of my 3 x 240w drivers failed, so I gotta get a replacement sometime in the next few weeks. I still gotta get my ventilation squared away before I can even run them.😎 FRIDAY 10/4: She's my lone Fastbuds plants..got high hopes for her. She'll be surrounded by a bunch of Candy Cane hybrids.
Likes
48
Share
Hey fellow growers week 3 update of my Blue Dream grow. Not a lot of change since last week but growth! I switch both blurps to full power tonight to get these ladies rocking!! Well I did feed twice this week. Do remember that I'm not feeding the plants large amounts of water yet as I don't wanna drown my ladies. If I had to guess I would say maybe an 1/8 gal per plant. This is what the ladies were fed.... 12/31/2021 1ml micro 1ml gro 1/2ml bloom Ph 6.34 335 ppm Solution temp 73.2F 1/2/2022 1ml micro 1ml gro 1/2ml bloom Ph 6.34 335 Ppm Solution temp 73.2F Not sure I will do any lst training as none of these ladies are ready for clips yet. Grow is moving along smoothly at this point and I'm satisfied with where my ladies are at this stage of life. Well till next week thanks for stopping by. Best of luck and Happy Growing!!😎🌱💚💪💪
Likes
132
Share
@rhodes68
Follow
12/7 Week 4 still in strong veg no flowering signs. Reduced feed to 600ppm and upped amount to 0.5 gal to control runoff PPM/EC as it was just too high at 1400-1700 ppm and seeing some tiny white tips on new grow growth. Still on all Grow will add some bloom when I see some hairs multiplying. Increase nuets when runoff checks out ok Ended ponytailing and just doing some leaf tucking as always After some thought and a bit of reading I decided to do this as a root drench and fertilized flush to remove all salts from the pot. @0.5 gal ea 5.8PH CT Grow AB / Kangaroots /Fish Sh!t with @50% runoff at 900ppm (unadjusted 700ppm adjusted) in / and 985ppm out. See how things look in 24 hours. 12/11 Hooked up a reptile heater (60w) in a reflector directed at plant area on 24/7 to level out heat in lights off and give them more IR. They are really taking to it 12/12 Feed adjusted to 850 watching for white tips
Likes
13
Share
Unfortunately I couldn't harvest full plant, because half of it was stolen.
Likes
12
Share
Day 49 Since the last update, the plant has only shown very slow signs of recovery. There’s a bit of fresh growth appearing in the center, but overall it remains weak and far behind expectations. The leaves are still drooping, though not quite as badly as a week ago. The pale green color persists, with some areas still edging toward yellow. This shows the roots are still struggling and nutrient uptake is limited. The heavy topping has given the plant a wide, flat structure with many bud sites, but at the moment it can’t take advantage of that shape. The potential is there, but growth is stalled by the stress it’s under. Watering has been kept very cautious — smaller amounts with longer breaks to avoid waterlogging. The medium was allowed to dry out thoroughly before watering again this time. Even so, the plant seems to be putting most of its energy into recovery rather than active growth. Compared to the other plants, this one looks “stuck.” Because of that, my expectations have shifted — I now see it more as a learning project. The new strains I started alongside are doing much better and give me confidence for this run overall. For now, the focus is still the same: no extra stress, no experiments — just steady care, patience, and time
Likes
111
Share
@DreamIT
Follow
There is little to say yet. I recommend everyone to try this technique at least once. Maximize your harvest and increase your personal experience. If you want more serious proof of how mainlining works, take a look at the diaries of @Canamatoes, my teacher and mentor. More updates later, stay high🤘😁🦄
Likes
Comments
Share
@Rogel
Follow
Seguímos una nueva semana guiando hacia abajo y los lados, estoy creando una estructura en forma de cubo alrededor de la maceta para controlar el espacio y poder abrir aún más la planta, mi objetivo es que no supere el 1,5de altura pero sea un arbusto abierto. Es mi primer lst, cualquier ayuda es bienvenida. Estoy germina do otra semilla más y una doble oreoz para practicar en maceta de 25 litros poda apical y probar
Likes
34
Share
~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_ ❤️💡🌱😽💨 Week 5 of flower!! These girls are looking so much happier since getting some overdue calmag.. Buds have grown a ton since last week and I'm a huge fan of the spacing.. Both the Gypsy-Kush plants look identical.. we cleaned the base of new growth on all plants and removed a few more large fans from around the tops.. Light penetration couldn't be better... The Solux350 is kicking ass! Its incredible how something so small (and at 75%) can light up an entire 4x4 .. these plants are getting plenty of light and at 14".. not too much else to report its been a stellar week! Thanks for reading if you made it this far and happy harvests folks!! ⚡Hortibloom/Solux 350⚡ Specifications ⚙️: Diodes: Samsung LM281 Pro / Osram DR (1,440 total)💡 Driver: Inventronics 350 watt🔌 PPF: 1015 μmol/s ☢️ PPE: 2.9 µmol/j 〰️〰️ Lifespan: 50k+ hrs ⌛ Weight: 14.3lbs lbs (6.5kg) Veg Coverage: 5 x 5 ft 🌱 Flowering Coverage: 4 x 4 ft 🌼 -Uses an aluminum heatsink (no fan), quiet while operating 👂⬇️ -IP65 waterproof ratings, tolerant to high humidity grow environments 💦 -May be daisy-chained via RJ14 and managed from a single controller 💡~💡~💡~💡~💡 🌎 https://hortibloom.com/products/solux-350-led-grow-light ~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_