The Grow Awards 2026 🏆
Likes
Comments
Share
JOANNE'S CBD / ROYAL QUEEN SEEDS WEEK #22 OVERALL WEEK #10 FLOWER This lady started a little slow but definitely made up for the slow start she produced some fat buds and has a nice aroma to her!! Stay Growing!! Thank you for stopping by and taking a look it's much appreciated!! THANK YOU ROYAL QUEEN SEEDS!! ROYAL QUEEN SEEDS / JOANNE'S CBD
Likes
64
Share
@Prof_Weed
Follow
Heute wurden die Sämlinge eingepflanzt in den finalen Topf von Terra Aquatica, Cultimate, 15 Liter. Die Steinwoll Würfel gieße ich dann nach 3 Tagen mal,das System habe ich eingeschaltet. Die Sour Jealousy von Fast Buds ist ein Ticken größer wie die Orange Bud von Dutch-passion. Mal sehen wer das Rennen macht.. ppfd liegt bei 215, bei 20 Stunden Licht haben wir einen DLI von 15.48.
Likes
4
Share
@jahredi
Follow
Well... I had been growing these in a local biosolids medium. Should of researched that earlier 😭 While there are folks who grow in it, it’s not my jam. To many questions unanswered. So... I did an emergency, bare root transplant to an organic soil! I definitely ripped some of the more fragile lateral roots in the process, so I decided to go ahead and top and do a major pruning to cut down the amount of foliage they have to feed. I figure they’ll either make it or they will not. Time will tell...
Likes
12
Share
@MrRaid
Follow
Day 16 some low stress training for her 👍 I'm using tap water so not fully organic but food wise it's all organic
Processing
Likes
7
Share
@V3N0M
Follow
Well... week 3 these babies are really taking off.. I started all 4 on 1/8th dose of foxfarms.. all 4 taking about 20oz water each.
Likes
19
Share
@Jd1971
Follow
Ak49 3 weeks into flower and Bruce banner 2weeks into flower:)
Likes
15
Share
@Waveform
Follow
Not much to say about this real first grow week’s start. Everything looks ok, steady growth at 40% light. I had to restart the control app a few times, therefore the broken graphs. At night times, the control software tries to attain optimum humidity rather than optimum VPD. That’s why VPD is dropping when the lights are out. CO2 is back to baseline – really wonder what the reliable values are … I found I have to silence the blowers when a timelapse photo is being taken. The shaking you see at the beginning of the grow video should not appear, or to a much less degree, in the future. Day 13 (July 30th) shows good, steady growth. Leaves are a bit spotty, although less then the processed images show. Something to be worried about? I would not currently … All are developing their 3rd nodes now. The controlling Raspberry Pi crashed last night when I tried to access it remotely … ;( – looks like the Connect software is in need of an update. The leaf temperature sensor is now really aimed at lady-to-be nr. 1’s leaves. Nothing to change that I see. I won’t cut the top yet, just watered the outer circle of the big pots slightly to encourage root growth. Day 14: Nice growth. First plant is now at 11 cm, and at 12 cm on day 15. Nothing special to report so far, except for I had to move the internal camera a bit upwards to keep little lady #1 in focus. Day 16 and last day of this week (Aug 2nd): The young ladies are now at about 14 cm tall. Growth looks very compact though. I think the two inside girls will lose their heads next week; I’d still prefer to have one or two more nodes available. Pictures of this day are taken at the end of the plants’ day. Notice their leaves are pointing upwards, which should be a sign that they want more light. I turned the lights up by another 20% for a total of 60 W now. Weather was pretty hot the last days so it wasn’t possible to stay in optimum VPD range but as long as growth is this satisfying I don’t mind. I will water them slightly at their next day start. Outside plant’s soil humidity might still be at around 58% officially, but drying starts at around 40% with this measurement and the sensors are placed quite closely to the stems so outer soil is dryer. I am preparing the plant water with some additions and a frequency imprint suing some Solfeggio and Schumann frequencies.
Likes
2
Share
A good week with a lot of growth. I took these pictures today right after feedings. This was the second feeding of this same mix. As of today, they are 18 days old today. Looking quite nice. As you can see in the pictures they are just starting to show. I give a really good look at them in the video. And as you can see they are just beginning to show some white hairs, so I think next week we will be in flower. So far so good. hopefully, it continues. Happy grow everyone!
Likes
49
Share
Deep burnt brown pistils Little pink purple startin to kick in .. Nugs lookin real do si do and super creamy tasty aroma comin off her can’t wait till flush 🚿
Likes
11
Share
@NONSENSE
Follow
Very nice genetic. I'll do same Jack H from Fastbuds for sure again. Plant was very strong and ready for training. I still did not smoked it, will replay later about the taste and power.
Processing
Likes
20
Share
They are growing really well. Added a humidifier at day 9. I have a seedling in rockwool still it is growing super slow. Root still not sticking out even tho it have been in the cube for 7 days now. Im feeding very light 40% strenght. I see how light green the leafs are and thats what im going for. I will up the strenght abit the following days. I been watering almost everyday. Started the first week with 0.1 liter now upped it to 0.2 liters per plant. I had the HPS light just a bit too close to the plants so i have some very slight curling on a few of the leafs. No problem i just move the light up 5cm. So far im very pleased with the growth rate
Likes
18
Share
~ FASTBUDS TESTER #2204 ~ Well friends, here we go on another 'canna-venture' together! The grow room has had a complete remodel and some upgrades done to it including brand spanking new 4x8 and 4x4 tents and a Trolmaster Hydro X controller along with a new Control Panel. This tester strain is one of six tester strains that FastBuds has graciously provided me with and I'm looking forward to seeing what this girl has to offer when she's grown to her full potential! One drawback of 'testers' is I have little to no information on it other than its number and that it's an autoflower... 🤪 But, it's ALWAYS a blast growing them for me because not knowing a lot allows me to just concentrate on the essentials: Light, Environment, Water, Nutrients and possibly a bit of LST... not complicated, just basics like keeping a constant temperature and RH in the tent at a level that gives a good VPD, watering when almost dry and maintaining proper light levels according to their stage of growth. ____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________ ~THE SETUP~ ~Initially seeds were lightly scuffed, then soaked for 3 hours in 78℉ distilled water after which they were transferred to moist paper towels laid out in a Jiffy Pellet plastic starter tray with lid. Underneath the tray was placed a Vivosun Heat Mat with Controller that was set to 78℉ where they stayed until their tap roots emerged. ~Planted into Jiffy Peat Pellets that were hydrated with distilled water warmed to 78℉ with a 7.0 ph. ~Once roots emerge from the Jiffy Pellet they're transferred to their fabric pots. ~Grown 100% organic in a 4g Gronest fabric pot and a 3g fabric pot by Wraxly filled with Mother Earth 70/30 Coco/Perlite medium and initially amended with Dr. Earth 4-4-4 / Earthworm Castings / Dr. Earth Flower Girl 3-9-4 and Coast of Maine Stonington Blend Organic Plant Food 5-2-4. ~19/5 light cycle for the entire run with supplemental UVA added during flower. Lights are controlled by a Trolmaster Hydro X controller set for a 15min Sunrise/Sunset simulation. ~Top dressing every 3-4 weeks with slow release dry amendments and Earthworm castings. ~Straight water ph'd @ 6.2-6.8 when needed and bi-weekly Compost Tea's. ____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________ Weekly Updates: 12/1- I soaked both seeds for 3 hours in 78℉ distilled water after which they were transferred to moist paper towels laid out in a Jiffy Pellet plastic starter tray with lid. Underneath the tray was placed a Vivosun Heat Mat with Controller that was set to 78℉ where they stayed until their tap roots emerged roughly 24 hours later. 12/3- Today their tap roots were about 1/2 to 3/4" so at 11 am I transferred them into Jiffy Peat Pellets that were hydrated with distilled water warmed to 78℉ with a 7.0 ph using a tine off of a plastic fork as a 'mini trowel' to make a hole in the pellet and to gently cover the tap root, leaving only the seed head slightly exposed. This method accomplishes most of the initial work the seed has to do by eliminating having to orientate itself, push it's root down and head up. By 10pm the #1 seed had her cotyledon leaves opened and the #2 isn't far behind! 12/5- Well this is the full Day One for the #2 FBT #2204 and the second day for her sister! I'll keep them in the covered/heated Jiffy tray until I see their roots beginning to emerge from the peat pellet, then I'll transfer them gently into their respective fabric pots. The #1 will be going into the 4g Gronest pot from FastBuds and the #2 will reside in a 3g pot by Wraxly, which I'm trying out for the first time. 12/7- Yesterday I checked the #1 tester and she had roots starting to emerge from her pellet so I transferred her into her 4g Gronest pot. After making a hole in the medium for the peat pellet, I coated the entire surface with Xtreme Gardening Mycos then placed the pellet in the hole and planted her in. Lastly, I watered her in with about 4oz of de-chlorinated water with 3ml/g of FishShit added which was then ph'd to 6.4 @ 75℉ after which I placed a humidome over her for 24hrs to ensure that the humidity stays constant. The #2 tester is doing great and I'm confident that she should be ready to transfer into her fabric pot in the next couple of days! 😎💚 Thank you for checking out my passion in life! Please visit as often as you wish and I hope you enjoy this journey as much as I know I will! Grow Strong! 💪😎🤙
Processing
Likes
17
Share
This week I have seen very big growth out of all my plants it’s very exciting I’m gonna grow some autos next 🤙 for 3/20 national auto flower day. Do y’all think these will be done by 4/20 probably not and hats okay don’t ever rush anything :)
Likes
10
Share
Week 14, looking good. Just trying to keep an even canopy, and upping the feed as and when needed 🙌🏽💚
Likes
13
Share
ZTRAWBERRIEZ and Gorilla Punch don't need much longer. In this week the pistols all were coloured in orange. The buds did their bulk perfectly. We got temps +30 degrees so in the greenhouse there Are +40 degrees. The following week should get cold and rainy. ZKITTELZ needs a little more time but also is doing good.
Likes
Comments
Share
Lemon Cherry Cookies Auto - Best autoflowering strain 2025
Likes
67
Share
@Dunk_Junk
Follow
Week 10 - - - - - OMG she got frosty!!!!!!!!!!!!! She smells so beautiful! So Citrus! So Lime!! 😂 😍 This week I have added a couple of grams of 20-20-20 fertiliser to her water. For a few weeks now I've been loosing a lot of lower leaves. They turn yellow and fall off. I did send the growcaps rep a pm a couple of weeks ago now asking about the active length of growcaps but it's gone unanswered..... so I took things into my own hands. She seemed to like the boost in nutrients with the amount of frost on her and not dropping any leaves. I do think the growcaps worked very very well at the start but I think they need to make them last a few weeks longer.