Screenshot😩🔝

Really kicking myself in the ass for not taking cuts of this. Probably some of the better outdoor/greenhouse flower i have produced.

I'm afraid the Raspberry Pi's time got reset somehow resulting in the timelapse being taken mostly at night rather than during the day, which means there aren't a lot of usable photo's :(.

We picked up the cuttings for the GanjOS Lab from High4Life on December 30th and put them in our propagator for around 3 days for acclimatization.

A bad day for me as soon as I took pictures one of my Ballast went out Going to substitute with 600 W spider farmer L. E. D. Until my new balance arrives in 2 weeks.Did low stress training to my clones.

Germinating 3 Purple Kush Feminised seeds. filtered water in glass, also add 3/5 drops of hydrogen peroxide, stir water well before adding the seeds, and stir again after adding seeds to water. I will leave it for 24 hours The seed coat softens by soaking your seeds in a hydrogen peroxide solution, allowing the seeds to absorb more oxygen. This results in increased germination speed Hopefully all 3 seeds will germinate by tomorrow? Seeds popped today:-)transferred 3 Purple Kush seeds in to small pots 10/09/23 3 Purple Kush seeds, 1 seed in each small pot. Each Pot is Half filled with lite mix compost and Half filled with Vermiculite , watered planting medium before sowing seeds 2cm deep in planting medium. The seed will push through the vermiculite easley with very little effort, in effect increasing higher successful germination rate, the compost will offer the first tap root an immediate lite nutrient supply. Placed 3 pots on top of a Propagation heating mat for correct germination temperature, position in a shaded place, and keep out of direct sunlight. This may seem like a lot of effort? and it is, but it will be highly beneficial by increasing a higher germination rate and higher amount of seeds will germinate from using this method :-) especially if your seeds were expensive. 11/09/23 no sprouts above the vermiculite yet, i will check it again tomorrow. Today 2 Purple Kush Germinate and rise above the vermiculite 3 days after sowing. Purple Kush is going ok, it could be growing faster, unfortunately i can't upload new photos because there is a problem in the GD system, they are doing there best to fix this problem as soon as possible. GMO Cookies where started 16/09/23 filtered water in glass, also add 3/5 drops of hydrogen peroxide, stir water well before adding the seeds, and stir again after adding seeds to water. 3 seeds sprouted, but only 2 survived, it become to hot and one GMO Cookie sprout died. I have now started another strain (Party Monster) 19/09/23 filtered water in glass, also add 3/5 drops of hydrogen peroxide, stir water well before adding the seeds, and stir again after adding seeds to water. I will leave it for 24 hours, 5 seeds of Party Monster have sprouted and are under the same 100W LED grow light. GMO Cookies have all come up above the vermiculite and are now positioned under a 100W LED, there is a small clip on fan blowing and circulating the air. This is my second attempt to grow GMO Cookies from 3 feminised seeds, i messed up on the first 3 seeds, i put them under a 250 Watt LED and it fried them, my folt. Growing from germinating seeds is a very delicate situation, your environment temperature needs good control. 2 Party Monster seedlings are looking good, coming along well under the 100W LED light. 3 GMO Cookies are looking good also under the 100W LED light. Plus i have now started soaking in glass of water 03/10/23, 5 Strawberry Yields fem seeds aka Strawberry Fields. filtered water in glass, also add 3/5 drops of hydrogen peroxide, stir water well before adding the seeds, and stir again after adding seeds to water. I will leave it for 24 hours. The seed coat softens by soaking your seeds in a hydrogen peroxide solution, allowing the seeds to absorb more oxygen. This results in increased germination speed Hopefully all 5 seeds will germinate by tomorrow? The 3 GMO Cookies fem seedlings are coming along well, keeping them under the hood of a propagator, i have many mixed seedlings under the same hood, to keep seedlings protected from this relentless Spanish heat. 5 Strawberry Yields fem seeds have all sprouted and are above vermiculite, keeping them under the hood of a propagator, i have many mixed seedlings under the same hood, to keep seedlings protected from this relentless Spanish heat. Also positioned also under the 100W LED light, indoor temp 29 degrees humidity 65%, still to hot for seedlings to be directly under lights due to high temp in the room. 3 Strawberry Yields sprouts are doing well, gave 2 seedlings away, no space for all 5 plants, coming along well under the 100W LED light. 27 degrees humidity 55% good growing conditions Super Lemon Haze I began soaking 13 feminised seeds SLH since 27/10, after 24 hours soaking 11 seeds opened in filtered water in glass, also added 3/5 drops of hydrogen peroxide, stir water well before adding the seeds, and stir again after adding seeds to water. The seed coat softens by soaking your seeds in a hydrogen peroxide solution, allowing the seeds to absorb more oxygen. This results in increased germination speed! 1 Super Lemon Haze fem seed planted in a 2 ltr pot 28/10, this is the only plant i will keep for flowering. The Pot is Half filled with lite mix compost, and the rest of the pot is half filled to the top with Vermiculite , watered planting medium thoroughly soaking it before sowing seeds 2cm deep in vermiculite. The seed will push through the vermiculite easley with very little effort, in effect encouraging a higher successful germination rate, the compost will offer the first tap root an immediate lite nutrient supply. And i planted the 11 remaining popped SLH seeds in the brown round pot, this is just to see how many will rise above the vermiculite from the 13 SLH fems seeds soaked on 27/10. I will give these away to a friend. Both pots have been placed on a propagating heating mat for consistent and ideal germination temperature until all seeds have risen above the vermiculite. Once my 1 fem seed has germinated! i will cover the pot with a transparen plastic bag and place the pot 20cm below a 100W LED light. Super Lemon Haze feminised seeds Seeds sourced from Satdica Bulk Seeds Soaked seeds 27/10 planted up on 28/10, 12 out of 13 seeds have transformed in to 12 healthy little seedlings. 11 seedlings will be given away to a friend, and i will keep the one seedling you see already planted up in a black 2 ltr size pot. Now positioned under my 100W LED light, distance 15cm above seedlings. Light cycle 24 hours. Keeping them covered with propagating hood for a few days longer to allow seedlings to become better established before removing the hood. The vents on hood are fully open to allow seedling to slowly become accustomed to the outside vege room space. Gelato Cookies 3 Feminised seeds Satdica Bulk Seeds Popped 3 Gelato Cookies Feminised seeds today 06/11 filtered water or bottled water in a glass, also add 3/5 drops of hydrogen peroxide, stir water well before adding the seeds, and stir again after adding seeds to water. I will leave it for 24 hours The seed coat softens by soaking your seeds in a hydrogen peroxide solution, allowing the seeds to absorb more oxygen. After placing on propagating heating mat for 24 hours. This resulted in increased germination speed! and today i can see little white taproot tails protruding out from the seed husk 👌 3 Gelato Cookies seeds, 1 seed in each small pot. Each Pot is Half filled with lite mix compost and Half filled with Vermiculite , watered planting medium before sowing seeds 2cm deep in planting medium. Spoon your seeds into it's planting medium, do not touch with fingers, spoon it in with half spoon of water and a seed, place the seed in the center 2cm deep in the planting medium, water it in again very lightly to help the seed settle into a comfortable position before leaving it to rest covered on your heating mat. The seed will push through the vermiculite easley with very little effort, in effect increasing higher successful germination rate, the compost will offer the first tap root an immediate lite nutrient supply. Watered and fed them in with Plagron Terra Grow 5ml to a ltr of water, i may have added too much, perhaps 2/3ml to a ltr of water would have been enough? placed 3 pots on top of a Propagation heating mat for correct germination temperature, position in a shaded place, and keep out of direct sunlight. This may seem like a lot of effort? and it is, but it will be highly beneficial by increasing a higher germination rate and higher amount of seeds will germinate from using this method :) especially if your seeds were expensive. 3 Gelato Cookies have come through the vermiculite, 09/11 and now they are positioned under my 100W LED grow light. I didn't expect all 3 seeds to pop, because 1 seed looked like perhaps not viable, because i only keep the bad looking seeds for myself and keep the best seeds for customers. I am keeping them covered with transparent plastic bags for a few days to protect them in case it's to hot in the 24/7 grow room which is 24 degrees, this is probably an ok temp for them? but i'd rather not run the risk. Romulan Feminised seeds Germinating 3 Romulan Feminised seeds 26/11 filtered water in glass, also add 3/5 drops of hydrogen peroxide, stir water well before adding the seeds, and stir again after adding seeds to water. I will leave it for 24 hours The seed coat softens by soaking your seeds in a hydrogen peroxide solution, allowing the seeds to absorb more oxygen. This results in increased germination speed Hopefully all 3 seeds will germinate by tomorrow? 27/11

Well am trying to veg as long as possible it it’s nearley time to flip to flower 🌺 dunno if am Goni manage tae get another run 🏃‍♀️ on the go am trying ma best to sort something ye can’t trust anyone these days but fuk it it’s middle of October so a will flip in next week or two then a can relax n let them do there thing looking forward to the stretch faze that’s ma s favourite 🤩 bit lol it yeah a really cannot Sao it goes this but I harvested to early a never dried properly n a rushed and made silly mistakes that impacted massively as much a was happy a shoukd hav waited longer anyway guys wish me luck also told ye feds on case chedderbob112 dizne tell lies real deal @chedderbob112

All looking good with the banner. The frost is coming and the smell is developing. She has stacked well and I think she might give the largest colas of the smaller plants. Hoping this makes up for the fact that she hardly stretched. The small plants are being raised so I can keep them close to the light. The amnesia is trying to bully them all. Been defoliating continuously with this lady. Hoping that can stop now and I can just watch her ripen up!

So letzte Woche wurden die Ladys nur noch mit Wasser gegossen, diese Woche auch und dann geht’s zum trockenen 🥦✌️

Feliz con los resultados de la hidroponia cultivar plantas autoflorecientes en hidro da resultados increibles en comparacion a cultivar en sustraro

Feeling kind of anxious. I mean for starting a new grow. This ones were an ok first coco grow. I think the next one gonna be better. Tho the plants are great. Totally frosted, lots of popcorn but some good buds too. Smell is getting intense. I’ll start flushing this week and next one we chopp em.

Muy caros los productos, efectivos pero me sigen pareciendo caros, probaré nuevas gamas! Un saludo

This grow is going to be testing my coco based auto watering setup. The plants will eventually be going into 2.5 gallon airpots which I cut to be very tall and narrow which I hope will give great performance for this grow style. Nutrient solution will be pumped from a 5 gallon bucket to halo-style drip emitters 6 times a day for 5-10 second intervals. I am going to try to use inline flow control knobs to dial in the watering and allow for slight runoff every fertigation. For lighting I am using my HLG 100 watt lights, one per plant. I am a big fan of these quantum boards, they have given great performance in the past! Thanks for reading! 🌱👍 May 13 day 1: the Blackberry breached after germinating in a rapid rooter for 2 days. I am impressed with how quickly this seed popped! It had no issues with stuck seed casings, which I find is the main downside of germinating in rapid rooters. I am excited about this one! May 16 day 3: Auto watering drip emitters are set up, and I am testing them to dial in the amount of runoff it produces. I also planted the seedlings/rapid rooters into 1 litre grow bags and began feeding nutrients. They are still under the humidity dome for now for the time being and seem to be doing well. Day 4: seedlings doing well, they are staying under the dome untill they grow their next set of leaves, then I will take them out and run a humidifier.

MARSHYDRO LED DOING AN AWESOME JOB! DON'T MISS THE VIDEO!! SHORT!! THANKS 😎 GOPRO HERO SESSION WITH WGS FEIYU GIMBAL STABILIZER

First week after light switch is done. Plants are growing very nice. Tips for improvement are allways welcome! :)

Esta semana entramos en pre flora Farmers, a ver cómo tira con el té compost que pusimos... aproximadamente 5% de melaza pescado hidrolizado ácido fulvico, mycorrizas, azos bacter and micro organismos para un buen rendimiento un saludo compañeros!

1000ppfd

It was a interesting grow I had Spider mites in flowering. I treated with lady bugs. Seemed to do the trick. All my other autos got hplvd. This likely had it too at end with close proximity to them. She made it. Great looking plant, and smell. Thank you Mars Hydro. DO NOT BUY AMS. The owner is a convicted criminal, and he stole 550 dollars from me. It's not worth it. Thank you grow diaries community for the 👇likes👇, follows, comments, and subscriptions on my YouTube channel👇. ❄️🌱🍻 Happy Growing 🌱🌱🌱 https://youtube.com/channelUCAHN7YRZWLPCARHHMIQ7X4G

Christmas week, family over so no pictures but she’s still looking good