Processing
Likes
Comments
Share
Likes
36
Share
@SAC87
Follow
Day 14 flower Hey Growers So day 14 of flower, I decided to defoliate as the tent was getting so overgrown. They are drying out quickly and the media is dense with roots. They are going to require daily watering very shortly. They seem quite happy and doing well. You can see in one of the pictures, the leaf edge is raised, which idk exactly what that is. I’ve decreased the light to 70% until I know how they’ll react. Other than that just put in the trellis to support the tops. Happy Growing 🌱
Likes
27
Share
Last week i found some seeds grown in the bids and i released them. Was a bit of work but i think its worth it. I start to give just water for both kush, the haze will get 2 weeks nutrients. Hope that come more seeds. Have a nice week✌️
Likes
42
Share
Flowering day 18 since time change to 12 / 12 h Hey guys :-) The ladies have recovered well from the cold thanks to the heating mat and have developed beautifully 👍. During the check today I saw that despite spraying neem oil 3 times, there are still a few trips :-( . Now I've ordered nematodes again specifically against trips for leaf and substrate. I will use that immediately 👍. Watering was done twice this week, each time with 1.3 l (nutrients see table above) Next week I will remove the lowermost shoots so that the energy goes into the upper buds. Fresh osmosis water was mixed with tap water and put into the 100 liter tank so that the water can stand and I'll have enough next week :-) Otherwise everything was cleaned. Have fun and stay healthy 💚🙏🏻 👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼 You can buy this Nutrients at : https://greenbuzzliquids.com/en/shop/ With the discount code: Made_in_Germany you get a discount of 15% on all products from an order value of 100 euros. 👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼 You can buy this strain at : Clearwater Seeds Water 💧 💧💧 Osmosis water mixed with normal water (24 hours stale that the chlorine evaporates) to 0.2 EC. Add Cal / Mag to 0.4 Ec Ph with Organic Ph - to 5.8 - 6.5 MadeInGermany
Likes
56
Share
@Aedaone
Follow
The temperatures, humidity, height, and watering volume(if measured) in grow conditions are all averaged for the week. The pH is soil pH. Any watering done by me is well water which is 7.6 pH and 50° F. Coop Poop, Feather Meal, and Soluble Kelp are ml/gallon of soil top dressed. Everything else listed in nutrients is ml/gallon of water fed to plants without checking the solution Ph. Day 1 we had a high temperature of 88°F with clear sunny skies. I watered about 5 gallons per pot with well water. I added 75 ml Coop Poop, 100 ml feather meal and 50ml soluble kelp top dressed. Day 2 we had a high temperature of 74°F with sunny skies. I watered about 5 gallons. These girls were still a little hungry Day 3 we had a high temperature of 79°F with partly cloudy skies. Today I fed 5 gallons liquid feed mixture with 40ml of Agrothrive Fruit and Flower 3-5-5 and 80ml of Biogreaux Molasses 1 - .5 - 5. Day 4 we had a high temperature of 85°F with sunny skies. I watered about 5 gallons of well water per pot. Day 5 I didn't get photos but it was a normal day. Lots of sunshine highs about 80°F. I watered about 5 gallons Day 6 we had a high temperature of 79°F. Skies were sunny and it's really feeling like fall. I watered the #3 about 5 gallons. The number two got 5 gallons of feed. The feed was 100 ml of AgroThrive Fruit and Flower 3-5-5 and 40ml of Biogreaux Black Strap Molasses. I fed the #1 a 5 gallon nutrient solution that contained 120ml of AgroThrive General Purpose 3-3-2. Day 7 we had a high temperature of 73°. It was sunny, cool, and a dry 35% humidity. The girls are super happy. I watered about 5 gallons today. This week was a success. The girls have reached their final height. The #3 is at exactly 10'. Thats measured from the top of the pot to the top of the plant. I continue to treat weekly for powdery mildew. Finally the weather is cooperating. I let the canopy get a little out of hand but she's still producing. Only the number 2 smells like white cake. The others have a lemony smell to them.
Likes
31
Share
Heeey! 👋 It's week two and everything went quite well I believe! The girls are growing and they look healthy! 💪 During the first days this week and while I was checking them I started to think how I could improve (and fix) what I did in my previous grow, specifically the veg. phase. I wasn't the brightest person in my previous grow because I left the lights at their maximum power during this phase to increase the overall heat of the tent (it was a winter where I live) and while that idea made total sense to me at that time later I found out that was a not the best idea at all 😰. By doing what I did it meant my plants were receiving way more energy they could handle and that meant the plants didn't grow as much as they could 😱😭 So, how could I improve that this time? The best way was to get a PAR meter so I could measure how much light my babies are receiving but those are expensive so the best option after was using the lux meter (or rather the RGB brightness sensor) that's available in my phone (most phones come with one) and by doing that I get a rough idea how much food my babies were receiving (in lux tho, not the best method but it helps to get an idea) 👌 The first days Pistachio and Matcha were getting about 8000 lux and as the week progressed I ended near 18000. Some websites said that amount was acceptable for young plants (they do not talk about the quality of the light tho). For the next week I plan to reach 24000 lux and stay around that 😊 I also think this week I'll move the girls to a slightly bigger pot and with each transplant I'll keep using mycorhizes (Mico Root are mycorhizes) to help the root development. Anyway, that's all for now. Thanks for reading and I hope you'll all enjoy the photos and timelapses I took (the 2nd one looks cool!) Cheers! 😃
Likes
12
Share
We had approx 4 inches (10 cm) of rain this past week which is a lot for this area. Soil has a lot of moisture but not too wet. Excellent growth in veg stretching a fair bit and starting to show signs of early flower development. Preflowers with resin: smells like sweet floral and bubblegum. Need some sun and heat.
Likes
16
Share
@valiotoro
Follow
Hello everyone 😎 Week 10 of flower for the strawberry banana auto from Fast Buds 🍓🍌 Only one plant left ! She grew fast with beautiful color,for the nutrient 4ml/L terra bloom & 1ml/L power buds next week i will introduce Green sensation at very low doses from Plagron ✔️ Now only plain water💧 Amazing smell 🤤super fruity 🍓🍌 The buds are super sticky ✂️ Mars hydro SP-6500 100% Have a nice day 😋
Likes
3
Share
This is my first grow at my place… previously recorded at my PIC @rasta007 s place. I started off with a small ac infinity tent hoping I could get away with it but I had purchase another tent at week 6 because she was kissing the light and I had no more room to extend it . She’s on Greenleaf nutrients prepared by my love @Rasta007
Likes
1
Share
@Oldwied
Follow
The third week is over the stress of repotting is well absorbed and growth is in full swing. Light Power: 50% Day 16 Photoshooting
Processing
Likes
14
Share
Today 7/30/19, day 57 and the start of week 9. I'm still continuing to alternate between days with my pesticide treatment (especially after finding that bug living on one of hulkberries fan leaf) and thrive alive green daily foliage spray as a prophylactic solution against any possible pests or mold going into these last few dog days of veg. I will flush them with distilled ph'd water for two days this weekend in preparation for flower. Then I'll start them on some "flower fuel" bloom booster on top of my secret for success flower recipe at 1/4 of the recommended strength. Outside of that still no adverse issue to report for the end of the 8th week. After my last trim, they both have responded very nicely, I was kind of worried about fat banana stalled growth. But one thing I noticed when I topped her at the 6th node, yes the main stem stopped growing but it developed many bud sites up and down every stem. Whereas hulkberry was topped at the 8th node, she has mainly focused on developing long stems and only 2 or 3 bud sites along her stems. Even though hulkberry in structure, is much bigger than fat banana and has a way bigger root system. Fat banana is bushier and has developed way more bud sites than hulkberry. I can't tell which strain will yield the most at this point only time will tell! Also, a big shout out to "J"@RQS, thank you for the excellent customer service. Another reason why Royal Queen Seeds is top 3 in breeding!!
Likes
136
Share
~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_ 💡🌱🤘🐱 Week 10 of flower! Amber trichomes are starting to form, we're cloudy in most sections but there's still a bunch of clear a little deeper in. This is probably their last full week..we cut all nutrients nearly a month ago and have been watering heavy (as we typically do during flush) but they have only lightened slightly, we use a soilless media which should be completely flushed out by now but most the leaflets are still super dark, after seeing several other grows of this strain we assume it must be characteristic of B.B..we have 4 grow areas in our grow room and the Bangers can be smelled over everything else.. It smells like Fruit Loops with notes of gasoline 🍓⛽...The SP-3000 by MarsHydro is an absolute beast in a 4x2, this is our 2nd grow under The SP-3000 and we completely filled the 4x2 on both occasions. Each run resulted in massive, compact Buds just covered in resin..its without a doubt the best LED of its size we have in house or have ever been privileged to use honestly... Full disclosure: we got a little impatient starring at these girls, so we (well I did lol) pulled down a bud 2 days ago (approx. 10grams) and immediately threw it in the oven for decarb..we made a 5oz batch of tincture and this is easily the "speediest" Seedsman strain I've tried to date, its a surprisingly clear headed high, definitely a daytime smoke..however, may have a different opinion after a proper dry and cure..we'll update our smoke report after drying...thanks as always for dropping by and happy harvests everyone!! ❤️💡🌱 ⚡Mars Hydro/SP-3000⚡ Specifications ⚙️: Diodes: Samsung LM301B / Osram 660nm (960 total!) Driver: Meanwell 300watt 🔌 (300W±5% @AC120V-277V) PPF: 824umol/S ☢️ PPE: 2.8 µmol/j 〰️〰️ Lifespan: 50k+ hrs ⌛ Weight: 10.1 lbs (4.6kg) Veg Coverage: 3 x 5 ft 🌱 Flowering Coverage: 2 x 4 ft 🌼 -The SP-3000 uses an aluminum heatsink (no fan) and the driver can be placed outside the tent 🌡️⬇️ -IP65 waterproof ratings, tolerant to high humidity grow environments 💦 .. -Up to 15 can be daisy-chained together and all controlled from a single light! 💡~💡~💡~💡~💡 ~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_~_
Likes
7
Share
@Lazuli
Follow
So i had a lockout mid flower, i should have flushed earlier but in the end the buds got dense and fat
Likes
51
Share
Finally harvest time arrived 🤗 It’s been a great run, though I had to improve a lot along the way. But as usual there was a way to get things done and finished up😎 After a long heatwave I decided to chop the whole tent, just a bit before I actually wanted to. But I see amber trichomes and heavy buds, so I think it’s safe to chop now, so here we go. 🤩 Can’t wait to taste this after so long watching over it🤤 More details to come.
Likes
5
Share
She has a nice structure, hope to get many buds from this lady, it's a strain I'm very excited to work with, hope to have a nice jar full of this diesel in a few months, stay here with me to see her performance! 💚❤️👨‍🌾