trichome production exploded overnight!

Plants are doing and looking beautiful. Plants look like they fully recovered from the previous weeks mishaps.. Buds are developing nicely at this point And every day I notice them slightly bigger .. I'm noticing the smell get stronger day by day as well Keeping temp at 76-78 and humidity at 45% At the end of week 3 I will run 7L of pure r20 ph@6 through the autopot system , to let any accumulated salts from the hoses and roots flush out . The plants should use up 7L in about 2 days and then I will continue with my regular feedings probably on day 3 of week 4 Also the weather has been getting warmer the last few days and after adding the 2 new lights the temps are getting higher in my tent .. Added 8inch Vortex inline fan to bring fresh air from outside on a controller that shuts on or off depending on temp

Blue Dream starting to get some frost to her. Looking like all the holy comm phenos are gonna be a long flower time judging by the slight difference in bud sizes between the blue dream and the holy comms. Going to give them a top dress and a recharge with a few things come the end of the week. Until then just straight butt chuggin out the acinfinity self watering bases.

15.04. F5 Flower Day 5 – Early Stretch The plants are transitioning into the flowering phase without any issues. Stretch has started and growth is becoming more vigorous. Current environment: * Temperature: ~22°C * Humidity: ~60% (slightly high, will be reduced gradually) Performed light training to even out the canopy by bending down the taller shoots. The Autopot system is running very consistently, and the plants are responding extremely well to the BioTabs setup. At this stage, the focus is on maintaining an even canopy and keeping environmental parameters in range while the stretch develops. So far, everything is running smoothly.

First one cutted

it was so easy to grow, love this plant it's glorious and the taste... no comments, its earthy and maybe some diesel aroma... it was happy 1st grow of the ILGM's Gorilla Glue Auto!!! strongly recommended for beginners.

Progress

Hello everyone! without many words! 100% in perfect condition !!!

Cherry Cola diesel smell ⛽️

I’m getting close to harvest; I’ve already done a root flush on the most advanced plants. I’ll try to do it gradually, both due to time and to avoid excess humidity, since where I live the lowest I can get, even with everything open, is around 50%. I’m also applying a foliar preventive treatment against fungi. Additionally, instead of watering lightly and frequently, I’m trying to water less and keep the soil dry for more days. The leaves are starting to change color, a sign that harvest time is approaching. I have a carbon filter, but they still give off a smell that’s hard to hide.

It's happening! It's going to be a high of 32C/90F and so very sunny, so why not train them today? They're both 22 days from seed as of training start. #2 got FIMmed: So I was planning on topping one but ended up choosing to FIM it instead because it's lower stress. I have no idea what will happen now. I've never done either before. I chose #2 because it seems to be having an easier time producing leaves so far. I have a video of the cut. I used a pair of bonsai shears. I was really second guessing that I actually had to cut the leaves? I missed one, and it just felt weird to go back in and cut healthy growth, even though I'd already took off most of the newest leaves. I am not convinced I did this correctly because I don't understand what happens with the tiny new node I didn't cut. We will see. #1 got LST'd: With LST, I maybe should have done it sooner. The issue is the leaves are wide enough that they would be touching the soil if I really bent it like I was planning. I even undid it and tried the other direction just to see that it was even wider across. I propped a leaf on the tie and will have to adjust it again tomorrow once the crown has righted itself. I also read that it's not good to keep them in ties once they've gone into flower for autos because it stresses them, but with two plants I had LST'd, removing the ties just resulted in them eventually straightening the stems back out. So I'll not do that again for this one. I'm also a bit obsessive about measuring my plants, and that's harder with LSTing. I have a ribbon tape measure I use to measure the main stem length instead of the actual height of the plant.

Week 6 of flower for the Fastbuds banana purple punch and gorilla cookies. The gorilla cookies has a real strong hazy smell to it and the banana purple punch has a real fruity smell to it. The strawberry banana from Fastbuds is flowering nicely a couple weeks behind.

Growth has finally picked up a bit with this girl she's bushing like crazy and noticed over the last few days she is using more feed/water now and is producing a lot of budding sites did some defoliation and tucked a few branches stripped a bit of waste materials from under the canopy to give extra energy to the tops happy week so far.... 09/12 a little problem went to find my trellis had come of the clips pulling my canopy into one big ball sorted it and put a pic up of the day after so no major problems or snapped branches luckily thanks for reading happy growing

it grows so fast. The lower leaves are shaded and away from the light. So I cut them as the plant gets taller I really don't have a good setup to be able to clean my roots. I tried this week anyway. I watered each pot with 2L (not enough I think :/) of water at 450PPM PH: 7 then after I gave 1L of water at 900PM PH: 5.5. There was a big puddle in the room afterwards. But it wasn't that hard to clean up after all. In 5 minutes with a rag and a bucket ------------------------------------------------ -Daytime temperature: 24-29°C -Night temperature: 22-27°C -Humidity: 50-75% ( Too high but it's hard to lower it... I need advice please contact me if you have :) ) -Lamp: Mars Hydro FC3000. intensity 80% at 40cm from the top leaves -Room: Mars Hydro 100x100x180cm -Extractor: Mars hydro 402 CFM Max. power 3/10 -Substrate : 70% coco, 25% perlite, 5% vermiculite. My instagram : https://www.instagram.com/p/CuMhQ_BsjRP/?utm_source=ig_web_copy_link&igshid=MzRlODBiNWFlZA== Looking for MarsHydro equipment for your crop? 🔥 You can use my promo codes! 🙏😻 "houstone3" for: TS LED Grow Light, Tent, Ventilation for 3% off "houstone5" for: FC&FC-E&SP LED Grow Lights; Grow Tent Kits for 5% off https://www.mars-hydro.com/?acc=hou-stone

And she’s up and drying! Massive yield, piney earthy terps— perfect structure. Just a great plant all around! More to come

Día 62 (24/06) Riego con 1.25 Litro H2O + Regulator 0,15 ml/l + K-Boost 1 ml/l + CaMg-Boost 0,3 ml/I + TopBooster 0,3 ml/l - pH 6.2 Día 63 (25/06) Riego con 1.25 Litro H2O + Regulator 0,15 ml/l + K-Boost 1 ml/l + CaMg-Boost 0,3 ml/I + TopBooster 0,3 ml/l - pH 6.2 Día 64 (26/06) Riego con 1.25 Litro H2O + Regulator 0,15 ml/l + K-Boost 1 ml/l + CaMg-Boost 0,3 ml/I + TopBooster 0,3 ml/l - pH 6.2 Día 65 (27/06) Riego con 1.25 Litro H2O + Regulator 0,15 ml/l + K-Boost 1 ml/l + CaMg-Boost 0,3 ml/I + TopBooster 0,3 ml/l - pH 6.2 Día 66 (28/06) Riego con 1.25 Litro H2O + Regulator 0,15 ml/l + K-Boost 1 ml/l + CaMg-Boost 0,3 ml/I + TopBooster 0,3 ml/l - pH 6.2 Día 67 (29/06) Riego con 1.25 Litro H2O + Regulator 0,15 ml/l + K-Boost 1 ml/l + CaMg-Boost 0,3 ml/I + TopBooster 0,3 ml/l - pH 6.2 Día 68 (30/06) Riego con 1.25 Litro H2O + Regulator 0,15 ml/l + K-Boost 1 ml/l + CaMg-Boost 0,3 ml/I + TopBooster 0,3 ml/l - pH 6.2 Vaya monstruo de fenotipo. Espectacular! 😍💪 💦Nutrients by Aptus Holland - www.aptus-holland.com 🌱Substrate PRO-MIX HP BACILLUS + MYCORRHIZAE - www.pthorticulture.com/en/products/pro-mix-hp-biostimulant-plus-mycorrhizae

Big week! I got my new EarthBoxes and a bunch of goodies. I picked up the Probiotic Farmer's Alliance kit from BuildASoil, so I also got some EM-1, Kashi Blend, dolomite lime and Malibu compost. Alongside that I picked up Colorado Worm Compost (vermicompost), Gnarley Barley (malted barley, corn and hemp) and Craft Blend (aprox 3-5-2 organic mix). Unfortunately there was a bag of soil missing, so I ended up using my own mix though I am somewhat scared of it being too clay-heavy for the SIP. I inoculated with EM-1 and began fermenting a batch of activated EM-1 to make the bottle last longer. It looks about a week from LST, after that I hope to set up a two-tier SCROG setup and begin growing the bushes. I will begin spraying AEM-1/EM-FPE/EM-5 alternatively once a week for IPM, I will try to avoid using neem this round (unless I find this approach lacking). I also brewed a batch of EM-FPE with aloe that smells incredible, I can't wait to give it a go.