Trimmed front 2, left back 2. Switching from 13/11 to 12/12 on Monday.

Getting near the end now. Plants are smelling magnificent! I think it'll be two more weeks until harvest. Fingers crossed the buds continue to gain weight. I'll be fully stoked if I get an ounce of nice flower off each plant.

Missed last week update but did some cutting girls have to live up to the mission 73 between the 5 plant....added one more which was a cutting from a seed plant harvested previous...didn't look like I did anything so cut dem a few day later 85 between the same plants... only cut the lower half of G4 n smaller inside branches( going to stop they dont hold up well)

When I started growing I set two goals for myself. I was the first to make 1 gram-1€ and I was very close. This grow cost me 52€ (that includes electricity, seeds, biobizz...) but unfortunately I had to buy nematodes (+ 9€) for a total of 61€. That means he would have succeeded if I hadn't had a fly infestation from the ground. I told you that I was very close to the goal. The second one is to make 1w-1gram, considering my setup and my "knowledge"🙈, I think it's impossible. However, I must admit that I am very satisfied with 53 grams. HAPPY GROW EVERYONE AND GOOD LUCK GUYS.

I did not top this girl, yet. Her top lowers started catching up to the top so I didn’t want to stop her yet lol. But all in all she’s looking healthy.

-

Semana 6 Floración

First time grower, criticism will be well recieved😀 Two plant ebb and flow setup in a 3x3 as a test run Top feeding until I can afford the rest of my setup🙄 Started seed in water balanced to 6.0 Sat. Feb. 29th Tap roots within 12 hours, directly into pre soaked rockwool cubes. Broke the surface march 3rd. Began 1/4 strength micro, grow, bloom and stress relief Using very hard water for the next couple days, roughly 450 PM out of the tap. Ro system to be installed march 6th Ro system now installed. Start of week 1 will be Saturday the 7th of March. Day 2: Turned the light down to roughly 50%, instead of raising it, due to the fear of light burn. Will look into it soon. Plants seem to have recovered after I decreased the light intensity. Fan and filter purchased. Alternating flush and feed cycles 12 hours apart to keep salt sats down. Day 3: Bumped light intensity back up to roughly 75% of the ts1000's capability or 700 "light units" from a cheapy 3way meter. Adding as much co2 as I can through baking soda and dilute phosphoric acid. Day 4: Exhaust fan with climate control installed March 10th Day 5: Girls exploded now that I have my salt build up figured out . Day 6: Light back up to 100% Day 7:little droopy on the one plant, gonna let them dry out a day Setup should be complete for start of week 2.(actually sick right now and having trouble getting supplies) Still need a flood table setup.

Woche 3 Das Fundament wird gelegt und Umtopfen steht an. Die Schoki ist in der dritten Woche ihres Lebens. Die ersten Seitentriebie bilden sich und die Pflanze ist gesund gewachsen mitlerweile hat sie 3 Nodien. Und ist über ihren Cube hinausgewachsen und hat diesen kräftig durchwurzelt. Somit wird jetzt in den 3l Stofftopf umgepflanzt. Danach gibt es zum ersten Mal die standart Düngedosis, angepasst an das Pflanzenbild 2,5 -5ml Hesi TNT für ordentlich Nährstoffe im Wachstum, 5 ml/l Hesi Root für eine kräftige Wurzelentwicklung und 2 ml/l Calmag, um unser Osmosewasser aufzuhärten. Der DLI wurde auf im Laufe der Woche auf 40 erhöht. * Zustand der Pflanze: Die ersten "echten" Blätter sind vollständig entwickelt und wie durch die EasyCubes zeigt sich wie eine kräftige Wurzelbildung. * Wichtige Ereignisse: Beginn der Nährstoffgabe. Anhebung des DLI. Umtopfen in 3L Stofftopf * Düngung & Messwerte: * Gießwasser: pH ca. 6,0. Leitwert ca.1,4 - 2 S. * Drain: Wir messen sporadisch, um die Abweichung von +/- 500 S einzuhalten. * Anpassungen: Wir sind überrascht wie gut sich die Pflannze im Easys Plug System entwickelt hat.

UPDATES: - Pushed them a little too hard as you can tell by the pics, pushed temps up to 31/32'C. Pulled temps back down to 29'C, seems to be the sweet spot. -Just waiting to harvest GENETICS: -MSNL - Gorilla Glue Auto ~ my favorite strain, as you can tell by my username! WATER: -Condensed (Starting at 40ppm) -Disinfected prior to adding nutrients etc. (Using COOSPIDER UVC - 253nm & 187nm bulb) CLIMATE: - Ambient Air Temp = 29'C ~ 28'C LST ~ Leaf to air temp variance of between 1'C - Night Temp = 22/23'C ~ Day/Night temp differential 6-7'C - Under Canopy Temp: 26'C (Day) ~ 21'C (Night) - Relative Humidity = 50-60%RH (Avg. 55%RH) - VPD = 1.45kPa (Avg.) - Co2 ranges from 900ppm to 1500ppm (Avg. 1200ppm) AIR PRESSURE: - Ambient Air Pressure (outside tent) = Mean Avg. 1010 mbars (101 Kilopascals) - Actual Air Pressure (inside tent) = Mean Avg. 1005 mbars (100.5 Kilopascals) - Air Pressure Differential = up to 0.5 kPa range between inside & outside LIGHT: - UVB ~ 2 hours daily mid light cycle. - Warm White 3000K/White 5000k/Far Red (660nm) - At plant canopy = PPFD 900-1000umols/s/m2 ~ Lux 45,000-55,000 ~ Daily Light Integral 55-65 - Under canopy lighting ~ Blue (460nm)/ Red (630nm) NUTRIENTS: - Mostly Advanced Nutrients (For base nutrients and most additives, as only company I could find scientific data on) - Canna (For Calmag Agent and Cannazym) - Plant Success (Great White Mycorrhizae) ADDITIONAL GROW TECHNIQUES: - Mostly getting out of the plants way and letting nature take its course. - Some LST. (i.e. tying down branches and tucking large leaves away) - No HST or Defoliation. INFECTION PREVENTION & CONTROL: Infection control practices i.e -PPE, Alcohol Hand wash -Gray room outside tent, -Carbon filter -HEPA filter -Plasma Ionizer -Inline UV-C germicidal bulb - Also using an additional higher powered COOSPIDER (UVC) 253nm & 187nm bulb, to disinfect the gray room outside of the tent once a week for 30 mins. - Ozone (o3) gas that is produced using the COOSPIDER, is then directed into the tent to further control any unwanted pathogens. - Ed Rosenthal (Zero Tolerance organic pesticide), sprayed once a week as preventative measure. On hand for heavier use (Once every 3 days before lights out for 15 days) in the case of an outbreak (No outbreaks yet, due to aforementioned preventative measures)

Love the way these ladies are developing; the tent smells so good. Nothing to report this week. Spring weather is approaching in the midwest... tent gets a little warmer late afternoon. Will keep monitoring, but as it warms I will turn the AC on and should be good. Reducing veg nutes, increasing flower nutes. Pics/vid taken 71 days after breaking the soil.

Final month of veg left all are still healthy and bug free ,another 2 weeks and will start flush them and reduce feeds to 1/2 dose then none the last few weeks

Thick luh mas. Some the White wedding phenos all outperformed my custom bred seeds. I’ll be sticking to a legitimate breedeer drom here forward Most plants have all white hairs 3 plants are crazy dense and beautiful Other plants are showing why a pheni hunt is impor

Well I finally got these girls in the dry tent did not get a wet weight will update on the trim and dry weight I will suggest if you are using 5 gallon pots definitely jump to at least a 7 gallon pot huge difference the buds look and smell awesome ready to set up 5x5 and 30 gallon pots

I do less nutrients during this week and treated as if it’s weak one because as you know, I use fox forms ocean forest and it has nutrients in it so I don’t wanna overpower my plants and I just wanna see how they do with a little bit of nutrients before I upped the dosage

This weeks been hectic! Iv had a lot of training to do and a fair amount of defoliation - all only done until my plant had no feed left. Iv signed up to a couple of patreon accounts : ‘Willymyco’ and ‘DGC - dude grows podcast’s. Another great podcast. However, over the past week there’s been a heatwave and I accidentally pulled the red on/off plastic valve from the res for a second , it’s all good and just went on insulated wires…so I just mopped it up. I changed it to a mars hydro ts-1000w, and then the ts-600. Glad the dimmer works though or temps will be insane! I am still thinking of putting in the fc-e3000 but if I do that I’m going to have to take out the stoppers from the ends and hacksaw some off. It’s only cheap aluminium and then I’m going to think about removing one of the light strips if I can. Then I’ll just keep it low. It’s still weird working with a plant they suggested, un-topped— this is the first time i have done this in my life - I have literally always - HST’d, using the early veg stage and making used of the time for it to heal.

Day 113, Flower Day 57. Harvested Bubba Kush today as I felt nervous with it from last week's powdery mildew. It is hanging on hangers in the small tent drying now. GSC is going to get 1-2 more weeks.