Processing
Likes
Comments
Share
@
Follow
Likes
18
Share
Getting closer now-- Unfortunately the humidity has risen a lot over the last week so mainly focusing on that issue As for the 3 girls one I'm just leaving to do their own thing stumped frosty still bad no hope with her the two in video however are phenomenal 1st we got the frosty gelato - smell quite gassy to touch The vanilla Frosting has a beautiful citrus smell to touch And both are stupidly sticky! I'm estimating 1 week left of full nutrients Then reduce to just the ripen and half cal-mag Finally a week of pure flush
Likes
10
Share
@Kinghaze
Follow
I put the autopot system on and put op a trellis net . Unfortunately I did not have a scrog net with small compartments , but I will put a second trellis in week 2 of flower with the smaller ones
Likes
Comments
Share
Tuve problemas de raíz al tener poco drenaje con las botellas y tube que trasplantar antes de tiempo, de los errores se aprende.
Likes
12
Share
Likes
26
Share
@CapeGrows
Follow
This grow took me around 12 weeks to complete. I harvested at about 80 days and got some beautiful dense nugs. I have found growing autos in DWC allows to get amazing results. During this grow I started feeding bloom nutrients at a much earlier stage to try and make them available as soon as the plant can use them. I also found this didn’t effect my stretch much and allowed for a whole lot of bud sites. Take note that most micro nutrient lines contain a lot of nitrogen and when the autos start making bud sites you can cut the grow nutrients much earlier. I had pretty good results with micro and bloom during the early flower stage. I also found that by gradually removing certain growth and not adding too much stress, the strain reacts pretty well. If you do decide to do a heavier defoliation, rather do it after the plant has completed its stretch. This will help not shock and stunt growth during vegetative stage. I would personally recommend to try and scrog this strain of grown in dwc for even larger yields as I removed quite a lor of growth during my grow. I will definitely make use of this for my next grow. At the middle of the flowering stage I installed a dehumidifier and tried to keep it between 45-55% RH. My temperatures were consistently between 20-27 degrees as I ran a 24h light cycle. I also made use of a mycelium bag for some added Co2 which I found worked well. I am overly satisfied with the yield and density of these flower and would recommend Fastbuds genetics to anyone looking to grow their own. High quality and very high yielding plant.
Likes
9
Share
Likes
70
Share
Likes
70
Share
Ich warte 10 -12 Tag für netto gram.
Likes
11
Share
Plein de résine sur les Bud se développe bien tu grosse odeurs de bonbon au fruit rouge.🎄🌅🌡️
Processing
Likes
9
Share
These are about a month old. I've no idea what they are as there from a long time ago and were mixed with a few varieties of autos and photoperiod. Hopefully they work out and are not Spanish sativa as that just gives me a headache after more than 0.25g in a day?? Anyone else ever have that? Powerplant does the same if I use more than 0.50g in a day. The only two strains that have that effect on me!
Likes
8
Share
@Darfman
Follow
Zdarec 😎 Zjistil jsem,že už od začátku kdy měli holky teprve 10cm jsem měl světlo až nahoře u stropu, tak se dost vytáhli. To je vidět také na fotkách. Vše napraveno a už mají světlo 13 cm od vršků. Zas tolik to snad nevadí, protože tohle je jenom předpěstování. Pak půjdou do prostoru 60x120x180 pod 220w LEDky. Před týdnem jsem toppnul vršky a udělal defoliaci spodků. Takže holky mají každá 6 větví. Ty spodnější ještě roztáhnu ať se holky košatí. Dal jsem na ukázku video, kde je vidět také Critical Mass před sklizní. Jak usuším, tak přesunu holky do většího a přesadím do 11 litrových květináčů. To je vše,tak zase za týden zdar 😄😎🌿
Likes
4
Share
@Dmars
Follow
11/22 Day 31 from flip. Today is the first day that I took a tape measure from the lights to the topmost part of the canopy and I haven’t seen a change. I’ll check again tomorrow but I’m really hoping the stretch is finally done. I still have about 10 inches of space between the lights and canopy so I think I’ll be ok with that. I took the chance to do what is hopefully a near final defoliation of a few leaves and some smaller sucker branches that won’t amount to much. Everything still looks super healthy, no red anywhere on any stems and no discoloration on the leaves. Everything is spot on. Light adjusted to 840 PAR / 36.3 DLI. 11/25 Day 34 from flip. I made some adjustments to my nute mix to be more firmly at 1.3 EC, which means I’ve added some additional nutes into the mix. I also tested runoff EC and discovered things were spiking a bit more than I’d like. So I mixed up a few batches of my new mix and I’ve been feeding every few hours to flush things out a little bit. I’ve brought it down from 1.9 to 1.5 so far after this. I may finally need to break down and set up some timers to feed multiple times throughout the day. Obviously once a day is not getting done right now. 11/26 Day 35 from flip. I finally got the timer hooked up to my pump to begin automatic watering. For now, I have it set to water at noon for a minute when the lights come on, a 2 minute pause to let that settle, and then 30 seconds more to make sure both are fully saturated. The second fertigation event will be at 6:00 for 45 seconds, and then right before lights off another 45 seconds. I’ll have to keep an eye on it to see if I need to adjust any more for now. I haven’t adjusted the lights since last time, but the latest reading is 885 PAR / 38.2 DLI at the highest point of the canopy. It’ll stay there for now.
Likes
4
Share
@Ageddd
Follow
ULH_1 Starting to flower, it is 3 weeks old. This morning, spotted the new hairs, so my thoughts were clear: This plant needs a final transplant before Flowering ^^ . 25 litres tex-pot, with Canna-Terra Pro. First nutrients feeding, after rooting period. Dose is 2 ml/l TopVeg. Planning to give her Veg nutes for 3 weeks at least. ULH_2 is still growing and rooting, its like 2 weeks old since germination.
Likes
10
Share
Week was a bit more of a pain than some.of my other grows. Working on getting the sprout to stretch a little. Also feeding some PH water while adding a bit of additional dirt to fill void around sprout.
Likes
7
Share
Day 43 12/06/2021- Beginning of week five of flower. She should be done soon, she will also get her final feeding soon. Day 45 12/08/2021- She got her final top dress today from here on out she is on her own all I will do is water with pain water PH to 6.2-6.8 when dry. Day 47 12/10/2021- She is coming along nicely. Very frosty wish she wasn't a auto so I could of clone her for sure. Today she got a nice treat as it rain in my hometown and that's the water she got. Hoping she is ready by the end of the year. I know she looks funny but she was never topped either. Day 49 12/12/2021- End of the week, nothing new.
Likes
11
Share
@Kayotic
Follow
*Day 67 since sprouting *Week 5 of flower *Smells strong now and very frosty *Final defoliation a few days ago *Still no nutes *Watered a gallon today
Likes
5
Share
Hi liebe Community! 💚 In den letzten zwei Wochen hat sich die Pflanze wunderbar weiterentwickelt. Der Wuchs der Pflanze ist sehr kräftig und nun war es an der Zeit, die Pflanze zu drehen, damit sich ein leicht entstandener Höhenunterschied wieder ausgleicht. So dass sich die seitlich runtergebundenen Triebe besser entwickeln können. Außerdem habe ich nun einige Sonnensegel zurückgeschnitten, damit die Pflanze ihre kompaktere Wuchsform beibehält. In spätestens zwei Wochen, wird die Blüte eingeleitet😉 Die Wachstumsbedingungen im Growschrank sind weiterhin am Optimum und Stabil: ——————— 🌞 Temp: 26°C 🌚 Temp: 20 °C 💨 RH: 68% VPD: 0,7 kPa ———————
Likes
16
Share
Aug 24: starting the sixth week of flowering. I’ve added another Scrog layer mostly to help keep fan leaves out of the way and expose the bud sites. This “loose Scrog” or whatever technique works quite well. She’s fairly leafy but the buds are coming. 👍 defoliated to remove fan leaves that were growing toward centre. Don’t want to overdo it but there needed to be some removed. Aug 25: nice sunny day and had the UV lights going. Took flash pics just before using the 730 nm far red light. Don’t use a flash like this if you don’t have the red light as you might cause it to hermie. But you can get great flash pics. 👍 Aug 26: looking good. Watered with potassium silicate this evening. It’s a strong base and it takes a fair bit of vinegar to get the pH back down to about 6.4. That’s fine though because the microbiota (‘bugs’) will appreciate a serving of easily digested acetate. That’s part of why it’s better to use vinegar than HCl. Chloride would not help but the organic acetic acid does help.