This week I had to Lollipop again (I know is very late and I hope I didn’t stressed the plant to much). My canopy is so tick and so many overlapping leaves and buds in the center of the plant that don’t receive enough light or any at all , n combination with the RH swings that I got going on (45 and 63 RH), I’m very afraid of mold. I should have did a better job at Lollipoping from day 21. I’m inexperienced grower and I didn’t knew better. I decided is better to risk to shock the plant a little bit risking a reduction in yield then get mold or pests and lose it all. My 30 pin dehumidifier works great with the AC but sometimes when the AC( compressor) stops my RH jump at 62% -63%, witch I don’t like . I’m trying to keep the humidity around 50% but in such a small room between the AC and Dehumidifier I got big swings in temp ( 75-82) and RH ( 45%-63%) witch is not ideal but is nothing that I can do. I played with the AC and Dehumidifier setting a lot trying to keep humidity around 50% and temp around 80 degrees and that’s the best I can. My AC is set at 82 degrees and my Dehumidifier is set at 45% RH. Also during the lights off (day time) is very hard to keep the temperature In control when outside is 110-115 degrees with my portable AC (1400BTU) in the 4x 6 closet. Is crazy but I do my best to keep temp under control. This is another rocky mistake I made is trying growing weed DWC in the middle of summer where temps are 105-115 degrees constant in a closet without centralized AC port and at second level in the building. LOL Also I think I underfed her (630 PPM TDS, PH 5.8-5.9) ) and I got a Ca deficiency witch I think is the reason my flowers developed slower then I anticipated. Hopefully I’m wrong and everything will be good. P.S. I got a little bit of calcium deficiency caused by salt buildup (to much PK boost) despite my earlier belief that is underfed. I increased the PPM from week 4 (630-640TDS) to 680 TDS) on week 5 while I kept the PK booster at 3+ml l per gallon. Slightly my PPM’s was rising in my reservoir for few days until I decided that my plant can’t take that much nutrients (PK). 2-3 days after I increased the TDS I’ve noticed more spots on the lower leaves with tip burns on top ( first signs of PK toxicity). One day later found spots and yellowing of the leaves on top of the plant that indicates Ca deficiency caused by salt buildup ( PK toxicity) and reversed osmosis (hope I’m not wrong). Going into week 6 I lowered the PK boost at 1.5ml / gallon and total TDS to 640 PPM. Seems like leaves damage to stop and my PPM to stay stabile at 630-640. Trying to keep PH at 5.8 max 5.9. I will post pictures of my Ca deficiency/ PK toxicity. If you guys have any suggestions please leave me a comment.

This week I had to Lollipop again (I know is very late and I hope I didn’t stressed the plant to much). My canopy is so tick and so many overlapping leaves and buds in the center of the plant that don’t receive enough light or any at all , n combination with the RH swings that I got going on (45 and 63 RH), I’m very afraid of mold. I should have did a better job at Lollipoping from day 21. I’m inexperienced grower and I didn’t knew better. I decided is better to risk to shock the plant a little bit risking a reduction in yield then get mold or pests and lose it all. My 30 pin dehumidifier works great with the AC but sometimes when the AC( compressor) stops my RH jump at 62% -63%, witch I don’t like . I’m trying to keep the humidity around 50% but in such a small room between the AC and Dehumidifier I got big swings in temp ( 75-82) and RH ( 45%-63%) witch is not ideal but is nothing that I can do. I played with the AC and Dehumidifier setting a lot trying to keep humidity around 50% and temp around 80 degrees and that’s the best I can. My AC is set at 82 degrees and my Dehumidifier is set at 45% RH. Also during the lights off (day time) is very hard to keep the temperature In control when outside is 110-115 degrees with my portable AC (1400BTU) in the 4x 6 closet. Is crazy but I do my best to keep temp under control. This is another rocky mistake I made is trying growing weed DWC in the middle of summer where temps are 105-115 degrees constant in a closet without centralized AC port and at second level in the building. LOL Also I think I underfed her (630 PPM TDS, PH 5.8-5.9) ) and I got a Ca deficiency witch I think is the reason my flowers developed slower then I anticipated. Hopefully I’m wrong and everything will be good. P.S. I got a little bit of calcium deficiency caused by salt buildup (to much PK boost) despite my earlier belief that is underfed. I increased the PPM from week 4 (630-640TDS) to 680 TDS) on week 5 while I kept the PK booster at 3+ml l per gallon. Slightly my PPM’s was rising in my reservoir for few days until I decided that my plant can’t take that much nutrients (PK). 2-3 days after I increased the TDS I’ve noticed more spots on the lower leaves with tip burns on top ( first signs of PK toxicity). One day later found spots and yellowing of the leaves on top of the plant that indicates Ca deficiency caused by salt buildup ( PK toxicity) and reversed osmosis (hope I’m not wrong). Going into week 6 I lowered the PK boost at 1.5ml / gallon and total TDS to 640 PPM. Seems like leaves damage to stop and my PPM to stay stabile at 630-640. Trying to keep PH at 5.8 max 5.9. I will post pictures of my Ca deficiency/ PK toxicity. If you guys have any suggestions please leave me a comment.

1rq semana en floracion.

1rq semana en floracion.

1rq semana en floracion.

all 6 plants are starting to flower but its still 100 degrees out here

Buds are getting heavy, I had to craft a net to hold them up. All smells fantastic, looking good.

Buds are getting heavy, I had to craft a net to hold them up. All smells fantastic, looking good.

Cut the little Canuck on day 75 before dawn and placed in tub of clean water for 4 hours to remove debris. Then hung under a shady tree to dry excess water. Very dry breezy day. By evening I weigh it at 168 grams stem and all. Then hung upside down bag open to dry. It was beginning to wilt after 48 hours... hopefully long enough to break down some carbs. I’ll be checking every day an if rain threatens I’ll put in shed. Hope to trim and bag in shed after 7 days to finish drying. Pyramid is ready to cut. It will get the same treatment. I know this is a little unorthodox and a bit risky getting the plant so wet before drying. I feel like it just gives the plant an extra day to use up any nutrients and break down those starches.

This week I have fed my girls for the last time (feed-water-water-feed) and I think they are ready to go into a flush, I know one of them really needs it but I shall not name and shame 😂 but overall been a pretty boring ass week, although last week I said I didnt care about the deficiencies something is getting worse and I want to know why to stop it getting g worse a d prevent this happening again I shall ask the question down below, thanks for dropping In and giving this a read, Happy Growing!👊👍

Flushed one for a week and now into darkness. The last two that started flower under the cheap LEDs need a bit longer. They will need another three weeks. The one plant looks really pretty and smells great. The upside is I don't have to trim them all up at the same time. Looking forward the the cure. Cheers

Flushed one for a week and now into darkness. The last two that started flower under the cheap LEDs need a bit longer. They will need another three weeks. The one plant looks really pretty and smells great. The upside is I don't have to trim them all up at the same time. Looking forward the the cure. Cheers

Buds are fattening by the day, grow tent has a nice smell of juicy fruit mixed with caramel..definitely interesting. Leaves are starting to turn yellow as the plants are sucking everything out of the soil. Trichromes are looking clustered and almost there, getting some ambers which should give a nice high...harvest next week?..I think so! :)

What a week recovering from a transplant brought on by Nitro Lock. We start week 3 Monday! I added one more new plant to the group being my total number of plants up to four!

Donna Jo is still being watered; -Tuesday with full gp3 (green plant 3 part) plus Cali mag by General hydro PhD to 6.2 roughly 2 litres - Thursday get PhD Cali mag water and Only 1 litre at most. Try not to water Thursday unless she is to dry to make it to Friday -Friday full gp3/ Cali mag PhD 2-3 litres -Sunday full gp3/Cali mag PhD 2-3 litre -Monday/Wednesday/Saturday no water. This week had a pretty major change not just in flower production, but also decided to change tent set up as well. Changes to the tent included ditching the 600w led and the 2x 2000w garbage led lights (i call bs on manufacturer saying they are 2k) These 3 lights are now out and we have stepped up to cmh 315w. Should have bought this cmh 315 right off the hop and not spent the money on led. Now going to cmh the tent run way hotter and has required other upgrades to keep from overheating. The duct system was dual t4 cloudlines running one in and one out off the same control module has now been changed to a T6 cloudline exhausting with a t4 feeding cool/fresh air. Tent jumped 9 degrees with cmh 315 so had to also add the overheat back up plan. Put a 6” inline duct (can fan pushing extra 200 cfm) along the exhaust line closer to window exhaust point which is plugged into an ink bird plug and play thermostat set to 82. This just helps the T6 do a better job with less noise. With these changes I feel way more confident of yielding a higher gram/plant ratio. I believe if you look at last weeks pictures and compare to this weeks you will probably agree with me. You decide .......😀

Donna Jo is still being watered; -Tuesday with full gp3 (green plant 3 part) plus Cali mag by General hydro PhD to 6.2 roughly 2 litres - Thursday get PhD Cali mag water and Only 1 litre at most. Try not to water Thursday unless she is to dry to make it to Friday -Friday full gp3/ Cali mag PhD 2-3 litres -Sunday full gp3/Cali mag PhD 2-3 litre -Monday/Wednesday/Saturday no water. This week had a pretty major change not just in flower production, but also decided to change tent set up as well. Changes to the tent included ditching the 600w led and the 2x 2000w garbage led lights (i call bs on manufacturer saying they are 2k) These 3 lights are now out and we have stepped up to cmh 315w. Should have bought this cmh 315 right off the hop and not spent the money on led. Now going to cmh the tent run way hotter and has required other upgrades to keep from overheating. The duct system was dual t4 cloudlines running one in and one out off the same control module has now been changed to a T6 cloudline exhausting with a t4 feeding cool/fresh air. Tent jumped 9 degrees with cmh 315 so had to also add the overheat back up plan. Put a 6” inline duct (can fan pushing extra 200 cfm) along the exhaust line closer to window exhaust point which is plugged into an ink bird plug and play thermostat set to 82. This just helps the T6 do a better job with less noise. With these changes I feel way more confident of yielding a higher gram/plant ratio. I believe if you look at last weeks pictures and compare to this weeks you will probably agree with me. You decide .......😀

I think there’s been some sort of salt build up / nutrient lock. The lower leaves have been turning a lighter green and some even yellow on SL plants. Most stems are red. Seems like it’s a pH problem. I flushed them with 4-5 litres of water to reduce the nutrient concentration in the roots. Going to introduce molasses in next feeding! Organic Unsulphered And also stop the Micro (nitrogen)

Growing good, haven't noticed any worrying signs, RP is happy I guess in it's tent ;)