Processing
Likes
27
Share
ok so everything has gone fantastic , no nutrient burns at all , and have been slowly creeping up the base nutrients , i have stopped the cal mag and now adding house and gardens bud XL at full strength these girls are now in full swing of flower and i bought a new ph stick this week , i have found when PHing the feed bucket that its best too have air stones in the bucket , add all nuts and then ph but do not use the feed that day as if you check the next day the ph is off again so i left it 24 hours after i add more ph down , and it seems too make the measurements alot easier and stable , i have bent down the main stems " without damaging them onto my netting too A keep the canopy all the same high so my lighting is covering all plants at the same distance and also it allowed the side stems too reach up too , i also was sponsored another new led light by kingbo this week so have added another 600watt led too the grow , so now have two 600's and one 900watt , and temps are still fine sitting at 24c lights on and 19-20 off , so am pleased with that , this lady is nice and compact and tight lots of leaves that I had too remove too open up her bud sites , stretch was also minimal ,
Likes
1
Share
@Pestitel
Follow
Amazing experience with the Mix Pack, I will try it again next summer for sure. Love the variety.
Likes
39
Share
La temperatura ha afectado en su crecimiento, pero comenzamos a ver que algunas hojas se pusieron de color amarillo por ende especulamos que podría ser por estrés lumínico se separaron los paneles a 60 cm. Se regó con Top Veg para comenzar su crecimiento como corresponde. Seguimos ...
Processing
Likes
11
Share
Week 5 buds are getting fat!! Starting to get excited.. continuing lst and defoliation!
Likes
8
Share
It was the last days of Thelma & Louise, they stayed together until the end 💪 At the beginning, I planted 2 seeds hoping at least one of them will make it until the harvest but this grow really exceeded my expectations. It was my first outdoor grow and I'm so happy with it. I had so much luck with the weather except the first week and the plants grew really well, especially Thelma! They smell so good 😁 I didn't add many pictures of the plants this week because I will put them in the "harvest weeks" for a final photoshoot! See you soon for the harvest and the smoke review 😎
Likes
25
Share
These girls are smelling like fresh, sweet with a hint of chocolate. MMMMM and they are stacking so hard! Can't wait to smoke this one. Trees are 9ft tall now.
Likes
6
Share
@WeedM8
Follow
Its very hot but its resisting very well
Likes
3
Share
Dense nuggets, identical plants. Pretty easy to trim. Don't think this species is really fungus prone,small buds but very dense. Will update smoke report later. Need to cure now at least 4 weeks. Will post and update in september.
Processing
Likes
28
Share
@TerpedUp
Follow
I went ahead and gave them a lil bit of voodoo just one watering with it. I am doing leaf tucking or leaf breading whenever I see possible. They all seem to like it especially #1 and #3.😊
Likes
109
Share
Our most infamous strain with the stickiest buds in the game. A knockout artist who boasts a staggering 24% THC. Very big and potent. The “glue” comes from so much resin, that your fingers will literally be stuck together while trimming. A large-sized plant that only needs around 9 weeks to reward growers with big enormous sticky fat buds, that any type of grower will fall in love with. Super easy to grow and her pine and diesel terp profile will impress even the most experienced cannabis connoisseur. She is well suited for beginner growers and hash makers should not miss out on this trichome queen. Bud descriptionGorilla Glue Auto’s buds will be chunky and dense, with a heavy resin production that causes your fingers to stick together like super glue. The buds are dark green, with swollen pointy calyx that swell wrapped in bright orange hairs. A truly impressive amount of trichomes that would make excellent cup winning extracts hands down.Smoke reportShe is one for smokers with the highest tolerances and fans of powerful hybrids. Gorilla Glue Auto is extremely potent and her effects are not for the light-hearted. Not only will she glue you to the nearest armchair, your eyes and face will slowly feel the force of her physical effects while you enjoy a nice head high that will keep you deeply motivated and energized. Certainly a perfect choice for staying at home and lounging out with friends or relieving stress and pain while maintaining an uplifted spirit that allows you to continue with your day-to-day chores.Plant AppearanceThis lady likes to stay low and will usually grow to a height of 60-130cm, making her ideal for keeping out of sight. She does not require much maintenance and will reward you with massive yields of up to 450-600gr/m2. Her growth structure is short and bushy, thanks to her sativa dominance, and will grow one main central cola, with fat side branches all around. Once flowering starts, expect Gorilla Glue Auto to fill out thick and fast, as she begins to pack on size, weight and go crazy with the trichome output. From seed to harvest she is ready in 9-10 weeks, where she will finish with a short and fat appearance.
Likes
23
Share
@Chi_K24
Follow
Hey guys, allot happened this week. Mid week on Wednesday I did a major heavy defoliation, she was very bush and allot of internode growth. I clean up everything and allowed more light pen. Also nipped any undesired off growths. Shaping how I want the plant to grow. Basically lollipoping. As you can see I also started to install 4x 1/2 bamboo sticks to help support the plant once she gets bigger. I had problems last year late into flower and don't want to repeat same mistake. I also amended the pots with 70/30 ratio of 444 to 284 @ 2tbs/gal. Iv only water once in the past 7 days with the Aquabak. Not enough data to review the product. We will see. Other than that we have had plentiful thunderstorms and have not required to water. Thanks to the felt pots, they did not get flooded with the amount of rain we got. Prolly 50-100mm worth of rain. Thanks for updates. Enjoy the photos and vids
Likes
10
Share
@4F1M6
Follow
I started germination of 2 M.A.C beans on 29/12/2020. I pre moistened my rockwool cubes with ph balanced water to 6.4. Made sure the plugs were just damp and not soaked. Using a small wooden dowel I increased the size of the plugs pre made holes. Than I sowed my beans into the holes. Ripped off a small piece of rockwool and mulched it up. Lightly filled the holes in with the mulched rockwool. Than stuck the plugs into a misted humidity dome, to complete germination. Shouldn't take anymore than 4-5 days to see some sprouts. Once I see some cotlydon leaves bursting to the surface. I will get the plugs planted into some 1 gallon pots. Plus get these ladies situated into their home. Cant wait! Been itching to give this variety a go! Never givin pev seeds a try but... hopefully they keep this amazing powerhouse true to its name. Guess this grow will double up as testing the waters with pevs genetics. Always intresting to dive in to different breeders.
Likes
102
Share
Germination date 🌱 02/12/2021 Day 101 16/03/2022 Strain 🍁 Barney's Farms Biscotti Mintz (Biscotti x Mintz) THC% • 30% 💡 Mars Hydro FC-E6500 • Power draw 650W + 5% • Max coverage 5 x 5 • LED 3978 pcs high quality chips • Max Yield 2.5g / watt • Noise level 0 DB • Removable Driver & Light bars • Daisy chain • Fast cool system https://marshydroled.co.uk/ 🇬🇧 PROMO CODE • (organicnature420) DISCOUNT https://www.mars-hydro.com/ 🇺🇲 PROMO CODE • (ORG420) DISCOUNT 👍🏻 ⛺ Mars Hydro 150 x 150 x 200cm 📤📥 AC infinity 6inch 💧 10lt dehumidifier ❄️ 3.1kw air con system 💉 Nutrients Dr Forest (dry amendments) Grow Bloom Bloom2 🌱 Growing Media • Soil Notes 📝 What a insane Strain. This girl is coated head to toe in frost. Biscotti Mintz is a beast 3/3 that look and smell mum worthy. Impressed with Barney's Farm they have done well with this. I just can't fault it. Even going to let the mutation slide as this is unreal ❄️❄️❄️❄️❄️❄️❄️❄️❄️ Discount codes in bio for Mars hydro
Likes
67
Share
@Canna96
Follow
Ripper seeds knocked it out of the fucking park with this one. I have no idea what she will yield, but I can tell you this entire plant is just stacked colas from top to bottom. With that being said, I do believe I low stressed trained her far too long and hurt her yield significantly. I did LST from day 30 until day 38, so I believe I lost out on far too much vertical growth during the stretch. I am going to adjust on my next grow and only LST the top 4 mains for about 2-3 days just to allow the bottom 4 mains to catch up. This Acid Dough absolutely reaks, and smells stronger than anything I have grown so far. The trichomes are almost ready, and she is only drinking plain water from my dehumidifier at this point. I am planning on harvesting her on Sunday, and I am working on a little 4th of July harvest video. This will also be my last (flowering) run with the Mars Hydro TS 1000 as I just received a couple new lights from Mars Hydro and ViparSpectra. The Mars Hydro TS1000 was a fucking champ, and I will still use her for vegging my autos. I will be running one auto under the Mars Hydro FC3000, and another auto under the ViparSpectra XS2000 from here on out. I am also running a timelapse of my Gorilla Girl from Sweet Seeds, and since I am only running 2 autos now, I actually have room for it! Unlike the Wedding Cheesecake, I am totally looking forward to trimming this Acid Dough Auto, and I believe it will take less than half the time. This is absolutely one I will be growing again! Thanks for stopping by all, be safe and Blaze On!!!
Likes
15
Share
@UDUDUDUDU
Follow
A little early I think to post. This seed grew into a plant & broke soil 2 days ago. Now to watch this beauty grow up into a full sized big slice of cheese :)
Likes
20
Share
Likes
12
Share
@thonhash
Follow
En esta última semana de prefloracion, aprovechamos a hacer otra poda de bajos y defoliación (como podéis observar,si se ha llevado bien hsta ahora el cultivo,y hacer correctamente los cortes,y en su momento, se recuperará en apenas horas/día. Seguimos regulando el led a un 75/85%(225/240w aprox) y entra en acción el terpesyn. Volvemos a aplicar enzynabis