By continuing to use the website or clicking Accept you consent to our cookies and personal data policy and confirm that you are at least 18 year old. For details please see Privacy Policy and Terms
Hello everyone! I have never grown on coconut and hydroponics before, used only substrates with soil, and now I am starting my first grow on coconut with reversible watering. Maybe I will need your advice and recommendations. Please be happy in my first report on the growdiaries. I started by tossing a Painkiller seed into a Root Riots. Then I prepared a starting solution for buffering the substrate, poured it into the WaterFarm system (T.A) and turned it on for several hours. Here and throughout the report I will indicate not milliliters, but ppm solution. Now I will tell you about my setup, what kind of light and hydroponics I use. In the following I will describe the fertilizers used, as well as the rotary variety. 🙌
For the plant, I use a reversible irrigation system Euro WaterFarm V3 GHE 😎
Its characteristics:
Air pump capacity: 78 l / h
Water pump power: 1.8W
Air pressure: 0.012 MPa
Size (length-width-height): 30x30x37 cm
Tank volume: 15L (solution volume 8L)
Characteristics of my main lamp😇
Name: SIYANIE QuasarBoard 100 Elite v2 UV:
Power consumption: 105W
Efficiency: 2.95 mmol joule
Number of white diodes
Samsung lm301b: 160pcs
Number of red diodes Samsung lh351h v2: 20pcs
Number of Seoul UV diodes: 385nm - 2pcs, 395nm - 2pcs,
405nm - 1pc
Driver: MeanWell ELG-100-36
Board temperature 48C
One panel is designed for a box area of up to 0.36 m2.
Panel size: 407 * 307mm
Characteristics of my additional lighting, which I will turn on later😈
SIYANIE Red 660nm Booster 30 Watt:
2 strips 40 * 7cm 15W each, driver 30W
Each bar has 12pcs diodes Samsung lh351h v2
MeanWell driver.
Planks: 29volt, 500mA.
The current per diode is 500mA.
For what and where:
This additional light is needed to enhance flowering and active mass gain of inflorescences.