+1 strain
I have a 95%cloning rate only because I usually mess up one out of 20 cuts ! Haha , I swear by spraying the shit out of each node prior to cutting and also pull the plant away from the light for 2 days to allow it to stop consuming and start storing - it also works well as performing the stretch prior to going in the cloning chamber making life easier when place for then a few big healthy tops together , spray the entire spot close to node you will cut to push water molecules into the stalk and then also have 99 percent iso to disinfect the blade / scalpel before doing each cut- then very important scraping and Evan removing of just 2 -3 areas of the skin that is close to cut and will be rolled immediately into root powder - I just use promix . Then have correct hole size for stalk to insert into rock wool , then twist counterclockwise into the cube allows it to dig in about to the center of the cube , keep hands disinfected while moving and handling cubes with clones because bacteria will grow on the leaves and stems while in the chamber for usually 8-12 days , spray 5 - 7 times on shield inside and around the cubes every 2 days and take off the shield top after 7 days to allow them to climatetize and start root growth, only take off for short periods and watch them tonmake sure if they fall down then put lid back on then spray less then before . Also every for days give light spray with algae extract using 1/4-1/2 the strenth reccommended .i throw away or just give away all the ones that root after14 days (they slow and possible infection) I hope this helps anyone needing clone advize
likes 3
