Mirra is her name

Hello, guys and girls! This time my setup has more potential for proper grow. Genetics: Actually, I don't know what strain is it 😂 Either LSD auto or Amnesia Auto from a custom breeder. Tent setup: Actually the tubes and corners are bad for this tent. I hoped I'd connect them tightly, but this one should be solder. I didn't want to do that, so I just used nail(not screws, they were too hard to screw in) and rubber. I can't say that construction is strong, it even started to fell side after few days, but if lean it against the wall, then it's better. A lot of 2 sided tape for the walls. I decided to make a custom one in order to economize. I spent around 40$ for tubes, corners and tools, and another 40 for the walls. This size tent would've been around 200-250$. But I definitely recommend to use proper tubes(a lot of videos on youtube for PVC tent) or wood sticks. Hydo setup: Last grow was in 10 liters bucket, I knew it wasn't enough. So, now I bought a bucket for 35 liters. Let's check this size, hope it wouldn't be too big. I'm not sure, it might be too big for hydro. I used lighter to make holes in cup and bucket. And knife heated on a gas stove to make a big hole for the cup itself. Cup has stones on the lower part and sided parts of it. And coco with perlite at the upper middle. I use the most simple and cheap compressor for 3watt. It cost 4$ or something in the zoo-fish store. At the begging of the grow it will be one compressor. I think I'll add 1 or 2 more by the mid of growing. Also this time I use air stones, instead of sponge filter.