First Time

1st Week: As my seeds didn't germinate, I decided to use a pack of White Widow. I've noticed that more fit in the closet, so I planted extra, planning to discard the weaker ones. I've started with very light watering, but today I gave them a good soak with a bit of Synergy from Grotek. I think the humidity might be a bit low, and I'll try to correct that. The first nodes have appeared, and in some, even the second. I won't start fertilizing until the 2nd-3rd week. Humidity: 45%-70% Temperature: 17º-23º

2nd Week Until today, since the last time, I have only done a good watering of 1.5 liters for all the plants (12). I have started fertilizing with 0.75ml of both Vitamas Pro and Solo-Tek Grow from Grotek. They are beginning to form their first nodes. 3-4 are lagging behind because they have experienced a bit of stress. Humidity: 60%-70% Temperature: 19º-24º

3rd Week I start with generous watering, 1L for the larger plants. I use Vitamas fertilizer at 1ml/L, Solo-Tek Grow at 2ml/L, Synergy at 0.15gr/1L, and Monster Grow Pro at 0.1gr/1L. Some are already at their 5th node, and soon I will perform apical pruning according to my plan. Conditions: Humidity: 55%-70% Temperature: 19º-24º 3rd Week Update. I perform apical pruning and remove the other nodes from certain plants. I fill the pots as much as possible to allow for the development of more roots.

4th Week. I make apical cuts and remove the other knots from the remaining ones. I haven't watered again since Saturday; I gave it a good watering, and the substrate remains moist. Humidity: 60%-80% Degrees: 19º-26º

5th Week. I make apical cuts for the second time, I prune. I have exceeded a bit with nitrogen, thinking that with coconut substrate, I would have a deficiency; I got a little carried away. I'm unsure whether to make more apical cuts, leave them as they are, or do one more. Humidity: 60%-80% Temperature: 22º-26º

6th week. I've done some low pruning. The excess nitrogen is diminishing. I won't make more apical cuts, and I'm considering how much longer to keep them in the vegetative phase. I've set up a mesh to attempt scrog. Humidity: 60%-80% Temperature: 22º-26º

6th week. There is no nitrogen excess anymore, but other deficiencies are emerging. I've started adding CalMag, and I think there might be an iron deficiency as well. I'm hoping someone from the forum could comment on this. I'm finding the need to water quite a bit; the next week will already be the flowering stage. I adjusted the distance of the light, which I think was too close, and raised it. Environmental conditions: Humidity: 65%-80% Temperature: 17.5º-24º Lamp distance: around 70-80 cm Plant height: approximately 65 cm Moderate odor

9th Week I'm trying to address the deficiencies, I believe it's due to using coconut substrate. I am gradually reducing the daily light exposure by 1 hour until reaching 12/12. As it's the first time with Delta 9 in the cultivation, I have trow it foliarly.

The buds are starting to form. The smell is strong when I open the cabinet, but with the filter, it doesn't smell. I corrected the deficiencies I had correctly. I defoliated a bit to allow good light penetration. I'll let you judge how they look now. I did a week of stretching, lowering the light by 1 hour each day.

6th week of flowering. The flowers are almost fully formed, they just need to fatten up and share. It's noticeable that they're drinking a lot of water and also that it's hotter than the previous months, so it evaporates faster.