This three girls lookin nice, buds are getting bigger now and they don't get higher.
Also no problems with them
In cause of don't cutting the one plant down, it is to high and towered above the led, it's annoying but I cannot change it, let's surprise 😅
Does anyone have experience with the Greenception gc9 LED? I bought a new one for my flowering ladies and want to know which circuit stages must be working.
Sorry for my english so far 😅
You want it to be both sprectrums on , there should be a switch on the unit to make both the red and blue diodes light up this is the setting you want it on for flower . Once your plants are done stretching I advise that you turn the blue off and only use the red diodes this will promote denser flower development . The blue spectrum is more less for growth and the veg cycle . I hope this information helps you with your new light !! -Happy Growing!
Looks good so far 😎👌
Next time I would recommend to top the other plant too✌️ you want all your plants at the same hight to place the light at the same distance to every plant☀️↔️💡
@InhaleXhale, yes of course 👍but let me say that i use 2x the gc4 and have no experience with the gc9. I run my lights with a distance of 45 - 35 cm, but i gues you can add 5cm for the gc9. I would start at 45cm and turn all lights on👍(you are already at flower stage) if they doing well you can go closer to maybe 40cm. (At my first grow i was used 30-35 cm and i had some light bleaching because i was to close).
General:
At spreeding stage i use about 40 cm and run the veg light only for the first 2 weeks. (Take a look at the temp of the light because the Active cool doesnt run (gc4, 9c9 idk))
Later i run only full spec. till i need the veg. light to cover the space.
After some weeks i run full power to provide enough light. (Doesnt mater if veg. or flo.)
At the last weeks of flower you can slowly move the light a bit closer (only ~5cm)