This week wasn't very spectacular. One branch snapped I don't know why, but I have to fix it. These buds are looking so awesome frosty and they have almost around 3 weeks until harvest. It's fantastic.
Does anyone have experience with the Greenception gc9 LED? I bought a new one for my flowering ladies and want to know which circuit stages must be working.
Sorry for my english so far 😅
You want it to be both sprectrums on , there should be a switch on the unit to make both the red and blue diodes light up this is the setting you want it on for flower . Once your plants are done stretching I advise that you turn the blue off and only use the red diodes this will promote denser flower development . The blue spectrum is more less for growth and the veg cycle . I hope this information helps you with your new light !! -Happy Growing!
Looks good so far 😎👌
Next time I would recommend to top the other plant too✌️ you want all your plants at the same hight to place the light at the same distance to every plant☀️↔️💡
@InhaleXhale, yes of course 👍but let me say that i use 2x the gc4 and have no experience with the gc9. I run my lights with a distance of 45 - 35 cm, but i gues you can add 5cm for the gc9. I would start at 45cm and turn all lights on👍(you are already at flower stage) if they doing well you can go closer to maybe 40cm. (At my first grow i was used 30-35 cm and i had some light bleaching because i was to close).
General:
At spreeding stage i use about 40 cm and run the veg light only for the first 2 weeks. (Take a look at the temp of the light because the Active cool doesnt run (gc4, 9c9 idk))
Later i run only full spec. till i need the veg. light to cover the space.
After some weeks i run full power to provide enough light. (Doesnt mater if veg. or flo.)
At the last weeks of flower you can slowly move the light a bit closer (only ~5cm)