StarLink

ShawarmaKing This run started with a careful, step-by-step approach to ensure the Starlink developed a strong foundation for vigorous growth and resin-rich flowers. After germination, I placed the seedling into my DWC system, providing consistent oxygenation and hydration to support root health. To avoid overwhelming the young plant, I began with a light nutrient mix of 10 ml total for the entire bucket, resulting in a starting TDS of around 150–170 ppm. As the plant settled in and began producing new sets of leaves, I monitored pH closely, keeping it between 5.8–6.1, and watched for any signs of stress. Seeing none, I carefully ramped up the nutrients: 15 ml, then 20 ml, and eventually reached 25 ml total as the plant’s uptake increased, with TDS rising in stages from 250 ppm to 500–550 ppm. To encourage robust root development and protect against pathogens, I applied Great White mycorrhizae, dusting it directly on the roots during a reservoir change. I also introduced Voodoo Juice at half strength initially, allowing the beneficial microbes to colonize the root zone before moving to full strength in the next feeding. As vegetative growth accelerated, I began supplementing with Armor Si (silica) to reinforce cell walls and thicken the stems in preparation for topping and training. Starting with 0.25 ml per gallon, I slowly increased to 1 ml per gallon, premixing it with RO water first to avoid precipitation in the reservoir. When the plant reached the right node count, I performed a clean topping cut to encourage lateral branching and create a fuller canopy. To allow lower shoots to catch up, I adjusted my light height slightly, encouraging even growth and mild stretching. Around this time, I began noticing a surprisingly strong terpene aroma coming from the plant—even this early in the veg cycle. Recognizing this as a sign of excellent genetic expression, I decided to introduce Purpinator earlier than most growers do. I started with 10 ml total for the bucket, gradually increasing to 25 ml, with the goal of priming the plant’s flavonoid and terpene pathways. The idea was to amplify aromatic potential and set the stage for vibrant colors and rich terpene profiles well before flowering. Alongside Purpinator, I added Bud Candy at 1 ml per gallon to provide carbohydrates and amino acids, supporting microbial activity and supplying the plant with additional energy during this critical growth phase. Now the Starlink is thriving: bushy, vibrant, and showing vigorous lateral growth. The early aroma is already impressive, and the gradual nutrient ramp-up combined with microbial support and early terpene enhancement has created the perfect conditions for a high-yielding, resin-packed flower cycle. I used the default veg, seedling setting in the ac infinity app keeping the light 14 inches away.

ShawarmaKing The following week things are going to get crazy

ShawarmaKing The following week we're going to be pushing the plant to its limits to its breaking point allowing it to thrive to its full genetic potential.

ShawarmaKing We had a mainline break and the clone is doing well so far so good but this main line break down the main stem with actually a blessing in disguise. Next week's post you will see all the new colas that were formed as a result of the stress induced here I will create an artificial knuckle using wire, masking tape and gorilla glue. The reason I will reinforce it is so that when I do high stress training again the split won't break open again.

ShawarmaKing So this week concludes all the high stress training that needs to be done now I just got to let it naturally fill up the rest of the tent since I already made a lot of new flowering sites and nodes it was a hard journey and I frankensteined a lot of this. I push the plant to the brink of what it could do. Broke a few branches along the way but I think it came as a blessing in disguise. So the plan right now is to stick with light befoliation for the next 7 to 10 days allow these new nodes to keep stacking and just let it grow vigorously I purposely pushed back the veg and prolonged it to the early veg stage as much as I could and we'll see the results.

ShawarmaKing If I let it veg untouched until the end of the month, I’d be setting myself up for a massive plant — especially in DWC. By that time, I’d likely see it fill the entire 2x2 tent, wall to wall, with thick branching and strong vertical growth. I wouldn’t defoliate or lollipop at all until right before flower. Letting it chill and do its thing would give it time to fully recover from any stress and bulk up naturally. The inner shoots that are shaded right now would likely push through the canopy on their own, and the weaker ones that don’t can be chopped later when I clean it up. By waiting, I’d have more bud sites, a stronger root system, and a fuller canopy — I’d just need to make sure the airflow is solid to avoid moisture issues. Once I decide to flip, I’d go in, do a proper lollipop, and start flower with a clean, strong structure that’s fully packed with potential. So yeah, if I do nothing and just feed and monitor it, by the end of the month I’d have a monster ready to bloom. So with the training clips removed. The clips were likely applying pressure at certain points on the stem or branches, which can slightly restrict vascular flow. The plant’s vascular system — mainly the xylem (for water and minerals) and phloem (for sugars and signaling molecules) — is responsible for distributing everything the plant needs to grow. However I think it was worth the trade off especially with the bonsai like structure I have created. These points are definitely woody for sure and they are definitely holding its shape.