hydroponic Dante’s Cherrycana

PrinceOfHerbs Now the cube has been placed in the middle of blue clay. Growth is progressing well and the water values are at 5.5 pH and a slightly elevated EC of 550.

PrinceOfHerbs Growth is progressing well, but some parts of the roots have slightly brownish slime (it doesn't smell), so the whole setup was cleaned and rinsed with HO2 and fresh water was added, and the slime was carefully rinsed off. Water values are at 5.5 pH and an EC of 800.

PrinceOfHerbs Growth is progressing well, but some parts of the roots still have a slightly brownish slime (it doesn't smell), so the whole setup was cleaned again and rinsed with HO2 and fresh water, and the slime was carefully rinsed off. The plant has been topped. Water values are at 5.5 pH and an EC of 1000.

PrinceOfHerbs The slime on the roots has been removed and things are progressing rapidly. After topping, four large leaves were removed to allow the lower shoots to grow. The pH is 5.6 and the EC value is 1200. VPD ist bei 1.1

PrinceOfHerbs The plant grows extremely bushy. This makes it difficult to tie the shoots down neatly. After defoliation, the plant is left alone for a few days to avoid stressing the flowers. And then the plant goes into flower

PrinceOfHerbs The plant is growing very well. The pH has been set to 5.0-5.5 and the EC value is 1700. The lamp has been turned up to 100% and an additional 15 ml of hydrogen peroxide has been added to the water to prevent algae or similar growths. A significant amount of leaf volume has been removed again to allow as much light as possible to reach the plant. Flowering day: 4

PrinceOfHerbs Everything is growing well, pH at 5.0-5.5 and EC at 1700. It was radically defoliated again and low stress was applied. VPD: 1.1 Flowering day: 11

PrinceOfHerbs The plant is growing very well. On day 21, lollipopping was performed and the plant was heavily defoliated. Flower buds and the first resinous areas are visible. Flowering day: 22

PrinceOfHerbs The plant is growing well and becoming increasingly resinous. A slight purple coloration is beginning to appear in the flowers. Flowering day: 27

PrinceOfHerbs The plant is extremely resinous and looks healthy, though the top leaves are slightly curled and stick out far upward. Ppfd 1200 and the lamp is 25 cm away, so everything is actually optimal. No other issues EC: 1.8 pH: 5.0–6.0 Days to flowering: 35

PrinceOfHerbs The plant is very resinous, and even the large leaves are full of resin. Unfortunately, the flowers don’t look particularly firm yet. Hopefully, they’ll become much firmer over the next 3 weeks. pH: 5.5–6.0 EC: 2.5 Days to flowering: 42

PrinceOfHerbs The plant looks incredibly good; the leaves are turning black and the buds are extremely resinous. The only downside is that the buds don’t grow very compactly. EC: 2.0 pH: 5.0–5.5 Flowering days: 51

PrinceOfHerbs The plant is now entering the final week of flowering; flushing will begin shortly. EC: 1.0 pH: 5.7–6.0 Flowering Day: 58

PrinceOfHerbs The plant is no longer receiving any fertilizer, except for a little CalMag. However, even this has been omitted over the last 2–3 days. As the flush progressed, the plant became noticeably stickier and is now using up its last reserves of fertilizer residue. EC: 0.15 in the last 2 days 0.0 pH: 6.0 VPD: 1.6 Flowering day: 65

PrinceOfHerbs The flowers are extremely resinous. You rarely see that much. But the flowers haven't become particularly compact. The aroma is good, and they have purple patches.