ZOASHI 🌈🫧 (Mother Plant)

Big_Terps ZOASHI MOTHER PLANT After finishing a pheno hunt with The Keeper (Zoap x Rs11) from Wizard Trees Genetics, I picked a particular phenotype and named it Zoashi because of its lovely soapy sherbet ice cream taste. I saved a few small buds on each phenotype after harvest and reverted them back to vegetative growth. Then once i knew which phenotype i was going to keep, i got rid of the others, and grew out the selected one until I could take healthy clones. When it wax ready to clone, I took nine clones—eight for flowering and one as a healthy mother plant for future runs. This diary will document the progress of the mother plant, which has been kept in a small 1L rhizo propagation pot will be transplanted tomorrow into an 8.5L Autopot pot equipped with an air dome, air base, and pot sock. To prepare for this move, the tank was filled with 10 liters of water, to which 30 ml each of Bloom B and Bloom A, 8 ml of CaMg, and 5 ml of Cleanse were added. After mixing well, the EC was set to 2.1 and the pH to 5.8. The plant received a nutrient feed of 250 ml, and the light cycle was changed to 18/6, set to turn on at 6:00 pm and off at 12:00 pm, with environmental controls adjusted as needed. Enviro Controller V2 Temperature - Daytime Temp : 24C - Nighttime Temp : 24C - Bandwidth : 1C Humidity - Day Humidity : 70% - Night Humidity : 70% - Bandwidth : 0% Dump Override - Lights On : 6:00pm - 6:05pm - Lights Off : 12:00pm - 12:05pm Fan Speeds - Min Speed Day : 80% - Min Speed Night : 80% - Max Speed Day : 100% - Max Speed Night : 100% - Negative Pressure: -50% Ext 1 Humidity - Humidity Day : 70% - Humidity Night : 70% - Bandwidth : -2% Ext 2 Heater - Temperature Day : 24C - Temperature Night : 24C - Bandwidth : -1C Daylight Lighting Controller - Power : 50% - Sunrise/Sunset : 30mins - Dim : 24C - Off : 40C On Day 2, the plant was moved to an 8.5L Autopot square pot that had a potsock, air dome, and air base. It was filled with Ecothrive Pro Coco + Charge, and after the transplant, I added more media around the plant. The Autopot tray was set up and connected to the tank, with the airdome attached to the air pump. Next, I checked the pH of the batch tank and made adjustments as needed. I topped the newest growth and removed large fan leaves that were blocking lower branches. Then, I watered the plant with 500ml of plain water, activated the system, and carefully looked for any leaks. After ensuring everything was working well, I closed the tent. Day 3 :