Chat
RecommendedRecommended

budnet aeroponics

2
13
5
1325
5 years ago
Follow
2
Grow Conditions
Week 1
Vegetation
16 hrs
Light Schedule
19
°C
°F
Day Air Temperature
11+ conditions after
Login
Nutrients
ml/l
ml/gal
tsp/gal
1+ nutrients after
Login
Commented by
zerobane zerobane
5 years ago
kicking off 2nd grow with 2 clones of ak47 and 3 green crack seedlings. Using growplugs with rockwool to seal the grow pots; full high pressure aero system; 4 nozzles @50microns per container. Cycle time: 7 seconds on / 5 minutes off Some minor nutirnet burn on tips at 400ppm; might drop res to 300ppm for week 2. Bottom of containers are showing 550ppm before run off to res, which signifies more water is being absorbed then nutrients.
Similar Diaries
Lemon cherry cookies
11 weeks
Lemon cherry cookies Auto_lover
Lemon Cherry Cookies Auto
7 minutes ago · 9 comments
Purple Punch Auto
3 weeks
Purple Punch AutoOwopper
Purple Punch Auto
11 minutes ago · 2 comments
Green crack auto (i saved this girl)
4 weeks
Green crack auto (i saved this girl)Slurpalurpa
Green crack auto
2 years ago · 4 comments
Northern lights auto RQS
4 weeks
Northern lights auto RQSbalahsehde
Northern Light Automatic
2 years ago
Smoothie
19 weeks
Smoothie420medic
+2 strains
a year ago · 8 comments
Cookies Gelato Automatic
7 weeks
Cookies Gelato AutomaticAutoGrowUk
Cookies Gelato Automatic
2 years ago · 3 comments
Big bud auto
13 weeks
Big bud autoRytmause
2 strains
2 years ago · 5 comments
Bruce Banner Auto
10 weeks
Bruce Banner AutoB_g83
Bruce Banner Auto
2 years ago · 7 comments
Grow Questions
zerobane
zerobanestarted grow question 5 years ago
Leaves are fanning upwards and undergrowth is huge in flowering phase. Should i be worried about the upwards fan, should I trim on this point or just leave as is and just remove dead leaves?
Solved
Leaves. Curl up
like
DWCHC
DWCHCanswered grow question 5 years ago
When mine get to this point, I deleaf anything that doesn't have trichomes showing or are laying ontop of another bud..the flower auxins are in abundance and allowing a higher par down deeper into the canopy can really help out lower bud development. One rule I follow is to avoid removing more than 30% of the canopy on any day, usually followed up with a light nute application and a few days rest before another selective deleaf. To this end, I've reduced workload during trimming and have had less popcorn buds. On a side note, resin production is a defence mechanism of the plant to discourage browsing by pests. When the right amount of leaves are removed, the plant will respond with an increase in resin to counteract the browsing.. I don't know of any science study's that have been done in this area, but my trials have shown a noticable difference.. Cheers
Comments
Login

Show by Week
Sort by
popularity
popularity
newest
oldest
Ferenc
Ferencweek 2
Nice system mate @zerobane
zerobane
zerobaneweek 9
Thanks @dwchc and @Cannibalgardens Harvest in next 48-72 hours pending time with holiday; i'll update the journal with results. I did 2 experiments for this grow that support both comments. Keeping a consistent canopy seems key for yields, i'll go little more "cutty" with reducing canopy towards middle of bloom to increase light on next grow and run a control with no canopy cutting as a test. 1. the green crack on right side - 1 plant no trimming, 1 plant moderate, 1 plant heavy trimming throughout grow to keep a solid canopy. I'll weigh out results, but so far the the heavy trim is showing the largest colas. 2. The left side is the ak47 - it has 1 clone growing in back and 1 re-grow on same plant that was harvested on my first grow in front. Curious to see the yields and strength on re-grow. One thing I did notice was the nutrients starting spiking on return res; 800 on feed / 1200 in return. Even when i dropped to 200 for flush, the return was still showing 600-700ppm. Interesting; not sure on the "why" or what nutrient is coming back at such a high level.
CRiSPrGrow
CRiSPrGrowweek 1
"Cycle time: 7 seconds on / 5 minutes off " for the top feeding right? very informative 👌
CRiSPrGrow
CRiSPrGrow
@zerobane, very interesting !
zerobane
zerobane
@CRiSPrGrow, Thanks! Will add more info on setup for week 2. Using a mistking repeat cycle timer; the 7s-on/5m-off is the spray cycle for the aero nozzles. The aim at top of rootzone and spray a 50 micron mist.