Likes
Comments
Share
@DevilsBud
Follow
Marshydro supported grow Spliff Seeds CBD Spliff Berry/Afghani Gold Anesia Seeds Hyper Glue/IMPERIUM X/Captain Future/Blackberry Moonrocks All strains except imperium x/blackberry moonrock are topped and the main got LST clip on i snapped a Branch off one of the hyper glue by being to Hasty the other ones where no problem good week for the 9 plants A update of using the new marshydro set-up The FC-4800 is a absolute beauty of a beast the change from growing under a marshydro TS-1000 to a FC-4800 is night and day nothing bad about the TS-1000 it deliver me a great first run with 4 plants absolutely amazing lamp to start with no doubt . But since i am growing 9 now and soon maybe 12 the FC-4800 will for fill that task with no problem what so ever 💪🏻👌🏻 Marshydro gets your bud's frosty and reaching for the ✨ Also the new 120X120X200 tent Is of class of it's own bin growing in a 100x100x180 tent and has worked fine and will stil be used for plants that are en early grow stages together with the TS-1000 . The 120x120x200 makes everything much easier for me and my back 🤣 the 2 side holes now where I can reach the back for my grow 🤘🏻🤘🏻 Also the space i have now is great for the amount of plants i will be growing i am loving it visit www.marshydro.eu for your best gear and use the PROMO CODE: DEVILSBUD Some info about the Marshydro FC-4800 Superb Quality LED Chips: The whole light is composed of 1206 pcs Samsung lm301b and Osram 660nm chips. More than two times as many LEDs are used to drive the grow lights at low currents and to avoid overdrive. Quality is guaranteed and efficiency is up to 2.8 μmol/j. Even PAR Distribution and High PPFD Output: The multi-light bar design and the densely distributed light chips enable the LED grow lights to achieve the optimum PPFD required for plant growth over the entire effective coverage area. Specifically Designed Spectrum: To ensure even plant growth, blue and red light are enhanced on the basis of a full spectrum combination. Not only does this accelerate plant growth, but it also improves the yield and quality of the plants at the same time. Dimming Daisy Chain Function: The dimming function saves on electricity costs and enables brightness from 10% to 100% for the different stages of plant growth. A single master light can connect up to 30 lights in a daisy-chain system. Business LED Grow Light: The light's wavy heat sink dissipates heat quickly and the IP65 waterproof allows the light to operate in humid conditions. 180° collapsible feature for easier installation. All these features provide favorable assistance for commercial cultivation. And some tent info ●【Lock All Light Insid】MARS HYDRO Grow Tent Interior is made of diamond mylar. Non-toxic to the environment, no harm to plants. High-quality 1680D canvas being double stitched, (ALL OTHERS BRAND grow tent is 601D canvas) which is tear-proof for perfect light locking, No light leaks or rips at all. ●【Durability Grow Tent】Stable Metal corner adapters and poles are the trustful supporters of the tent. No rusting nor paint-falling. Quick easy tool-free installation. Carries strong heavy-duty SBS zippers, double layer lining to create a light-proof seal. ●【Easy Observation of your Plants】Special peeks window made by double layers of cloths. Observe the growing conditions of your plants without opening the tent and avoid disturbing plants. The peek window also serves to dissipate heat and ventilate air. ●【Removable Tray Keep Clean】The package includes a removable waterproof floor tray to hold soil and fallen leaves. The tray can be taken out easily to wash. Removable and water-proof makes cleaning easy. ●【Good Ventilation&Fast Assembly】 Circular double-sleeved vent holes with adjustable nylon strap for air circulation by exhaust fan, ducting, carbon filter, or reflector. Better allows proper light, heat, and airflow. Quick tool-free installation. Reinforced by a sturdy metal frame to ensure security and stability, supports up to 140lb. Perfectly safeguard your plants to thrive even in winter
Likes
31
Share
En la semana 13 de floración he retirado algunas de las hojas amarillas que se alojan entre los cogollos, que están muy compactos por cierto, y al haber pasado por una sobrefertilizacion las demas hojas se quiebran con facilidad por eso van a observar algunas hojas algo rotas, pero los cogollos están bien,, duros parecen rocas😅💪. Con respecto a los nutrientes los he reducido al mínimo. Según el banco son 17 semanas de floracion(estamos comenzando la semana14),asique ya falta poco, espero con ansias ese momento😅😅🤞🤞🚀🚀🚀😎😎😎
Processing
Likes
9
Share
@Kushizlez
Follow
Day 69 (March 6th) Just gave everyone their last watering. I’m going to harvest and wash everything tomorrow night on day 70. I‘m not going to do that whole 48 hours of darkness thing because I didn’t see a difference last time I did it. In fact, it made my plant under watered before drying which caused it to dry too fast. Slurricane and cheese will be washed with h2o2 and the rest will just be rinsed off in warm RO water and hung up. Before and after washing I’m going to go over each branch with a flashlight and make sure there is no dog hair or debris in or on the buds. I will be drying in my spare bathroom (that no one uses!) from hangers. Aiming to keep it around 60-62F and 50-60 RH. Hoping for that 10-12 day dry. I wanted to do a full plant hang but the tent got pretty dirty and I would feel more comfortable just cutting and rinsing everything off branch by branch. I’m going to try my best to keep the full plant intact. Got my humidifier hooked up and running RO water because with tap water it deposits calcium and lime all over the buds and walls. For air flow I’m just indirectly running a small usb fan. I’m not worried about air flow in the bathroom honestly. It stays nice and breezy down there anyway. Got the food grade peroxide and RO water to wash up the slurricane and cheese. Everything except for the cheese and garlic#1 is looking more than done. Trichomes all look pretty well done. Some of them have even burst open. Smells are all super ripe and mature too. Can’t wait to smell each individually in jars. Next week I will recap what went wrong and what I will do differently next time to keep it from happening again. (Day 70F) Just got everything chopped, washed and hanging. The vast majority of the PM was washed out but I can still see very small amounts. When they dry out I can shake the branches a bit to get the rest off. At very least it’s sterile now. There is no question I lost some potency while washing but the amount is negligible for a much cleaner product. I could see lots of dirt and other debris float to the surface of the water after being washed. And no those are not trichomes, those sink to the bottom. I could put that nasty water through a bubble bag and wouldn’t get all that much. Although it probably does remove a lot of the actual trichomes heads. I’ll have to check with the microscope. Everything is rigged up for a nice slow dry. Temp is sitting at 64 and RH is at a nice 60%.
Likes
9
Share
@420Guru
Follow
Iv added the Coco Coir Pellets into my net cups and covered them with clay pebbles. 1 layer of clay pebbles under the Coco Coir Pellets first.
Likes
52
Share
Week 8 night fro day 1 in to day 2 and all is going as planned 😁 i broth down my lights to a 50% power, this gives me a 500 ppfd, also reduce the shedule to 9h light. Hoping for great medicine on this run 🙏 5x White Mango WM 5x Alasken Purple AP 4x Blueberry BB 3x SAD S1 2x Badazz Cookies BC 19 in total for a 4x8x6 - 1,2x2,4x2 Light Lumatek Zeus 465W compact pro 2x at 50% All i Grow is medicine for myself, Stay safe, stay tuned and B Happy and do it for the love Peace ✌️ D
Processing
Likes
12
Share
Likes
10
Share
@MG2009
Follow
03/16/2022 All progressing well. We are at 12 + hours of light will not suffer any set back from revegging, fingers crossed. For a girl. Day # 6 updating early this week.
Likes
2
Share
Its now week 3 of flower and the budsides are growing and showing their beauty and smell and at the end of the week is lollipopping on the Menu. There aren't any signes of lacks in nutrients. I found one yellowish leave but I'm pretty sure that was my fault for leaving the Soil a little bit to dry for some days.
Likes
Comments
Share
First upload on my grow diary about this little auto. I’ve started this experience twenty day after first seeds popped of another regular in the same box, now i know that’s wrong but... now 🤣 so other error was trasplant late and other not correct situations that i will explane in next updates about early life of it, this is the result at 7/9 weeks of life , a little frosty girl
Processing
Likes
52
Share
Day 37 - Hitting the ladies with a little LST. My cloner project took a bit of a backseat to life, so I'm a little late in the game to top these babies.... So I decided I'm going to do something I have never done before.... Let these plants grow naturally. Yeah, you read that right, I've never let a plant just grow out without some sort of fun training technique. Even my very first grow was riddled with aggressive plant shaping. This time will be different! This time I will be just doing some very basic LST to open up their branches to more light. I went in and stripped some of the inner growth sites that would have produced nothing but popcorn buds being so hidden from light. I then created anchor points around the grow bags by pushing toothpicks through the holes in the mesh. I like this because it gives me the ability to easily move around anchor points by simply sliding out the toothpicks and moving them where I please. I got the idea from seeing someone else use pushpins once, but I didn't have any on hand. And so, the toothpick hypothesis was born, and so far its working very well! Both ladies look much happier now that they're getting more light to their branches. The leaves on these Blazin' Skywalker plants are just so effing fat that they've been doing a solid job at blocking light to the branches. I tried doing some leaf tucking early on, but the branches just weren't quite long enough for me to properly tuck the leaves behind them and would constantly come un-tucked. I think we've found our happy place. 😊 Thanks for hanging with me, growmies! I hope y'all have a crazygonuts awesome day! ✌️💜🌱 Day 41 - Watered Maz with some 6.5 pH water. She had gotten a bit over watered so I let her go a few extra days between watering. The next morning, she let me know I did the right thing. 💜
Likes
9
Share
@Headies
Follow
So I had a few issue. I over watered early on, took them out the seed tray early, started feeding them a week or two late, no humidifier yet but they recovered well.
Likes
42
Share
@rhodes68
Follow
1/17 Week 10 and wow Ok girls are doing well not a worrisome issue to be found unless its space. Brought Dink to the Flowering tent put Bambi in the Auto tent Dink is a very WIDE plant and thats a problem in the 4x5. Dropping Koolbloom for a while in favor of Peak, its better its expensive but Pussy has gotten to the point of fast building so bringing it in. Octo, Solitaire, Chew Mee and Plenty will benefit well. Pretty much everything else as it was last week no serious changes to nuets. We decided to go with 6 clones instead of the 9, we need a break and this keeps us under the plant limit. 1/19 Dropped Bloom 10% for Flowering plants Reset the auto tent for easier access Clones now in the 3x3