Likes
Comments
Share
Super pumped to try it out, reminds me of when I was a teenager. 🌱😎💨
Likes
27
Share
3/25/2023 Week 6- Day 1 of Veg (Day 52 overall) Added my first between changes SILICA Top offs. Was worried that when you add it to pre mixed Nutes that it can make the whole thing turn into a gummy looking substance. I was ready to drain the system and start it over for the week if needed, but no issues adding it to the tank. the Silica going into the Res didn't gummy the system up, it did drop my PH by quit a bit causing me to have to bring it back in balance. 36 Gallons in the Tank Silica Add .5mil/Gal = 18Mil I topped some that needed to be topped, I defoliated some that needs to be defoliated. Since I have moved into Week 6 I have increased the light intensity up to just over 500 maxing it out for Veg Cycle. Next increase will be Week 1 of Flower. 3/26/2023 Week 6- Day 2 of Veg (Day 53 overall) All conditions looked great. Other than me not putting one of the humidifiers back right which means it didn't work last night so Humidity was lower than I like. But got the Humidifier back on it's stand correctly and it is now pumping away. With that I decided to give the plants a day off from any stresses, no topping, no FIMing, no Defoliation for today. Just some good old soaking up the light rays and the ability to get all the Nutes they would like.. 3/27/2023 Week 6- Day 3 of Veg (Day 54 overall) Looking kind of Bushy today, so I defoliated some, and topped some. 3/28/2023 Week 6- Day 4 of Veg (Day 55 overall) PH was a little lower than I like 5.74 so I added a few Mil of PH UP and brought it back up to 5.94. Not much else at this stage, just I topped a little and I defoliated a little. 3/29/2023 Week 6- Day 5 of Veg (Day 56 overall) Topped a little, Defoliated a little Watched them grow!! 3/30/2023 Week 6- Day 6 of Veg (Day 57 Overall) Main action today was breaking down my old tent and setting up a new tent and getting my second RDWC system setup and ready for clones. I Topped a little, I Defoliated some and started taking a good look at what I would like to take for clones in the coming days. I have a few bottom branches that look every promising for my clone material on each. 3/31/2023 Week 6- Day 7 of Veg (Day 58 overall) #3 is at 16" Tall #2 is at 13" Tall
Likes
10
Share
@Kirsten
Follow
💚 ORION LIQUID NUTRIENTS 💜 3.6.25: I watered with 2ltrs of dechlorinated water PH'd to 6.3 containing the following nutrients; ♡ 1/2 TSP Cal-Mag ♡ 1/4 TSP Mega Crop Part B PH: 6.3 PPM: 1300 Plus an additional 2ltrs of dechlorinated water PH'd to 6.3 containing the following nutrients m; ♡ 1/2 TSP Cal-Mag ♡ 1/4 TSP Mega Crop Part A PH: 6.3 PPM: 1000 This week has shown some good progress, and we are now in flower and in need of more nutrients, so I'm trying my best to adequately feed. Adding in the Mega Crop Part A now regularly from now on. I'm hoping to see some better growth coming in next week. Thanks for stopping in this week 💚🙌🍃😊🌱✌️
Likes
28
Share
Sorry for the late post had a very busy period. The buds are great, good feedback from patients. First time I've been able to taste a fully organic bud and I can say I won't be going back!
Processing
Likes
20
Share
@Tikihoofd
Follow
After the repotting at the end of week 4, I watered my plants for a couple of days only using water (day 31 - 34). On day 34 I added some small LST cords, and watered. On day 35 I switched my lighting schedule from veg. to flowering, and watered. On day 36 I watered with nutrients. On day 37 I watered. On day 38 I defoliated and watered with nutrients. (The amount of nutrition used this week is combined at the top for the 3 plants.) During defoliation, I cut the inside looking leaves, and the big overhanging sugar leaves. Here and there I also cut some new growth on the inside of the canopy because it wasn't getting enough light. I noticed a very small amount of leaves which was yellowing on the bottom of the plant and cut them aswell. These we're from when the plant was just growing. All in all, things are looking good. Still searching for a solution for the trellis, because the things I came up with weren't cutting it. Probably going to fix one from PVC-piping. See ya!
Likes
144
Share
@DevilsBud
Follow
New week for the 7 strain 11 plants grow Everything is going great some little things here and there but nothing to be worrying about so i am happy how it goes one plant had balls and couple have some droopy leaves on them but have feeling my temp is way to low in darkness 16/3/22 I always show the good the bad and the ugly made couple mistakes wiles training but luckily these plants are so strong give some support and the branch that broke will fixes here self 💪🏻 Will be updating Tru the week And remember just grow weed and stop growing bullyish behavior visit www.marshydro.eu for your best gear and use the PROMO CODE: DEVILSBUD Some info about the Marshydro FC-4800 Superb Quality LED Chips: The whole light is composed of 1206 pcs Samsung lm301b and Osram 660nm chips. More than two times as many LEDs are used to drive the grow lights at low currents and to avoid overdrive. Quality is guaranteed and efficiency is up to 2.8 μmol/j. Even PAR Distribution and High PPFD Output: The multi-light bar design and the densely distributed light chips enable the LED grow lights to achieve the optimum PPFD required for plant growth over the entire effective coverage area. Specifically Designed Spectrum: To ensure even plant growth, blue and red light are enhanced on the basis of a full spectrum combination. Not only does this accelerate plant growth, but it also improves the yield and quality of the plants at the same time. Dimming Daisy Chain Function: The dimming function saves on electricity costs and enables brightness from 10% to 100% for the different stages of plant growth. A single master light can connect up to 30 lights in a daisy-chain system. Business LED Grow Light: The light's wavy heat sink dissipates heat quickly and the IP65 waterproof allows the light to operate in humid conditions. 180° collapsible feature for easier installation. All these features provide favorable assistance for commercial cultivation. And some tent info ●【Lock All Light Insid】MARS HYDRO Grow Tent Interior is made of diamond mylar. Non-toxic to the environment, no harm to plants. High-quality 1680D canvas being double stitched, (ALL OTHERS BRAND grow tent is 601D canvas) which is tear-proof for perfect light locking, No light leaks or rips at all. ●【Durability Grow Tent】Stable Metal corner adapters and poles are the trustful supporters of the tent. No rusting nor paint-falling. Quick easy tool-free installation. Carries strong heavy-duty SBS zippers, double layer lining to create a light-proof seal. ●【Easy Observation of your Plants】Special peeks window made by double layers of cloths. Observe the growing conditions of your plants without opening the tent and avoid disturbing plants. The peek window also serves to dissipate heat and ventilate air. ●【Removable Tray Keep Clean】The package includes a removable waterproof floor tray to hold soil and fallen leaves. The tray can be taken out easily to wash. Removable and water-proof makes cleaning easy. ●【Good Ventilation&Fast Assembly】 Circular double-sleeved vent holes with adjustable nylon strap for air circulation by exhaust fan, ducting, carbon filter, or reflector. Better allows proper light, heat, and airflow. Quick tool-free installation. Reinforced by a sturdy metal frame to ensure security and stability, supports up to 140lb. Perfectly safeguard your plants to thrive even in winter
Likes
12
Share
@Hempcules
Follow
WEEK 12 It was very warm this week for my OG Kush. Some leaves have lost a bit of color, but overall the flower production is progressing well. By now, all of the many large shoots are completely covered with big buds. They’re slowly getting larger, but they still have a long way to go before reaching their full potential. This phenotype takes its time during flowering, but it will certainly deliver an enormous yield. I’m really curious to see how that turns out. The plant is receiving and needing quite a lot of nutrients. At the moment, everything seems to be working reasonably well, and I hope the last few weeks continue like this. PPFD: 1000µmol/m²/s Water: 3x water 2x nutrient solution Vpd: 1,8Kpa
Likes
3
Share
@InsideAz
Follow
It’s been over a month of cure and I’ve been dipping into the stash frequently. Love this strain as a mid day smoker or even morning times. It produces a strong but not overpowering cerebral high allowing you to go about your day as planned, just in a better perspective. Very creative enabling and hyperfocus inducing Smells very sweet and berry like, seems strain review for a few more details
Likes
7
Share
@Nikkov
Follow
well, another week and just watering as needed, it should have yielded a lot more this strain is also not known from a local seed bank but no problem. I think the temperature, because I spent most of it being very hot, didn't let them grow, well, but I'm already starting another cycle and soon I'll start posting more here in another grow =D
Likes
2
Share
@TOMI08
Follow
Sziasztok 9.héten vagyunk A sütinek adok melaszt+canna flush Az ak47 valami szörny imádom
Likes
12
Share
@Hawkbo
Follow
Gotta get a transplant soon but its healthyish so far
Likes
4
Share
There was a very high heat wave in my country! For the past week we had 40 ª Celsius during day time and 30ª during night time. I lowered the led potency to minimal settings and it workerd really good. The strais are the same and it is really easy to see the differences between them.
Likes
54
Share
Likes
6
Share
Finally we are done, I spent one 10 months on Durban Poison, this is my best sativa strain and im absolutely in love. So next report will be with some Clones of Durban Poison.
Likes
6
Share
@lOlympusl
Follow
Everything went smoothly. Just have a little bit of water around the root every other day or so. Gradually giving more as it grew and the soil dried out.
Likes
2
Share