Recommended
Likes
3
Share
Likes
13
Share
@Droot
Follow
plants are going to be too big. i will have to figure something else out because i havent done any LST or anything to get them to stop,i wanted to see what they look like completely natural . i will probably angle the light and supplement the blurple light on the other side, and just turn the plant a couple times a day. if you have a better suggestion let me know
Likes
4
Share
@pzwags420
Follow
On day 1 I changed out my reservoir. I lowered my nutes to 650 ppm(25% reduction). I adjusted the PH down to 6.1. My left plant has some burnt tips from either PH shift or over fertilization. My hope is that the lower ppm will help to resolve the issue before it spreads. On day 2 I adjusted the reservoirs PH from 6.3 to 5.9. On day 3 the reservoirs PH is 6.0. I installed my new 200 watt HLG Rspec. I adjusted PPFD readings to 700-1300 PPFD on all tops. On day 4 I adjusted the reservoirs PH from 5.8 to 6.2. On day 5 I adjusted the reservoirs PH from 6.4 to 6.0. I diluted my nutrients in my reservoir by removing one gallon of nutrients from the rez and and adding 2 gallons of straight tap water to the rez. This brought the nute concentration from 770 ppm to 540 ppm as the plants will be entering the ripening stage in a few days and they have too much nitrogen judging by the extremely dark green leaves and burnt leaf tips on some branches of the left side plant. The buds seem slightly smaller then my last run which may be due to an excess of nitrogen and maybe not enough light as some of my tops are taller then the others making proper PPFD challenging. All in all the girls are coming along nice and I look forward to the final weeks of flowering 😀 On day 6 I adjusted the reservoirs PH from 5.9 to 6.2. I think I have halted the nute burn as I haven't seen it progressing any more on the leaves. I will continue to monitor closely during these final weeks. The trichome production is increasing with some trichs on top of colas starting to go cloudy. The pistils are turning brown with roughly 40-50% are turning brown all signs I'm getting closer to the harvest window 😆. I dimmed my light to give 600-1000 PPFD to tops. On day 7 I reduced my temps to 75 during the day and 68 at night. I adjusted the PH of the reservoir from 6.6 to 6.1. My reservoirs ppm was too high so I diluted the rez with 2 gal of tap water. This brought it down to 480ppm. The average ppfd to all 14 tops is 604 with no top receiving more than 1000 ppfd
Likes
16
Share
@Dunk_Junk
Follow
14cm vertical growth this week! Absolutely monster fan leaves.
Likes
103
Share
@Fatnastyz
Follow
3-24 Silica 1.5, cal/mag 6, micro 6, flowers 6, frost nugs 3, green sensation 1.5, slf 1.5, drops 1.5 ppm in 710 ph 6.0 Runoff 1375 ph 6.9 She still rockin 🤘 3-27 6ml cal/mag, 1.5 ml slf-100, 1.5ml drops of balance, 1/2 tsp recharge. She will get a full feed, next feed. Gave recharge b/c she only got cal/mag, so why not do some good while washing out salts. Ppm in 325 ph 6.0 Out 995 ph 7.0 See how she do 😁🤘
Likes
13
Share
Week 14, Week 14 was the last week before Harvest/Havrest! I flushed the plant and trimmed her a bit before harvest. I hope you all enjoy the videos and the pics!
Likes
20
Share
i was away from week 4 - 6, they have been only watered 3 times and sprayed couple of times, was also first time leaving them outside thru the night and strong winds. Some more aggressive LST and first serious defoliation, they needed a week to really start growing again, then they exploded,
Likes
17
Share
This is my first grow, felt like now is the perfect time to start. 😅 Picture 1 - The plants will have a 24h schedule with both sun and LED light. The solution with the cloth in front of the window is only temporary, I need something thats easy to pull up as soon as the sun comes out. My light is about 16in/37cm away from the plants, please let me know if its too close or too far away from the seedlings. Up until this point I germinated both the seedlings using one of those 'Easy Start' Kits with Microorganisms, I then just transplanted both plants with the soil still attached to them in the final pots. I am using Bio Bizz Light Mix for the soil. In about 1 week I will start adding the fertilizers, I will go with about half of what it says on the nutrient schedule because these are autoflowers. Picture 2 - Day 1 - Seedling number 1 is looking healthy. (I think?) As you can see I put a hygrometer next to it so I can monitor the Humidity and Temperature levels. I currently have a humidifier running next to the plants and humidity levels seem to be good so far. I read online between 65-80% are good at this stage. Picture 3 - Day 1 - Seedling number 1 again. At this stage I only water around the plant and dont soak the whole pot, I read that soaking the whole pot while the plant is this tiny can overwhelme the plants. I also noticed that the leaves look kinda yellow-ish? Please let me know if thats normal. Picture 4 - Day 1 - Seedling number 2. I need help with this one I dont know why but he doesnt look good, from the beginning he was much slower than plant 1 and when he finally popped out he looked like he was dying, he is kind of gaining a little bit of color now again but I dont know if he will make it. If you know whats wrong with him please let me know. I hope he opens his two little leafs soon. I still have a third seed laying around so please let me know if it'd be smarter to just abandone number 2 and germinate a new seed. Thanks for reading this far and I'll update as frequent as possible. Day 1 Issues Update - After taking a look at seedling number 2 again and seeing that after all this time it still didnt show any progress, I noticed that one of the two first leaves is actually cut. I mustve damaged it while inspecting earlier because I, (stupid newbie move), touched it too much or whatever. Now germinating my last seed in hopes that all goes well. Since I dont have anymore 'Easy Start' kits im going to try a different germination method, I will put the seed in a cup of water with a piece of cardboard on top of it overnight (12-15h) and then plant it into the moist soil afterwards. 😄 Picture 5 - Day 2 - Seedling 1 is still doing fine. In the morning the temperatures went up a lot (29 Celsius), due to the sun shining a lot through the window, and the seedling was showing slight signs of heat stress (Leafs going up and small yellow-is tint), I then opened the window and the Temperatures quickly dropped back to normal (20-23 Celsius). Moisture levels seem lower than yesterday and Im not sure why (probably because of the heat and opening the window?), still at a solid 62% tho so Im not too bothered. Picture 6 - Day 2 - Since my last Seedling 2 died I germinated another one, I put it in a glass of water over night (~15h) and then planted it into the soil. Hopefully it'll pop out in the next few days... 💪 Picture 7 - Day 3 - Everything looking good with Seedling 1, I kinda felt like it was sort of streching too much instead of growing its leaves, so I put the light closer to it. I will water again tomorrow, the last time I watered was when I put it in the soil 3 Days ago. Picture 8 - Day 3 - The new Seedling 2 is still germinating and will hopefully pop out of the soil in the next few days. Picture 9 - Day 4 - Seedling 1 still going strong, leaves are praying but I read that that is a good sign. I watered both pots again today with just Ph-water, will add fertilizer in about 3 days for seedling 1. Seedling 2 is still germinating, will post a new picture as soon as it pops out of the soil. 😉 Picture 10 - Day 5 - Seedling 1 looks healthy, but is going kinda slow. Turns out I had the light far too high... 😐 Pulled it as much down as I could now and its already growing better! Main indicator for not enough light was the stretching and the thin leaves. I will probably have to invest into a bigger setup as soon as flowering hits. ✊ Picture 11 - Day 6 - Seedling 1 leaves are getting bigger and the next set is already on the way. Picture 12 - Day 6 - After 4 days germination, seedling 2.1 finally popped out the soil! 👏 Picture 13 - Day 7 - Seedling 1 leaves seem a bit curled up, probably because of the hot sun this morning, Im not too worried tho. Will water with nutrients the first time tomorrow. Picture 14 - Day 7 - Seedling 2.1 looking fine, soil was pretty dry so I watered it a bit with ph water.
Likes
19
Share
Hey. Plants are growing fine. 🌿 Gave Nematodes on veg day 9 to prevent mourning mosquitos. I'm spraying Canna Rhizotonic twice a day. Conditions are pretty good so far, no problems. 👌 Should be ready for flower next weekend. 🌞 Stay green. 💚
Likes
47
Share
Going well except for the cbd critical cure. Few brown spots. It should rebound with nutes added at 1/8 strength.
Likes
31
Share
@HeyJude
Follow
In week 6, began fuller buds and the odor is much higher, I would recommend this genetically preferred carbon filter.Also the plant produces very nice resin and grows very fast (average autoflower 2 times faster)
Likes
9
Share
@MG2009
Follow
11/07/20 Was gifted a (It's MENDO DOPE) She has been sexed but not sure what pheno, but they're all good. Going to veg for a week then flip to 12-12. Ps. Took some clones for saving this is some crazy terpy shit!😍 Clones are on 12-12 schedule, in my experience they will root faster this way. This girl is potted in big roots soil and its time to pot up and flower.She is in florecent light tent for one more week than to LED to finish her off under11-14 schedule. Ps. Clones are looking happier than first pic 5 days ago.
Likes
7
Share
Getting close to harvest, maybe one or two weeks more. I had some powdery mildew starting on one plant so I cut those out, drying them now.
Likes
50
Share
@AsNoriu
Follow
Day 60 since seed touched soil. Joe is going okeish. Smallest from all by height, some branches stayed in first level of scrog only .. Still see signs of magnesium, thinking to load 200ppm of Epsom salt with next watering. Watered girls yesterday. Thinking to do heavy bottom clearing today. Dropped idea of third scrog level. Girls are secured enough and i dont want to loose access totally. Running out of height ... Distance to light- around 20-25 cm. Mars TSL2000 works just fine, with open window i keep day temps in 22-24 range. Took down all LST, cleared bottoms. Took a bit of leaves from top too. Very lanky, leafy, some tops didnt want to go higher, looks weak as producer, but all reviews are amazing about taste, so hopefully this will compensate ;))))) Day 62. All run, Joe stays low ;)))) Happy Growing !!!
Likes
1
Share
This Blue Dream’Matic from 420 Fast Buds is on the same timeline as my Purple Lemonade Auto. We’re entering week 10 from seed. I haven’t topped this one unlike the Purple Lemonade . Been a pleasure to grow. The smells are amazing, trichome production has been great , and the buds have been getting pretty thick! Definitely one of the stickiest plants I’ve handled. No complaints with this strain. I’ll post a harvest post next week or so once they get chopped down. Thanks for the progress follow! 🤘🏼
Processing
Likes
21
Share
March 7, 2019 update: These babies are doing great! I plan on transplanting 6 plants and moving them into the flowering room this weekend. As of right now my plan is to move 1 DinaMed CBD, 1 Medi Kush CBD and 4 Cherry Hemp plants into flower. I'm going to pick the largest/most developed plants for the move. Then I'll keep the rest in veg for another month, next month I'll pick the next 6. I'd like to get the plants on a monthly rotation so I can be harvesting monthly.
Likes
17
Share
@4chuk
Follow
Oct.16 - Week 2 begins. I need to stop editing my diaries high. Oct. 18 - Looks like a slight calcium deficiency on the oldest leaves, I'll watch the newer leaves for spots before I increase CaMg though. Oct. 20 - I have been watering with 20ml twice a day, growth rate seems to have increased, but still developing spots so I will increase CaMg today. Oct. 22 - It's growing pretty well considering how sick it seems. Time lapse uploaded.