Likes
Comments
Share
Partial reset on this girl who is obviously stunted and struggling. Not all strains are created equal and experience combined with skill goes a long way. So, taking my lumps with this girl. So, long story short, I reduced the ppm by draining and replacing 2.5 gallons of ph'd RO w/cal-mag added. This resulted in bringing down the ppm to roughly 500 w/ph at around 5.6. Will continue to monitor ph, ppm, and water levels for the remainder of this week looking for stabilization. At that point, I will gradually raise the ppm levels. If she doesn't make it back before TKO is ready to flip, I may need to scrap her given limited space. Come on girl, let's go... Midweek 4 update: Well, time has come for a decision. I moved the PBCRbx over to the 3x3 grow tent, so I can continue to care for her. Clear case of too much nutrients (high ppm levels) that have stunted early stage veg growth. Tried monitoring and adjusting ph twice a day but ppm remained higher than range resulting in fan leave tips looking burnt. Also some nutrient lock out occurring. Given ppm remaining high and water level dropping, I decided it was time to do a complete flush. Emptied and thoroughly cleaned bucket, air stone, and air line exposed in bucket. RO water with cal-mag and nutrients ph'd to 5.5 w/ppms at roughly 625. A day after flushing, the PBCRbx is looking a lot better. As a back up, I am running a separate PBCRbx by Ethos in a 3 gal fabric of coco peat, which is doing very well.
Likes
12
Share
Day 8 - First official day of veg and both ladies are looking good and on schedule for a couple of changes. Nutrients: 10ml of Hydro A & Hydro B were added to both buckets (10L of water in each bucket) PH: the Milwaukee PH controller was set to work - starting at a PH of around 7.6 - 7.8, it slowly worked down to a perfect 6.0 over about 50minutes. Lights: The lights were readjusted to be 60cm from the seedlings who are all between 8-10cm tall and the intensity of the lights were increased to about 70% brightness. Day 9 - Both plants are taking nicely to the adjustments and I am happy with the progress. Temp and humidity are stable and PH is controlled. Day 11 - The second nodes are clearly visible today for both Chong and Max which would hopefully put them at 3 nodes by the end of the week - right on schedule! Day 13 - The ladies seem to be showing some signs of heat stress, so thinking about adjusting the lights after their period of dark today because they are due to be adjusted tomorrow anyway for the new week of veg
Processing
Likes
33
Share
Start of 10th week and i decided to flush given almost 45L of clean water & been carefull with temperature of water! the laddies are looking well faded, and i hope to get a super clean medicine :) made some trim also on fan leaves to have better light penetration on lower canopy! Buds are looking dense, frosty & smelly!
Likes
21
Share
@Papablob
Follow
26/10 ci elle pouvait murire vite maintenant sa m'arrangerai. Elle m'oblige a rester en 12/12 et c'est restrictif. 🤨 27/10 vite mais bien. 😉 29/10Je me doutais bien que l'humidité allait monté. 😕 31/10 elles deviennent carnivore pour halloween.😈 Enfin.. demain ou après demain elle a un rendez-vous avec le sécateur. 🤤 01/11 le capteur d'humidité est mort 😅 En attente d'un neuf, je mets l'humidité a vue de nez.😬 🤤 elle a l'air terriblement bonne.👌♥️♥️
Likes
1
Share
Processing
Likes
3
Share
Likes
1
Share
So this week I added nutrients for the flowering stage. I gave her a little trim as well as added her netting. I flipped her on last Sunday PP
Likes
4
Share
@AutoCrazy
Follow
This plant is getting close to the finish line. She doesn’t have the tightest buds I’ve seen but what she lacks in tightness she makes up with loads of trichomes and a nice sweet skunky smell. I will likely take her down in the next couple days. She has been a pleasure to grow. Zero issues with mould/mildew or bugs! A true winner when it comes to resistance! Cant wait to chop!! Thanks for supplying the genetics sweet seeds!! 😎🍿🍻🌱
Likes
14
Share
On day 10, I transferred the buds to the HerbDryer since I needed to free up space in the drying cabinet for two other plants. When I made the switch, I did a light trim, and I finished the final trim when I placed them in jars for curing. As for the smell, it’s definitely strong and noticeable. You can clearly pick up berry and herbal aromas. After curing, the smoke quality and smell will improved . In terms of yield, it was a bit below expectations—only 36g dry. The top buds have good density, but the lower buds are quite airy and loose. That being said, I wasn’t expecting a big yield anyway, especially since it only had 12 hours of light during flowering. For now, that's it! I'll add more updates later. Meanwhile, I’ve started a new journey—this time with Runtz Auto from Zamnesia for the contest in partnership with Plagron. You can follow my progress in my Diarys Eternity CUP by Zamnesia & Plagron. https://growdiaries.com/diaries/246503-zamnesia-seeds-runtz-automatic-grow-journal-by-belsun-420 Thanks for the support!💚 ---------------------------------------------------------------------- Smoke test: You can definitely smell and taste the berries—not super intense, but you can catch the notes mixed with floral and sweet flavors. When you open the bag, the aroma spreads quickly, and it's easy to tell that you've been handling it. After smoking, your room will smell great, but not overwhelmingly so—it fades after a little while, hahaha! Overall, I’m satisfied for now… Now it’s just a matter of waiting for a better cure to enjoy it at its fullest! 🔥🌿
Likes
41
Share
Welcome to week 4 For Enigma in this Seedsman Tiny & Rare pot contest. After a bad start to week 3 she recovered well. Today I have added an air hose into her pot. It's run by a 5v 1w usb pump, connected to a 5v 2w solar usb panel. Using this I have been able to test the effectiveness of the light at different angles and ranges. The pump runs at full power within 30cm of the light. From there it slows rapidly down to 70 where it stops completely. I need a better light. Day 23: I have reconfigured the tent. I replaced the solar panel with a plug as I need the air to run when light is off too. My idea here is that if you can DWC with airstones, maybe if I blow air to her roots she can handle being in a saturated medium, thus allowing me to ensure she always has nutrition available. If it works as I hope, I may be able to have her exceed the size she might otherwise achieve in this pot. I have refilled the pot with fertigate every time the bubbles stop. There is no way its evaporating this fast. She has now been totally saturated for at least the last 6 hours and no drooping. Day 24: Been a bit lazy topping up her liquid but I'm confident the air pump is working as intended. Day 25: Enigma is on day 2 of a little dry-out experiment. Day 25.5 Enigma was wilting, so I fertigated her until the pot was full and then topped her up again twice. Day 26: Drowned her. Whoops. Day 27: Let her get too dry. Whoops. This is not easy. Day 28: End of week 4. Enigma suffering. It's difficult to get a balance between sufficient nutes and moisture levels.
Processing
Likes
4
Share
She looks very healthy and happy, she's fatting those flowers, she's very sticky, wonderful resin production and very very sweet aromas, just like her sisters, let's see how she turns out. I love her so far! 😍🤤❄️
Likes
8
Share
@JillSkunk
Follow
GEMINATION DAY! 3 of 3 have popped. I'm going t check the taproot again tomorrow and plant them as well. Just waiting another 12- 18 hours from a little more taproot growth.
Likes
10
Share
Gracias al equipo de Zamnesia, Marshydro, XpertNutrients y Trolmaster sin ellos esto no sería posible. 💐🍁MAC 1: La MAC 1 es una variedad muy solicitada, creada originalmente por Capulator y distribuida solamente a determinados criadores y cultivadores. ¡Pero ahora ya puedes cultivar este tesoro en casa y disfrutar de sus cogollos densos, jugosos y potentes! Gracias a su densa copa y vigor, la MAC 1 es una opción ideal para LST, poda apical y otras técnicas de entrenamiento (incluido el lollipopping). Cuando entra en floración, las plantas de la MAC 1 se estiran bastante y una vez maduras pueden alcanzar una altura de 160cm en interior y más de 180cm en exterior. De media, las plantas feminizadas de la MAC 1 necesitan un total de 9-10 semanas para terminar la floración, momento en el que estarán repletas de cogollos índica pequeños y compactos. 🌻🚀 Consigue aqui tus semillas: https://www.zamnesia.es/10906-zamnesia-seeds-mac-1.html Código Descuento 20%: ZAMMIGD2023 💡TS-3000 + TS-1000: se usaran dos de las lámparas de la serie TS de Marshydro, para cubrir todas las necesidades de las plantas durante el ciclo de cultivo, uso las dos lámparas en floracion para llegar a toda la carpa de 1.50 x 1.50 x 1.80. https://marshydro.eu/products/mars-hydro-ts-3000-led-grow-light/ 🏠 : Marshydro 1.50 x 1.50 x 1.80, carpa 100% estanca con ventanas laterales para llegar a todos los lugares durante el grow https://marshydro.eu/products/diy-150x150x200cm-grow-tent-kit 🌬️💨 Marshydro 6inch + filtro carbon para evitar olores indeseables. https://marshydro.eu/products/ifresh-smart-6inch-filter-kits/ 💻 Trolmaster Tent-X TCS-1 como controlador de luz, optimiza tu cultivo con la última tecnología del mercado, desde donde puedes controlar todos los parametros. https://www.trolmaster.com/Products/Details/TCS-1 🍣🍦🌴 Xpert Nutrients es una empresa especializada en la producción y comercialización de fertilizantes líquidos y tierras, que garantizan excelentes cosechas y un crecimiento activo para sus plantas durante todas las fases de cultivo. Consigue aqui tus Nutrientes: https://xpertnutrients.com/es/shop/ 📆 Semana 5: Comienzan a formarse los cogollos, las hojas se llenan de resina cada dia y el olor es bastante fuerte. Parece que ha terminado de estirar. Practico una defoliación intensa para airear los futuros cogollos y dejar mas espacio en el cuarto de cultivo. Agrupo de nuevo las macetas en su lugar optimo para asi rellenar por completo la carpa @marshydro. Me quedé algo corto de nutrientes pero estoy muy contento con los resultados, cada vez le voy encontrando mas su punto optimo. Siempre es mejor quedarse corto que pasarse.
Likes
10
Share
A metà settimana la pianta è in continuo progresso, i fiori si gonfiano adeguatamente, la cima sta maturando a vista d'occhio. Monitorerò il comportamento dei fiori ed il colore dei Tricomi. Attendo la fine della settimana per mostrare gli ulteriori progressi.
Likes
Comments
Share
@Nillenium
Follow
Bis auf das die Lampe zu dicht an den beiden längsten Blüten ist, gibt es nichts besonderes. Leider ist der Platz nach oben hin ausgereizt.
Likes
47
Share
More haircuts this week! I am very aggressively trying to keep up with the canopy growth. I'm continuing to remove the small branches underneath the canopy - more or less stripping the undergrowth, while defoliating around the growth sites that have made it to the canopy surface. I'm unsure of how much more growth to wait for before I send her into flower. Maybe next week? Who knows! Not me! Hah! Happily accepting any advice from any experienced main-liners out there! 😉 She's been super thirsty - I have to add a gallon every few days to keep up! I also started adding some p31 Microbes to the reservoir to see what I can see. 😎
Likes
1
Share
We’re in the midst of the bulking phase now, with a few buds stacking up nicely. Unfortunately, the plant on the left has sparser bud distribution. Compared to other auto genetics, these three plants also show a broad variety in growth structure and phenological traits. Also, overall plant health isn’t entirely satisfying, with high temperatures being the Main cause. The leaves are showing several stress-related issues like mild tip burn, nitrogen deficiency, and some cal-mag problems. But hey - we’re here to grow buds, not leaves! 😄 That said, the fade is to be expected as the plants start to cannibalize themselves for nutrients. The stretch is also in its final phase, so we’re likely 3 to 4 weeks away from harvest. --- Quick rundown on everything else: Watering: 1500ml every third day Fertilizer: According to the BioBizz schedule Light intensity: ~1000 PPFD VPD: ~1.62 kPa Temperature: ~28°C Relative humidity: ~55%