~ FASTBUDS TESTER #2205 ~ Well friends, here we go on another 'canna-venture' together! The grow room has had a complete remodel and some upgrades done to it including brand spanking new 4x8 and 4x4 tents and a Trolmaster Hydro X controller along with a new Control Panel. This tester strain is one of six tester strains that FastBuds has graciously provided me with and I'm looking forward to seeing what this girl has to offer when she's grown to her full potential! One drawback of 'testers' is I have little to no information on it other than its number and that it's an autoflower... 🤪 But, it's ALWAYS a blast growing them for me because not knowing a lot allows me to just concentrate on the essentials: Light, Environment, Water, Nutrients and possibly a bit of LST... not complicated, just basics like keeping a constant temperature and RH in the tent at a level that gives a good VPD, watering when almost dry and maintaining proper light levels according to their stage of growth. ____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________ ~THE SETUP~ ~Initially seeds were lightly scuffed, then soaked for 3 hours in 78℉ distilled water after which they were transferred to moist paper towels laid out in a Jiffy Pellet plastic starter tray with lid. Underneath the tray was placed a Mars Hydro Heat Mat with Controller that was set to 78℉ where they stayed until their tap roots emerged. ~Planted into Jiffy Peat Pellets that were hydrated with distilled water warmed to 78℉ with a 7.0 ph. ~Once roots emerge from the Jiffy Pellet they're transferred to their fabric pots. ~Grown 100% organic in a 4g Gronest fabric pot and a 3g fabric pot by Wraxly filled with Mother Earth 70/30 Coco/Perlite medium and initially amended with Dr. Earth 4-4-4 / Earthworm Castings / Dr. Earth Flower Girl 3-9-4 and Coast of Maine Stonington Blend Organic Plant Food 5-2-4. ~19/5 light cycle for the entire run with supplemental UVA added during flower. Lights are controlled by a Trolmaster Hydro X controller set for a 15min Sunrise/Sunset simulation. ~Top dressing every 3-4 weeks with slow release dry amendments and Earthworm castings. ~Straight water ph'd @ 6.2-6.8 when needed and bi-weekly Compost Tea's. ____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________ Weekly Updates: 12/1- I soaked both seeds for 3 hours in 78℉ distilled water after which they were transferred to moist paper towels laid out in a Jiffy Pellet plastic starter tray with lid. Underneath the tray was placed a Vivosun Heat Mat with Controller that was set to 78℉ where they stayed until their tap roots emerged which usually takes roughly 24 hours. These seeds however didn't follow the rules and took their fine time to pop out their tap roots. 12/3- Today their tap roots were about 1/4 to 3/8" so at 11 am I transferred them into Jiffy Peat Pellets that were hydrated with distilled water warmed to 78℉ with a 7.0 ph using a tine off of a plastic fork as a 'mini trowel' to make a hole in the pellet and to gently cover the tap root, leaving only the seed head slightly exposed. This method accomplishes most of the initial work the seed has to do by eliminating having to orientate itself, push it's root down and head up. By 10pm the #1 seed had her cotyledon leaves opened ...waiting on the #2. 🧐 I was concerned that one of the seeds may fail as she took so long to germinate so I soaked two more as an insurance policy. Naturally, BOTH of the second set of seeds popped their tap roots within 24 hours. One of the first round seeds failed to germinate which left me with three viable seeds, one in a pellet already and two showing tap roots. I planted both of the second round seeds into the same peat pellet that I had previously soaked. 12/5- Well this is Day ONE for the #1 FBT #2205 and I anticipate seeing one or both of the second round poking their heads out real soon! I'll keep them in the covered/heated Jiffy tray until I see their roots beginning to emerge from the peat pellet, then I'll transfer them gently into their respective fabric pots. The #1 will be going into the 4g Gronest pot from FastBuds and the #2 will reside in a 3g pot by Wraxly, which I'm trying out for the first time. 12/7- Yesterday I checked the #1 tester and she had roots starting to emerge from her pellet so tomorrow I'll transfer her into her 4g Gronest pot. The second round seeds finally made an appearance and I decided to yank the smaller of the two keeping me from having to stress them when I separated them.... this will be Day One for the #2! She looks really healthy and I'm confident that she should be ready to transfer into her fabric pot in the next couple of days! 😎💚 Thank you for checking out my passion in life! Please visit as often as you wish and I hope you enjoy this journey as much as I know I will! Grow Strong! 💪😎🤙

Getting there... cant wait for Spring Walls are up and painted, floor is laid, electrical all done, exhaust outlets mounted. Ive started to install the trim - I decided to put a grey stain instead of boring paint on the floor trim boards. Looks really solid against the dark bamboo floors. I used two gallons and two coats of flat pure white paint for walls and ceiling. Should give me a reflectivity somewhere around 80%. Some may ask why not opt for mylar? I just dont like the look. I dont care too much for reflectivity, as I will be well above the required watts/sqft with the light setup I will be using. I mounted an electrical receptacle in the ceiling, I thought it may come in handy for cord management. Im going to mount the 3 x meanwell drivers outside of the grow room and run some extra long cables to them. This is to keep heat out of the room, any little bit helps. Will be running a 8inch fan with about 750 CFM in order to properly vent the room. Intake will be a door vent and the negative pressure the fan provides. Odor is not too much of a concern, but may as well add a carbon filter. Tables to be built this week after trim is installed Week 1 Spend - $2080 Week 2 Spend - $350 (mostly on hardware store visits) Total so far - $2430

Well, I came back after vacation, and this is what I found: it jumped up to the light.... I made a little cropping and tried to use more LST, the problem is that it no longer fits :D :D :D but at the same time, it's really interesting to me trip :)also, several rings are already affected by the light, my 50w light currently shines at 100%, maybe it would be better to reduce it to at least 80%?.

I looked at the trichomes every 2 days this week. There are still some clear ones but they look cloudy overall. The OG Kush begins to have many amber ones. I started to flush too soon and the plants are now struggling a bit. I will harvest everything next week! The final grow area is around 1,1m x 1,1m.

Some leaf tip burn, either lights or nutes. Measured TDS@900 and moved the lights away a few cm.

Schwazzzz continues and ScrOG begins !

Hi guys, What's up? Welcome back to Queen Peaky's Flower Gardens We have decided to further extend this beautiful woman's stay in our tent to continue developing the fantastic buds she has developed

What can I say papaya sherbet really thriving under low stress training starting the last week of stretch hoping to keep a level canopy, but without topping her it’s hard to keep it flat🔥

Running into some temp issues tent reaching high temps even with two fans causing some yellowing of the plants as well as entering pre flower as well

Novena semana de floracion, se ha formado una linda cola, uniforme y compacta que continua cargándose de blanca resina 🤩. Tiene un olor afrutado muy intenso. Esta semana es la ultima con nutrientes, queda poco para ver el resultado final, estoy muy contento de este grow. 📅 Dia 57: Riego con nutrientes EC 1200, EC escurrida 1750 📅 Dia 58: 📅 Dia 59: 📅 Dia 60: Riego con nutrientes EC 1250 Ec escurrida 1650 📅 Dia 61: Riego con nutrientes EC 1200 EC escurrida 1750 📅 Dia 62: Riego con nutrientes EC 1300 EC escurrida 1850 📅 Dia 63: Penúltimo riego con nutrientes EC 1200, ha quedado una planta muy compacta

2020-08-03 Had to add some yo-yos as the main colas are getting ripped now. I have had to mash the plant into the tent, it's hogging all the light from plant 2 but oh well, not much I can do now and the yield from Plant 1 will be nice. Running same nutrient ratios still. Plant 02 has never matured into a full drinker, plant 01 is up to a gallon of water a day and is doing great on 800 ppm. 2-3 weeks til harvest!!

week 5

Slowly stretching, doubled in height and width. At end of week going to start feeding foxfarm trio at half dosage following feeding schedule. Growing steadily. Still slightly tucking leaves. Trying to give least amount of stress as possible.

Just water

Week 2, Day 10: all 5 seedlings has emerged from the coco that I've prepared.Most of them are between 6-9cm tall and 4 true leaves has appeared. Been feeding my self made nutrients equivalent to the GH main 3 Floral Series. The coco that I have bought is from a 5.5kg block which i buffered with Calmag solution of 150% strength and left overnight for 8+ hours. The girls seems healthy and happy at the moment however I have read some reviews that these 2 strains BCN Critical XXL & Big Bud XXL are not hard to care for and mostly forgiving on the nutes. I always ensure that my PH levels are within par of 5.5-6.5 & the recommended PPM according to the feeding schedule of GH label instruction which is between 300-400 ppm. The other 3 plants are Landrace Sativas which I grew earlier and 2 has been given LST (Low Stress Training) back 5 days ago and I noticed that the smaller leaves are thriving into bigger fan leaves and thicker branches! I overdid the 1st plant which seem to be slightly overbent including the main stem which quickly recovered and healed overtime. these plants are really amazing to watch them grow. I will be transplanting the 5 autoflowers into a 5 gallon pot in another day or 2,until then happy growing! 😸

Dane, We all should help one another. Human beings are like that. We should live by each other’s happiness - not by each other’s misery. We don’t want to hate and despise one another, share the Joint. And mother earth is rich and can provide for everyone. We can Grow enough Happiness, In this paradise, there is room for everyone. We only exist to bring joy into the world and The way of life can be free and beautiful, but we have lost the way. Grow High and Give the world A smile. At the end we own nothing more then all our memories, lets make them amazing for everyone, nothing to loose only everything to win. A last kiss goodby, a second one, softer and long as a sign, that you are woth it. That Everyone worth who loved and give. Enought Hippie Talk, now have a nice day and an even better grow, thx for watching by. colour change sets slowly in i need to find out some timelapssettings with gopro.

girls are doing great they smell like stinky feet wew thats rank.Have not found anymore hermi parts these bubba cheesecake nuggets are getting better every day They are awsome plants

I really love grow Blue Gelato 41.It’s a very tasty and strong.Suitable for gourmets. Blue Gelato so delicious that I want to eat it all the time. Thanks to everyone who follow my grow report, love u all, Peace!😘