Likes
Comments
Share
@DimJesus
Follow
Saludos 🙌 completando la novena semana y tercera semana de floración. Las variaciones de temperatura continúan pero ella es ya de acostumbró, la humedad está actualmente en 80% y varía bastante también. La altura del panel led continúa la misma en relación a la semana pasada pero ahora la distancia hasta la planta se redujo a 4-5cm del cogollo más alto, el cual está sin main-lining. Buenos humos 🍃
Likes
Comments
Share
As flores já estão resinado e por se tratar da segunda semana, considero que a evolução está a cima da média aqui na minha realidade. O plano de nutrição segue o mesmo, porem percebi que ela reagiu de forma mais expressiva com a adição de Cálcio e Magnésio.
Likes
52
Share
14 Jul 2021 The plant is still looking lovely, and her buds look wonderful. I’m continuing with the flush of properly pH’ed water chilled to 46.3F. My initial pH was 7.7, so I added 15 gtts (1.5ml) of pH DOWN which adjusted the pH to 6.2. I’d like it to be higher, but working with pH DOWN is so much harder than pH UP! The TDS going in was 75 ppm. Our heat wave is still going strong, and the temperature in the tent was 88F with humidity at 44%. The runoff pH was 5.3, and TDS runoff was 1897 ppm. That’s a reduction of 410 ppm from the watering on the 12th. At this rate it’ll be next week or later till I can harvest. If it does, I may end up harvesting sooner and curing longer. 🤷‍♂️ I’ll have to wait and hope I guess. 16 Jul 2021 I’m continuing with the flush today, and I’m beginning to think I should start flushing more often, yet I don’t want to damage the plant. At this stage of growth I don’t know if overwatering is as detrimental as it is to a younger, less developed plant. I want to harvest it before she gets too far along in her trichome development. She was clearly ready when I checked them on July 10th, and I don’t want her to get much farther along. Today I’m giving water at tap temps because at this point I don’t believe it matters. Everything I’m deciding to do is purely by instinct and trial and error. I feel like a researcher working on viable material that has a known outcome in general, but getting to the final stage (harvest) is detrimental in how the individual works the issues, or problems, and prepares for a desired outcome. Only each strain is different, and learning to adjust to those differences is the learning process. I never knew that growing weed could be so much fun, or as stressful! But I dig it! Today she received a gallon of water with an initial pH of 7.7. I added pH down 5 gtts (.5ml), which adjusted the pH to 6.4. TDS going in was 91 ppm. Runoff pH was 5.9, and TDS runoff was 1407 ppm. Temperature in the tent was 84F, and humidity was 60%. There was a 390 ppm reduction from the last watering 2 days ago. At least it’s moving in the right direction. 18 Jul 2021 The flush is going well as you’ll be able to see once I post my numbers a little later in this note. Her buds are still looking awesome, and she still looks healthy for the most part. Her leaves on the fan side still look dried up on the edges, but not completely dead. Since it’s happening on both of my plants in the same location, the cause was easy to surmise as I’ve noted it before. I’ll be ready for harvest in about a week or less, and then her tent mate will be left alone for a while. Today she was given a gallon of water chilled to 57.2F with an initial pH of 8.0. I added 8 gtts (>1ml) of pH DOWN in 2 separate increments to adjust it to pH 6.7. The TDS going in was 80 ppm. The runoff pH was 6.1, and TDS runoff was 784 ppm. That’s a reduction of 623 ppm since the last flushing/watering. So I’m down into the 3 digit realm now, so hopefully it won’t be too much longer! She smells like blueberry muffins! I’m not even kidding a little. Like blueberry muffins. I’ve never seen a better named strain ever! 20 Jul 2021 Flushing continues in my grow room today. I swear this part takes so long and is so frustrating. I only have myself to blame, but all is still good. She is ready for harvest, but I still need to finish this up first. The TDS runoff shows that the level is still dropping, just not as fast as I’d like it to be. Today I chilled a gallon of water to 57.7F, then got her ready to give my baby. The initial pH was 8.1, so I added pH DOWN 10 gtts (1ml), which adjusted the pH to 6.8. The TDS going in was 74 ppm. Runoff today: pH 6.3, and TDS 658 ppm. Our heat wave is still kicking hard, so the tent temperature was 88F, and humidity was 49%. I’m still hoping to harvest in a few days to a week from now. It all just depends on the flush. I didn’t bother with any pics today. Mainly because the lights went off as I was finishing up and figured there aren’t any changes from 2 days ago to bother. However, today ends a week, so the next will be a fresh week, so I’ll take pics then.
Likes
17
Share
@BLAZED
Follow
Week 12 (17-4 to 23-4) 17-4 Temperature: 23.1 degrees (lights on) 19,1 degrees (lights off) Humidity: 62% (highest) 50% (lowest) 18-4 Temperature: 22.5 degrees (lights on) 17.9 degrees (lights off) Humidity: 61% (highest) 52% (lowest) Opened the reservoir for a couple of minutes. 19-4 Temperature: 22.5 degrees (lights on) 18.4 degrees (lights off) Humidity: 64% (highest) 54% (lowest) No pictures. 20-4 Temperature: 24.1 degrees (lights on) 19.1 degrees (lights off) Humidity: 65% (highest) 54% (lowest) Light increased from 50% to 60% strength. I also made a new 10L feed, and added it to the reservoir, there was still 2850 ml in the reservoir, so i can calculate how much they get per watering. Opened the reservoir for a couple of minutes. 21-4 Temperature: 24.4 degrees (lights on) 19.3 degrees (lights off) Humidity: 66% (highest) 54% (lowest) No pictures. 22-4 Temperature: 23.7 degrees (lights on) 19.7 degrees (lights off) Humidity: 67% (highest) 42% (lowest) Opened the reservoir for a couple of minutes. 23-4 Temperature: 23.6 degrees (lights on) 17.7 degrees (lights off) Humidity: 64% (highest) 50% (lowest)
Likes
13
Share
Removed the 2 Xs 1500's (300watts) & replaced them with 2 P1000 (200watts) lights, now running 680 watts. These lights fit in better & have air space all around to help cool them, these lights run a lot cooler than the xs 1500s & only get warm not hot. Started some clones.
Likes
16
Share
@Mospeada
Follow
I don't believe I'll need to do any daily updates for the rest of the grow. Everything is dialled in and I'm ready to use what I've learnt for the next grow. I will be adding to this week in regards to writing up a summary of everything I've learnt so far and how I expect to improve upon the next.
Likes
18
Share
Last week in soil! Flushing has started and both looking amazing can't wait to get drying now 🤤
Likes
12
Share
@russrahl
Follow
Plants are looking good so far, added about 2ml/gal to the reservoir this week and plants responded well. They are all keeping short and stocky so far and should be able to start LST training in a few days I think. I also turned up the light to 750w and the air temps are now hovering between 24c-25c. Water temps are creeping up though in the 21c range, gonna wrap the buckets tonight in foil insulation and build a water cooler for this setup soon as well. Had some Ph issues during week 4 because my pen decided to go wonky. I tried to calibrate it again and had a hard time. So I busted out an older one and decided to calibrate it and see if it worked still... calibrated in a few min and sure enough res ph was well bellow 5. So water was changed as it was time anyway and ph’d proper just before lights out so we will see what happens tomorrow.
Likes
1
Share
Beautiful colas all over. Since flip growth has been super sayin..
Processing
Likes
85
Share
Lola is coming along slow n steady . Not much to report yet
Likes
9
Share
@Haoss
Follow
new life is born I will do my best to make this beautiful girl grow up big, healthy and beautiful. Together we will see what kind of girl she will grow up to be
Likes
5
Share
@GODAXE
Follow
21.07.2024 we finaly had a sunny week with a nice day and night temp. The camper berry look have nicely recover from the last week lack of sun. with this better condition the 300ppm nuts solution was just fine. as the roots has show nice developement they wiil hit their final dwc setup tomorow.
Likes
144
Share
@DevilsBud
Follow
New week for the 7 strain 11 plants grow Everything is going great some little things here and there but nothing to be worrying about so i am happy how it goes one plant had balls and couple have some droopy leaves on them but have feeling my temp is way to low in darkness 16/3/22 I always show the good the bad and the ugly made couple mistakes wiles training but luckily these plants are so strong give some support and the branch that broke will fixes here self 💪🏻 Will be updating Tru the week And remember just grow weed and stop growing bullyish behavior visit www.marshydro.eu for your best gear and use the PROMO CODE: DEVILSBUD Some info about the Marshydro FC-4800 Superb Quality LED Chips: The whole light is composed of 1206 pcs Samsung lm301b and Osram 660nm chips. More than two times as many LEDs are used to drive the grow lights at low currents and to avoid overdrive. Quality is guaranteed and efficiency is up to 2.8 μmol/j. Even PAR Distribution and High PPFD Output: The multi-light bar design and the densely distributed light chips enable the LED grow lights to achieve the optimum PPFD required for plant growth over the entire effective coverage area. Specifically Designed Spectrum: To ensure even plant growth, blue and red light are enhanced on the basis of a full spectrum combination. Not only does this accelerate plant growth, but it also improves the yield and quality of the plants at the same time. Dimming Daisy Chain Function: The dimming function saves on electricity costs and enables brightness from 10% to 100% for the different stages of plant growth. A single master light can connect up to 30 lights in a daisy-chain system. Business LED Grow Light: The light's wavy heat sink dissipates heat quickly and the IP65 waterproof allows the light to operate in humid conditions. 180° collapsible feature for easier installation. All these features provide favorable assistance for commercial cultivation. And some tent info ●【Lock All Light Insid】MARS HYDRO Grow Tent Interior is made of diamond mylar. Non-toxic to the environment, no harm to plants. High-quality 1680D canvas being double stitched, (ALL OTHERS BRAND grow tent is 601D canvas) which is tear-proof for perfect light locking, No light leaks or rips at all. ●【Durability Grow Tent】Stable Metal corner adapters and poles are the trustful supporters of the tent. No rusting nor paint-falling. Quick easy tool-free installation. Carries strong heavy-duty SBS zippers, double layer lining to create a light-proof seal. ●【Easy Observation of your Plants】Special peeks window made by double layers of cloths. Observe the growing conditions of your plants without opening the tent and avoid disturbing plants. The peek window also serves to dissipate heat and ventilate air. ●【Removable Tray Keep Clean】The package includes a removable waterproof floor tray to hold soil and fallen leaves. The tray can be taken out easily to wash. Removable and water-proof makes cleaning easy. ●【Good Ventilation&Fast Assembly】 Circular double-sleeved vent holes with adjustable nylon strap for air circulation by exhaust fan, ducting, carbon filter, or reflector. Better allows proper light, heat, and airflow. Quick tool-free installation. Reinforced by a sturdy metal frame to ensure security and stability, supports up to 140lb. Perfectly safeguard your plants to thrive even in winter
Likes
5
Share
Bonjour à tous, voici quelques vidéos de mes fifilles pour l'instant elles poussent bien. Après j'en n'ai qui pousse bizarrement à voir par là suite. Bonne journée à tous 😉
Processing
Likes
25
Share
@Ashbash
Follow
Still going lol. Still not too many amber, but I cut down one of the smaller side growths to dry and test. Keeping up with just water, probably could have added nutes for quite a bit longer, but oh well next time haha. Couple buds moved onto a light bulb and burned pretty badly. Be careful out there!
Likes
34
Share
@GreenLion
Follow
Hello everyone This is first week of flowering stage. She looks pretty good. I flushed two times and after this added transition stage nutrients. If you have any advice just say ;)
Likes
12
Share
@Fccfarms
Follow
Vegged for 19 days in the big tent and 2 weeks f seed in propergation room proir. Week 1 day 1 of flowering cycle. Started on Saturday 22nd June. Bring on the summertime heat . I wonder how these girls will cope.