The Grow Awards 2026 🏆
Likes
Comments
Share
- Streching is almost fully stopped. - Had to elevate the pot of Kings Kush 10 cm more as Chemical Bride is significantly bigger in size. - A big defoliation and Lollipoping are applied on 18.06 which kind of stunned the growth for the next 1-2 days. - Humidity has been a very big problem in Berlin due multiple storms this week as it cruised around 70-85 % outside whole week. - VPD fluctuated this week between 0,75 and 1.7 kPa , averaging at 1,15 kPa. Lower than last week… - Tent temperature fluctuated around 22 at night and 26 Celsius at day time, averaging at 24.2. Slightly higher than last week even though iI have increased the inline fan speed on 16.06. - Humidity fluctuated crazy between 50-75% this week, averaging at 61.6. - This week, I kept giving increased Ph (6.8) of water as the medium Ph is still under 6 cruising around 5,8. - Trichome development has started, already seeing frosting on Chemical Bride. - White pistils are slowly turning orange on Kings Kush.
Likes
7
Share
@ibbzy
Follow
All started to flower and the stretch begins! Lost a few tops with training. I will opt for just topping instead of LST (too time consuming) Will start slowly dropping nitrogen and increase phosphorous and potassium with some molasses! Last two shots are of last bit of LST and leaf tucking/defoliating
Likes
Comments
Share
@Lushgaia
Follow
Some of the leaves starting to yellow slightly but as it’s coming to the end I think I will let it ride out might give a little pk booster but that’s about it
Likes
4
Share
Likes
Comments
Share
Lady is now my tallest and growing strong. She is a heavy drinker now requiring about ~ .3 every 6-8 hours. Heavy P & K early in flower led to slight tip burn. Have been straight watering for the last week and she has bounced back beautifully. I topped her around week 3 she has now outpaced my untopped plant in the tent and has similar strong inter-node spacing. She's slightly dusty(trichomes) early!!!!!!!
Likes
12
Share
@VTR90
Follow
They really took off I was doubting the size of em a few weeks ago 😁 Really struggling with RH tho, not done much defoliation, didn't wanna upset em had herms the last 2 runs so treading lightly. A fair bit of air movement in there hoping that'll keep mold away 🤞
Likes
9
Share
@RdSkM
Follow
No fueron cosechadas todas al mismo tiempo. Unas empezaron floración primero que otras.
Likes
3
Share
@BigGGrows
Follow
Well, the Grandaddy black hermed on me in the beginning of week 7 flower. Separated her immediately and did a flush bringing the ppm down from over 2k to around 500. Two days later she was harvested. A little blown she didn't finish up how I wanted her to. 2 more weeks she would of been ready. Trichomes were 5% amber 70% cloudy 25% clear.
Likes
62
Share
Just trying this just to see if you can grow in s household name compost, struggling with nutes as it has nutes for 6 months already in wish me luck 😀🙏
Likes
69
Share
Almost done now! gonna have to do a proper endgame photoshoot next week! shes pretty but my solo grow is completely kicking its ass... but thats just genetics!
Likes
293
Share
@Ju_Bps
Follow
Hello growmies 👩‍🌾👨‍🌾🌲🌲, 👋 No more burning this week, using nutes again. Buds start to bump and are more and more frosty ❄️❄️ 💪 Will do a big defoliation next week ✂️✂️ 💧 Give water each 2/3 day 2 l Water Only 2 l Water + Bloom + Green Sensation + Sugar Royal (3 + 1 + 1 ml/l) PH @6 💡Mars Hydro - FC 3000 50% 13 cm Mars Hydro Fan kit Setting 8 Have a good week and see you next week 👋 Thanks community for follow, likes, comments, always a pleasure 👩‍🌾👨‍🌾❤️🌲 Mars Hydro - Smart FC3000 300W Samsung LM301B LED Grow Light💡💡 https://www.mars-hydro.com/fc-3000-samsung-lm301b-led-grow-light Mars Hydro - 6 Inch Inline Fan And Carbon Filter Combo With Thermostat Controller 💨💨 https://www.mars-hydro.com/6-inch-inline-duct-fan-and-carbon-filter-combo-with-thermostat-controller Fast Buds - Gorilla Cookies FF🌲🌲 https://2fast4buds.com/us/seeds/gorilla-cookies-fast-flowering
Likes
59
Share
Un altra settimana è passata e tutto procede bene.per fortuna non ho più trovato nessun nanners 🙏✌️💪..belle piantine mie, continuate così che farete delle belle pannocchie.... 30/8/24 gente ho combinato una bella cazzata.pur avendo esperienza, mannaggia a me,mi sono portato a casa dentro il box, il cazzo di ragnetto rosso... fanculo... Ho già iniziato a ripulire tutto, box e piante con Neem...li sterminerò tutti 😂..
Likes
107
Share
Alright Then REMINDER I DO 2 UPDATES PER WEEK 👉WEEKLYROUNDUP👈👉MIDWEEKLY UPDATE👈 We just hit week 4 and all is well , have to admit she's showing pre-flower growth super happy with how shes coming along 😃 ....... I'm still training her with LST looking good 👌 And she's filling out the pot perfectly👌 Very little water given ,so far and rain water to be used entire growth Lights being readjusted and chart updated .........👍 I GOT MULTIPLE DIARIES ON THE GO 😱 please check them out 😎 👉I WISH GD HAD DISCORD SERVER SO GROWMIES COULD HAVE A PLACE TO HELP AND TALK THINGS RELATED TO GROWING IN REAL TIME .....👈 👉SO I CREATED ONE ALL YOU NEED IS TO JOIN THE GROWDIARIES DISCORD SERVER !!!!!!!!!!!👈 LINK IS 👉 https://discord.gg/zQmTHkbejs AND SEE HOW IT PLAYS OUT !!!!!!!
Likes
4
Share
Day 28- business as usual. May top dress end of this week, not sure. But smells and trichs are setting up and no signs of deficiencies. I probably could push them more but it’s all good for now. Day 30- ditched the trellis and did a heavier defol as the humidity would reach 73 with lights off. See if we can get some better airflow and fatter lowers.
Likes
21
Share
Alright things are moving along nicely now.im getting close to about half way done.plenty of bud sights.i really do love myl.e.d.s.this is my third grow and and they are still doing great.check out my video
Likes
2
Share
@dwotTV
Follow
Transplanted in the afternoon of 10/23 because they were rooting out of the pucks. Got some humidity dome cups coming tomorrow and another inline fan to handle intake to try to dial in things a bit more. Fugue State #2, in the black pot is still a bit shell shocked, hopefully it opens up soon. Well both #2 and #3 damped off / shell shocked to death, so there's just one left, c'est la vie. #1 is trucking along well and ready for week 2. Sprayed with Neem Oil on 10/24 Fed Light Fox Farms Blend on 10/25 Treated with NemAttack on 10/26
Likes
47
Share
The cannabis strain Grape Guava can be a purple strain, depending on its specific phenotype and genetic makeup. While not all phenotypes of Grape Guava are purple, some variations, such as the Zatix Grape Guava, are noted for their striking purple appearance due to the genetic expression of anthocyanin pigments. https://www.youtube.com/watch?v=cKdVmdoKJ5k In a garden of green, Grape Guava gleams, With its fruity aroma, enchanting dreams. Clusters of grapes, guava's sweetness ignite, A strain so divine, in purple and white. Euphoria whispers, a lush fruity haze, Grape Guava's embrace, a tranquil daze. Off and away.@1400ppm. The increased CO2 allows plants to thrive at higher temperatures, which in turn necessitates higher humidity to maintain the ideal VPD for healthy growth and transpiration. 80F -5F = 75F LST with 70% RH = 0.72 kPa. Higher temperatures and humidity promote rapid growth, nutrient uptake, and photosynthesis while maintaining a lower stress level. Temperature influences the rate of enzymatic reactions involved in aerobic respiration. Enzymes, such as those involved in glycolysis, the Krebs cycle, and the electron transport chain, work most efficiently at an optimal temperature range. In low temperatures, enzymatic activity will slow down, thus reducing the rate of aerobic respiration. In high temperatures, enzymes can become denatured, thus impairing their function and stopping the process of aerobic respiration. Glucose is the primary fuel for aerobic respiration. The rate of aerobic respiration increases with the availability of glucose, as it is the starting point for glycolysis. If glucose levels are low, cells may rely on alternative energy sources such as fatty acids or amino acids , but these processes may yield less ATP or be less efficient. To determine this effect, carbon dioxide volume was measured (as carbon dioxide is an output of aerobic respiration) 18/6 with the 6 being IR. The near infrared (IR-a) borders around 700nm up to 1400nm @ photon par flux density of 1.8 instead of darkness, keeping temps overnight a neat 77F-80F. Think of my tent as a lung. What goes in must come out. When the rate of air going out exceeds the amount of air coming in, it creates a negative pressure. Tent concaves (bends in). If set up correctly, your RH will begin to drop slowly to the desired level you set, and the extraction turns off when it reaches desired% RH. The plant, as it performs cellular respiration, will always be releasing more water into the air, so the RH% of the tent overnight will always increase, so long as oxidative phosphorylation is occurring. As soon as the RH% creeps back up to 55%, the extraction turns back on, over and over. This creates a strong pressure differential which will work wonders on your grow. Replicating high and low-pressure fronts in nature. Critical for oxygen diffusion at the critical time of peak cellular respiratory function.. Moisture will not transfer from a saturated atmosphere to another if that air is already at or above its saturation point, meaning the air can't hold any more water vapor. Once I understood that water is produced as a by product during cellular respiration, specifically at the very end of the electron transport chain (ETC) where electrons are finally transferred to molecular oxygen, the higher the RH of the air, the more resistance there is for more moisture to be added to that environment, and effects the ease with which it does so. But none of that water comes from the pot; it's pulled from the air. If you run high daytime RH, your medium/pot is 100% reliant on transpirational root pull to move water. ZERO evaporation happens across the atmosphere if the tent air has high RH%, the medium cannot release its water through evaporation. Once a canopy develops, light no longer slowly wicks and evaporates from the topsoil. The Soil-Plant-Atmosphere Continuum (SPAC) describes the continuous pathway and process of water movement, driven by a gradient in water potential, from the soil, through the plant's roots, stem, and leaves, and finally evaporating into the atmosphere through transpiration. There is evaporation, there is transpiration, and then there is evapotranspiration; Evapotranspiration (ET) is the combined total of two processes: evaporation (water lost directly from soil and surface water into the atmosphere) and transpiration (water released from plants to the atmosphere through their leaves). Evapotranspiration represents the total amount of water that moves from the medium into the air. There is no such thing as a medium with too much water, only a medium that retains too much for too long. The water must always flow efficiently from one atmosphere(Medium) to another(Air) in a timely manner. Moisture is a critical factor for bacterial growth and decay. Dictating how long it's allowed to sit in any one location for any given period is a key preferred control. To ensure a net reduction in a bacterial population, the rate of removal (ET) must exceed the rate of bacterial growth (decay rate), which is often modeled as a growth rate for the specific bacterium under the given conditions. By optimizing daytime VPD, we also optimize conditions for bacterial growth to explode exponentially above 77°F.. If water is allowed to sit in a medium without an escape within a timeframe, nothing good will happen. IF High RH is maintained overnight as well as during the day, placing 100% of water movement at the behest of daytime transpiration, roots can only pull where they can reach, and if soil is compressed above a certain point, moisture will become trapped in a medium with no way of moving day or night. This will begin the countdown for decay to take hold. When water stagnates in a medium, it loses oxygen, creating anaerobic conditions that foster the growth of harmful microorganisms like bacteria and fungi, which can produce toxins and disease vectors. Thigmomorphogenesis, the process by which plants respond to mechanical stimuli like touch by altering their growth and development, results in significant morphological changes to improve survival against mechanical perturbations. This complex response involves sensing touch and initiating physiological and genetic responses, leading to changes in form and structure over days or weeks. The process is triggered by physical forces such as wind, rain, or touch. Plants adapt to these stimuli by changing their shape and structure, which may include slower growth, thickened stems, or altered leaf development. Plants possess sophisticated mechanisms to detect even subtle mechanical stimuli and initiate responses. A variety of molecules, including calcium ions, jasmonates, ethylene, and nitric oxide, are involved in signaling these mechanical inputs. Touch can induce the expression of genes that encode proteins for calcium sensing, cell wall modification, and defense mechanisms. A plant exposed to constant wind may become shorter and sturdier. A plant that is touched frequently might grow more slowly to conserve energy and develop thicker cell walls. These changes increase a plant's resilience and ability to survive in harsh environments. Let's get Thiggy with it.
Likes
24
Share
This lovely girl is just getting more and more beautiful. She is packed with buds that are swelling very well. They are nice and sticky to touch.
Likes
6
Share
I feed her with full strength of nutes in every 4 days. The leaves are much healthier, so this is the way to go. The smell is lacking which is weird, but hopefully the end product will be fine.