Likes
Comments
Share
Well it’s week 5. Week one of what I’m gonna call flower. I got 2 plants in full flower and the others are coming from begins fast. Dealt with a mag issue this past week got it straightened out. The banana purple punch plants just aren’t thriving like the rest in my tent. I’m gonna grow them again because I’m pretty positive it a me problem. The plants are doing awesome and these fast buds grow insanely fast. I’ve been creeping my light up every week. I’m at 60 percent on this evo 3. Gonna bump it up to 70 percent later when my light comes back on
Likes
5
Share
@zspl0it
Follow
Still trying to maintain the optimal VPD. Unfortunately the summer starts to hit hard and I had to have some AC running. Haven't nailed the numbers and it will be worse in the following weeks.
Likes
27
Share
@Dunk_Junk
Follow
Flowers are getting denser. Pistils are changing colour very slowly. On she goes! 💪
Likes
3
Share
Likes
2
Share
@pzwags420
Follow
Plants are growing well. set up veg tent with new ac infinity tent and fan.
Likes
15
Share
Getting so frosty that the leaves look like cotton balls but the buds ain’t fattening like my mango chutney and critical Kush is! Mind you, the don’t have that frost that gorilla Zkittlez does lol
Likes
20
Share
June 6: looking good. Very impressed with these Quebec Cannabis Seeds genetics. This and Bubble OG are great strong plants. June 7: check out coyowolves howling on video. June 8: more defoliation.
Likes
5
Share
The growth on this girl last week 🔥🔥🔥 & she's healthy AF(excuse my French🤣) She's been praying🙏 24/7 to my Geeklight Geekbeast Pro. At the end of next week i'm gonna do a big clean up on her (defol & lollipop) also i gonna give her, her first tea😁 (Bio-Tabs Compost Thee) Stay tuned & elevated growmies💚
Likes
1
Share
Absolutely blown away by the new 2025 setup, prev ran 3 tents 😂, switched to AC Ifinity 2,4 x 1,2 single tent, 3 x 150 or 6“ fans. Fans all port outside, 2 exhaust with yet uncoupled carbon filters, 1 inlet with pollen filter. 6-7 air push fans (not all yet on 😂). SpiderFarmer 16L humidifier, inkbird RH control, inkbird heat control, heater, trotek dehumidifier (12L) with drain line and reservoir. Blumat system with RO fed 20L water butt, each pot with 3 long ceramic blumats. Data logger from SensorPush including WiFi hub and 4 sensors. One in cellar room (lung room), one above each plant canopy. Setup logger n sensors and track VPD. System running itself
Likes
3
Share
@TyRun
Follow
Intermediate Results Overview This grow was intense! Setting up the grow consumed so much of my time and focus that I started slacking at work, and it took me a month to get back on track. But hey, what’s the point of a job if it gets in the way of growing? 😉 In the end, everything worked out, and I gained invaluable experience. This was my first grow using coco coir. At first, I didn’t get it, but then it just clicked! Now I’m hooked: "I’m here to stay." Coco is more controlled than soil, flushes easily, and you can introduce beneficial microbes, which thrive in it. My main takeaway from this grow? If you buy coco, don’t forget CalMag! Next time, I’ll definitely install HEPA filters at the intake. The amount of dust was insane, and the grow box pulls air like a vacuum cleaner. Watching the timelapse, you can see the box sucking in every bit of dust. I vacuumed the intake filters weekly. The plant was incredibly sticky, but that also meant it caught a lot of lint and fibers between trichomes, especially visible under a microscope. Smoking microplastics? No, thank you! --- On CO2 CO2 only works if everything else is dialed in. If the plant experiences stress from deficiencies or overfeeding, you can forget about it. Since CO2 supplementation requires turning off the exhaust fan, it’s hard to manage temperature and humidity. The plant releases so much moisture that RH jumps to 80% within minutes. It’s doable, but definitely a challenge. --- On Magnetic Fields No clue what’s happening here yet, but it’s fascinating! I’ll test again with a control sample. --- Nutrients Dreams do come true—I’ve tested almost everything Advanced Nutrients offers. It wasn’t all smooth sailing; their feeding charts need adjustments for your conditions, and you usually need to feed less than recommended. Overall, I’d say the nutrients performed 100%, and I see no reason to switch. I’ll stick with them for future grows. --- Strain This strain is reliable, though not the most productive. It flowered exactly as advertised and delivered a frosty finish. It tolerated all my mistakes like a champ—especially mold. Despite an abandoned SCROG plan turning the plant into a bouquet, there wasn’t a single mold spot, even in the densely packed lower buds that got almost no light. Zero mold issues! --- Aroma As advertised: pine, wood, and citrus. At first, I thought it smelled like grapefruit, but now I’m leaning toward bergamot. Bergamot with a classic weed aroma—a recognizable twist on the usual scent. During the grow, the smell was strong, but the carbon filter handled it perfectly. --- Flavor It’s too early to say, but the flavor is definitely there! Embarrassingly, all my past harvests tasted the same—like nothing. Just smoke. This one has a distinct sour taste. I’m excited to see how it develops after curing. --- Effect Too early for a full review, but I love what I’ve tried so far. The high lasts about three hours, with euphoria and relaxation. It’s the perfect evening strain. I’ve smoked a lot over the years, but I’ve never experienced true euphoria—until now. Guess I’ve been stuck with garbage and ditch weed before. 😅 It’s not a strain for productivity or chores, but it’s perfect for chilling, watching something, or chatting. No anxiety, just great vibes. It feels like having a beer after a long day: you relax, and life feels good again. --- Roots The roots were healthy—maybe too healthy! While the AirPot (20L) prevented root circling, it didn’t eliminate it entirely. There were dead zones at the bottom where roots circled around the perimeter. A dense root mat formed at the bottom (so dense you couldn’t poke a finger through it), which likely contributed to salt buildup. Breaking through that mat required more water, and I suspect this caused EC to spike 1.5x the next day if there was no runoff. Next time, I’ll mix some pumice with the substrate at the bottom, about 3–4 cm deep. --- Timelapse I only got the timelapse running after the switch to flowering, so it’s not from the beginning. Still, it’s an incredibly useful tool for understanding growth rates. I’ll definitely use it for future grows. Comparing yesterday to today is one thing, but rewinding a week to see how things were is game-changing. I recommend it! You can even use an old phone with a timelapse app if your camera doesn’t support it by default. --- What’s Next I’ve grown fat buds before, but I’ve always neglected curing. This time, I’m doing it by the book with full control. Drying in the grow box with RH controlled at 50–60% (averaging 55%) for a slow, even dry. Temps are kept between 20–23°C, with frequent venting to keep it below 21°C for terpene preservation. After 7–10 days, when small stems snap with a characteristic sound, I’ll trim and jar them with humidity sensors. For the first two weeks, I’ll burp the jars twice daily, then reduce to once daily for the next two weeks. After that, I’ll monitor the RH sensors and adjust as needed. I’ll share the details after curing is complete. After drying, I’ll weigh the buds, take photos, and share another post in a month or two after curing to report on the flavor and aroma. For now, I’m taking a breather, fine-tuning my setup, and preparing for my next grow: Wizard Trees - Zangria S1.
Likes
21
Share
@NSABND
Follow
Hi there start of week 11 today 😏 today (Day 78) the weather is cold and very high humidity because of rain 😲😩😕 Day 79 same shit weather then yesterday with very high humidity and rain 😵😲😵😲😵 Day 80 autumn has arrived 😱😨😰 cold with rain and high humidity 😲😵😭 Day 82 there are no Updates sorry 😵
Likes
41
Share
Likes
11
Share
bueno hemos iniciado el dia de hoy con un transplante final de cada de estas niñas las he transplantado a un sustrato propio hecho por mi con los suficientes minerales y propiedades para qeu este cultivo sea una locura , solamente estoy con pulverixador
Likes
15
Share
@38PLAN
Follow
Le piante più grandi sono nella 3 settimana,le più piccole alla 1 e alla 2. Le più grandi hanno fatto il sesso ma ancora non fioriscono,fra poco somministreremo auxine naturali per dargli un pò di fgas
Likes
7
Share
@Dairon
Follow
Buenas a todos!! Ya las he pasado al armario donde estarán hasta la cosecha, en este armario hay más espacio y más w de luz, en este hay 300w, lo hago así para ahorrar energía, pues es ahora a partir de la 4º semana de floración cuando va necesitando más lúmenes para engordar los cogollos. Más tarde cuando finalice la 5º semana también pongo una luz UV para que generen más resina. Como veis ahora están más separadas, por lo que correra mejor el aire entre ellas, pero para asegurarme de que no aparezcan hongos lo mejor es prevenir y usar Leaf Coat pulverizando vuestras plantas desde que lo uso no he visto ni bichos ni hongos. Voy aumentando La EC poco a poco, el PH lo mantengo a 6.3 pero lo subiré a 6.5 a lo largo de esta semana, voy alternando un riego con nutrientes, uno con agua solo a 0.45EC Plantas con una buena forma, buenisima distancia internodal, el único fallo es que el tallo es débil, por lo que tendré que poner tutores en el proximo riego aprovechando que está blando el sustrato, ya mismo se empiezan a ver los cogollos!! Saludos!!😃
Likes
3
Share
@AndrewC
Follow
So this experiment is going terribly! LOL This ulitmately taught me a few important things about this sytle of growing. 1.) My Frequency was way to high in the beginning. When i start over next, i will be going for 1 hr -> Spray for 1 min -> Wait 1hr (Repeat) 2.) Never reuse hydroton or CC. It ends up having left over material and nutes in it, which not matter how much you wash just make the soil a land mine of nutrients etc. 3.) Do no use rockwool cubes inside the medium, they hold onto water for too long leading to rot. 4.) Fill the buckets up right until about 2cm short of the nozzles that spay. Otherwise you lose too much water and nutrients to the misting, which spreads your nutes all over the enviroment. Ultimately, even though this is a living disaster, I have learnt valuable lessons, and who knows, some of them still might produce smokable flower!
Likes
13
Share
@Limelight
Follow
This week kicks off 6w of flower for unknown and she’s going!!! Super excited to see the trichomes increase because I’ve had two days where, it was very unexpectedly hot and could do little to nothing about it even with fans. So she definitely suffered from heat stress but, the super low temperatures (constantly 😍) after that has made up for it. I believe the best is yet to come with this lady but, I’ll continue to play it cool and safe with her! She’s also very resistant to low temps compared to wwa. This week also kicks off w11 for wwa and she’s also living up to her name (so I’ve read 😏) with, the increase of trichomes over the last week! She also suffered from heat stress but, has bounced back amazingly and is fattening up. She’s also looking to be very purple (due to low temps) I believe I’m a few weeks out but, continuing to slow roll things! Thanks for stopping by this week 👋… Have a great day reader ✌️😎😎.