Likes
Comments
Share
All three plants are happy and showing a nice layer of trichomes. Still in 2litre pots.
Likes
12
Share
11/06 Day 45 Temp 25c Humidity 57% Not a lot to report, I'm going to leave them be until their next feeding on Sunday 12/06 Day 46 Temp 27c Humidity 60% 13/06 Day 47 🌞 Temp 28c Humidity 67% Ordered another Spider Farmer light. This time the SF4000. Combined with the Sf2000 I'm currently growing under it'll be 600W or as near to as possible. It should arrive in time for flowering at the end of next week. 14/06 Day 48 🍼 Temp 27c Humidity 65% Fed the monsters 1.5L of solution each. Retrained and defoliated the lower fan leaves and removed some new tops that are appearing in order to create more space between branches Another two weeks like this and I'll switch them into flower 15/06 Day 49 Temp 28c Humidity 59% Slight tweaking of the training I did yesterday. Everyone looks happy and growing in the right direction. 16/06 Day 50 Temp 28c Humidity 59% Left the ladies to recover and compose themselves today. 17/06 Day 51 Temp 28c Humidity 59% trimmed a few nodes of one that was injured so I let it to grow out a bit more and recover
Likes
8
Share
These are my first CBD strain So allow they grow the same I can’t wait to try the bud :)
Likes
56
Share
@Aedaone
Follow
The temperatures, humidity, height, and watering volume(if measured) in grow conditions are all averaged for the week. The pH is soil pH. Any watering done by me is well water which is 7.6 pH and 50° F. Any listed nutrients are ml/gallon of soil to be spread evenly on top of the soil. Day 1 we had a high temperature of 88°F. We had on and off rain and thunderstorms throughout the day. The rain took care of the watering. The #1 and #2 plant responded well to defoliation and treatment. The #3 plant will have some more leaves stripped and everyone will get treated with Growers Ally again tomorrow. Day 2 we had a high temperature of 94°F with clear sunny skies. I watered about 5 gallons from the well. I treated these again with Growers Ally fungicide. The warmer nights, blazing sun, and this fungicide have really cleared up that powdery mildew. They've also decided to go all in on flowering. Day 3 we had a high temperature of 94° with sunny skies. Heat index was over a hundred. It was super hot today. I watered twice about 8 gallons total. Everything looked good after treatment. Day 4 we had a high temperature of 95 and partly cloudy skies. I watered twice about 4-5 gallons each time with well water. Day 5 we had a high temperature of 91°F with partly cloudy skies. I watered twice today 4-5 gallons each pot, each time. The #3 plant is still having some pm on a few of the lower leaves. The other two look great after treatment. Day 6 we had a high temperature of 88°F with sunny skies. I watered 5-6 gallons each pot. Day 7 we had a high temperature of 93°F with sunny clear skies. I watered 4-5 gallons each pot twice, from the well. This week was a success. The girls survived the powdery mildew outbreak. The Growers Ally worked great. They're continuing to grow tall. I can get my tape up there, but they're so tall I can't reach it with my step ladder to take the pictures. The super hot weather this last week just turned them on. They are loving it.
Likes
7
Share
@Naujas
Follow
great!!! the girl gained momentum :) and started growing rapidly :) she looks healthy, maybe a little sad, due to the lack of space for roots and leaves, but I believe she will get used to it :) good luck to everyone:)
Likes
7
Share
@GYOweed
Follow
Fucking leaf hoppers. This one was so long I thought it was a caterpillar at first.
Likes
5
Share
Ya la gorila se fue de corte al final de la octava semana, las big bud ya comienzan a amarillas las hojas dando aviso de que a funcionado el lavado de raíz y están consumiendo sus propias reservas de nutrientes.
Likes
7
Share
Ouh wee! This is probably the loudest auto run I have ever ran!
Likes
19
Share
First time grower, criticism will be well recieved😀 Two plant ebb and flow setup in a 3x3 as a test run Top feeding until I can afford the rest of my setup🙄 Started seed in water balanced to 6.0 Sat. Feb. 29th Tap roots within 12 hours, directly into pre soaked rockwool cubes. Broke the surface march 3rd. Began 1/4 strength micro, grow, bloom and stress relief Using very hard water for the next couple days, roughly 450 PM out of the tap. Ro system to be installed march 6th Ro system now installed. Start of week 1 will be Saturday the 7th of March. Day 2: Turned the light down to roughly 50%, instead of raising it, due to the fear of light burn. Will look into it soon. Plants seem to have recovered after I decreased the light intensity. Fan and filter purchased. Alternating flush and feed cycles 12 hours apart to keep salt sats down. Day 3: Bumped light intensity back up to roughly 75% of the ts1000's capability or 700 "light units" from a cheapy 3way meter. Adding as much co2 as I can through baking soda and dilute phosphoric acid. Day 4: Exhaust fan with climate control installed March 10th Day 5: Girls exploded now that I have my salt build up figured out . Day 6: Light back up to 100% Day 7:little droopy on the one plant, gonna let them dry out a day Setup should be complete for start of week 2.(actually sick right now and having trouble getting supplies) Still need a flood table setup.
Likes
11
Share
Likes
30
Share
week intel: we reached the peak of flowering stage and need to cause a little more e.c stress from this week so e.c stress is twice a week i reduced the amount of Nitrogen and calcium and stopped feeding silicate in other hand i raised the amount of base nutrient and booster short story version: more K & P - less N stresses : a little E.C stress around 1 and 1.2 twice a week from this week feeding: i feed them 3 times this week with this order : day 1 : i feed them high with base nutrients(calcium & micros (half dose) + Bloom) about 566 ppm - 1.1 e.c to cause a little stress. day 3 : i feed them low dose of Top-Max + B-52 around 392 ppm - 0.7 e.c to let them recover a little but not fully recover still a little stress will caused. day 5 : i feed them high dose of Feeding Booster around 630 ppm - 1.2 e.c to cause e.c stress again guide of the week : e.c stress if done correctly is one of the very few ways to increase quality in all aspects ( color , aroma , taste , bud structure , resin contents ) but if you over do it , listen carefully brother : it can reduce quality in every aspect so always look for signs and never reach the red line
Likes
30
Share
@SAC87
Follow
Day 8 Flower Hi growers, the end of week one has arrived. The plants seem to be happy. They’re starting to shoot up, new growth has that light green color, old growth is still dark green. I fed with Remo transition feed and and added green planet rezin. I think I may have been under watering as I realized there’s way more than 20% perlite…maybe closer to 45%. I’m going to start watering every 2 days, more coco style rather than soil with a dry back like I normally do. I think that could be the reason for the slower growth in veg regardless of light height and intensity with optimum environment and vpd. I was going to weave the new growth into the open squares, but historically it has caused those tops to be shorter at the end. So if they grow tall, I’ll add another level of trellis net and fill the squares of the upper net. Until then I’m just tucking the leaves on this very leafy plant. Heavy Defo will be on day 14. She has got a stank to her already. When watered or manipulated she has this skunky sour smell that I’m already intrigued by. Still have 2 months and 1 month of cure to wait ugh…..patience 👎🏻 I am having a bit of difficulty dialing in the Vipar Spectra XS2000. It seems very powerful for my setup especially in veg, I’ll try 50% in veg next time. You can see how stacked the buds are in the pics. I’ve raised it up 6” from the top of the tent to hopefully get some stretch. It’s heat output is good at keeping my tent at 77-81 at 100%. I am very interested to see how it grows the FastBuds autos once the SLH is done. That tent will have the XS2000, FastBuds Autos grown with Gaia Green Organics. I’m thinking that will be a solid hand. 🤞 Happy Growing 🌱 #Viparspectra #XS2000
Likes
2
Share
Update week 2 of Bloom
Likes
16
Share
@Andres
Follow
Purple afghan kush 1...she has taken her purpyra color ... there is very little left for her to be able to taste this variety ... she has a smell of tender wood ... sweet smell ... she did not grow enough but if she dedicated herself to fattening her head ... purple afghan kush 2 she had about 15 worms ... look for them one by one ... she did not grow well from the beginning ... I do not know what happened to her growth and flowering ... her buds are small ... let's hope she tastes good ...
Likes
78
Share
@Hou_Stone
Follow
🌺👋Salut les amis, 🌺Nous sommes au 48ème jour de floraison ce 11/11. 🌺Je suis stupéfait par ce changement de couleur sur les feuilles, j'espère que les bourgeons seront bien gouteux 🤤 🌺Après avoir obtenu un peu plus d'informations, je sais que j'aurais pu mettre plus de nutriments dans mon sol. C'est prévu pour la prochaine culture.👌 🌺 🌺❤️️Récolte prévue pour la semaine prochaine ! 🙌 🌺 🌺🤲Avec les feuilles et les plus petites fleurs je prévois de faire du Ice hash avec des bubbles bags et une mini machine à laver. 🌺Je partagerais ça prochainement✌️🎥 🌺🌺🌺🌺🌺🌺🌺🌺🌺🌺🌺🌺 🌺Intensité de la FC3000: 90% 🌺Ventilation : Extracteur mars hydro 6 pouces avec filtre à charbon puissance : 4/10 (24h/24h) + 2 ventilateurs à l'intérieur ( ON 10/24h). ils s'activent à un horaire différent. 🌺Arrosage : J'ai arrosé une dernière fois avec 1.5L d'eau et je vais laisser sécher au moins 5 jours avant la récolte. 🌺Température & humidité : NUIT : 15°C & 60% / JOUR : 23°C & 45% ❤️️Mon instagram 🌱 https://www.instagram.com/hou_stone420/
Likes
5
Share
@Nune2021
Follow
Hey bin mal gespannt obwohl ich nicht all zu viel erwarte der Wuchs bis jetz hält sich in Grenzen aber ich denke durch den Kleinen Topf ist das Wuchs Wachstum stark eingeschränkt Aber mal sehen ich lass mich überraschen 😂
Likes
14
Share
@BLAZED
Follow
Week 1 (31-1 to 6-2) As for my waterings, i give RO water, with 0.50 grams of Calcium, and 0.2 ml of Atami Rootbastic a liter. Growdiaries wont let me put my nutrients in grams so i'm forced to choose mililiters. 31-1 Watering: 20 ml. They are stretching quite a bit. I turned on the fan on the lowest setting for some air movement. 1-2 Watering: 20 ml. 2-2 Watering: 20 ml. 3-2 Watering: 20 ml. Heights: Kush#1: 9cm Kush#2: 7.5cm 4-2 Watering: 40 ml. I attached a wire to the Kush#1 for extra stability as it was a bit fragile in combination with the fan. 5-2 Watering: 20 ml. 6-2 Watering: 60 ml. Heights: Kush#1: 10cm Kush#2: 8.5cm
Likes
8
Share
Very happy with the outcome just as good as the first time I grown this strain!!!!