These girls are LOOOOONGG! The stretch has been like no other I have ever seen! 2 of the plants are well over 2 ft. tall, one of which was already super cropped at the beginning of flower because it had a few mains a little higher than the rest on it. The other 2 aren't too far off though, they're right there with them. I've been out of space in my closet horizontally for about the last week or so, and was quickly running out of vertical space as well so I upgraded spaces to a new AC Infinity tent, 3' x 3' x 6', ANDDDDDD come to find out I'm rapidly approaching the ceiling of that already on day 1 in the tent! We're almost at 3 full weeks flowering (since light flip) so I'm hoping like hell this stretch is over or about there because if not, it's going to be a super long 6-7 weeks, smh 😳. And sorry for the booboo quality video, my phone was being weird today.. Enjoy the update me maties 🏴‍☠️

The plants have reached a stage where they have enough foliage and growth on them to begin training and defoliation. I cut most of the side growth and major fan leaves off. Using safety pins and twine, I started their LST.

🌿Week 4: Defoliation & SCROG Setup Week 4 was all about structure and airflow. The canopy was getting bushy fast, with a ton of inner growth, so we went in for a solid defoliation session across the board. Lower fans, overlapping leaves, and shaded internodes were cleaned up to let light penetrate deeper into the canopy and reduce potential humidity traps. Right after that, we finally dropped the SCROG net, stretched out gently across the canopy to guide the branches horizontally and prep for flower stacking. Some of these phenos are already reaching for the sky, so the timing felt just right. Captured a full-time-lapse clip of the defoliation + netting process. It’s super satisfying watching the chaos turn into clean lines. Nature meets intention. Feed Bloom since 20/6 22/6 Defoliation 🌱 Plant Response: After defol, they bounced back fast. Tops are perky, leaves are praying, and stretch is continuing in a controlled way. The structure’s more open now — better airflow, better light distribution, better everything.

Pues por último vamos a terminar con actualizar las red hot cookies de sweetseeds, que me parece que son las primeras que recibirán machetazo. Ya están recibiendo los últimos riegos con fertilizantes agrobeta, y pronto les tocará el lavado de raíces y el estrés hídrico para que termine de marcar bien todos los tricomas. Como veis empezaron ya a inchar, hay varias avanzadas pero todas serán cortadas el mismo día , así que solo toca esperar unas semanas más y pronto prepararé cosecha de red hot cookies. . La humedad esta al 45% la temperatura está entre 21/25 grados , y como siempre el ph , ya que es de lo más importante,está en 5,8/6,0. . AgroBeta: 1 ml x L Flowering black line , vía radicular. 0,2 ml x L Beta shark, vía radicular. 0.5 gr x L mega PK , vía radicular. 0,8 ml x L Terminator, vía radicular. 0,5 gr x L Engordacogollos, vía radicular. 0,3 ml x L Tucán , vía radicular. 0,1 ml x L Betazyme, vía radicular. 0,3 ml x L Tricoma, vía radicular. 0,05 ml x L Gold Joker, vía radicular. 0,2 ml x L Silver, vía radicular. . Hasta aquí todo familia 🕸️ , un saludo y buenos humos fumetillas💨💨💨.

Will be flushing this week and hopefully harvesting next week. Looking good, strong trichomes production and smell is incredible for both.

Week 4 flower !! Flowers are developing perfectly and she’s full of trichromes ! She’s also staring to smell really str

1st week of flower....the girls are looking great and are all confirmed females yayyy...I will definitely a little and let the ladies be happy this gon be some good quality medicine

2nd Week Report 24/10/19 - 31/10/19 25/10/19 I didn't flushed, but I filled the reservoir with 3l of 10% strength solution. Added to the current solution the same nutrients quantity as the first week (except for "Root Stimulator" and "Enzymes" that the first week were 20% strength and now got back to 10%). Now the reservoir should be filled with a 20% strength solution 29/10/19 - CMXL is 10cm height and it is growing really well along with his roots. - LSD is 6cm height and it is growing a little slower like his roots, but both of them look healty. I think in some days should start growing fast like CMXL Added 2 low frequency (113kHz) Ultrasonic Piezoelectric Discs: - One for the root chamber that should help with root expansion as it nebulize solution and the fog carries nutriments (like a small aeroponics integration) and will help my attempt of cloning. - One will stand in a 20% solution next to the plants to increase Humidity (and maybe feed them a little). I'll try to set them running 24/7 Switched water pump that sprays Rock Wool from 5sec every 30min to 6sec every 60min. Next week I plan to stop using the pump as "Top Feed" if roots will be well developed and probably I will use it as "Recirculation Pump" to keep nutrients in reservoir mixed better 30/10/19 Roots exposed to air inside reservoir got a little yellow after inserting the small fogger, so I will try to keep it 30/30 seconds ON/OFF. I will check next day if it's helpful to existing root o as root propagator for clone trial Topped CMXL and did a little of LST just by bending the main stem to expose the small growing next to fan leaves. The cutting was immediately dipped in a solution made by honey and Root Stimulation (the same I use for reservoir solution as it should contain rooting hormone), hoping it covers the cut like a gel and don't let the oxigen get in the cut until there will be some new growing. After that I put the cutting on the lid without any pot, as you can see in the picture some tape is covering the hole and it holding the topping. I covered it with a small jar to maintain humidity, hope to see some roots next week ;) I plan to fim LSD tomorrow if tonight grows enough 31/10/19 Filled the reservoir with 6L 20% strength solution and after that added 10% nutriment for 36L directly into the tote (like I did last week). Now nutrient solution inside reservoir should be 30% strength and it's ready for the 3rd week Pinched LSD Top with my fingers and applied LST by bending a little the main stem. Hope this FIMming works and returns better yield ;) Cloning trial didn't worked (I was expecting nothing, just a test), the cut part of the topping is already dry. I knew the topping was too short, next time if I try to clone his stem will be at lest 2cm Last Update 31/10/19 Next Update 03/11/19 with the next week See you guys ;)

I topped this one too jus tucking bigger fan leaves until i can fo some LST .she growing jus as good so my little experiment grow dots vs. Bottles is so far the same both have vigorous growth still early to decide but will definitely keep updating only issue when it came time to feed the other I forgot that this girl already got food on her plate and I poured jus a cunt hair of nutes on her before I realized I gave her growdots so I made me a little sign just as a reminder lol happy growing 🤙

New flowering continues to develop on this lady, she seems to be swelling up day by day. Yellowing of the fan leaves has started which usually means it's time to flush, I need to check the trichomes to see how amber they appear before I do just in case the flavour or yield could be effected.

VEREMOS UNAS PLANTAS PEQUEÑAS, PERO CON ILUSION YA QUE SON LAS ULTIMAS AUTOMATICAS, HACE 40 GRADOS AFUERA HUELEN MUY BIEN Y LAS ESTOY REGANDO CON 3 lLITROS DE SOLUCIÓN CADA PLANTA

6/15/2021 Girls looking nice, I'm planning on vegging for this week and depending on growth scroging and switching to flower by week 6. Mazar looks a bit behind, all because that starting hinder from having a cotiledon break.

Went away for seven days had a friend come by and water the garden Absolutely exploded since I’ve seen them last very pleased with all of the plants except for mystery auto number one. It is disappointing me some but hopefully the top will bring more growth. Can’t wait to see these continued to develop!!!

Changed the light for the Viparspectra P600 because the SP3000 was needed in my other tent, and the p600 is enough for that size of a plant and 24/7 light to which I then switched. I found a nanner, not happy about that, looked for more but did not find any, still quite sure there are more because they never come alone. Plant is not ready to harvest yet so... I hope for the best. Some buds are getting denser, plant is slowly bulking. As of now I am considering to chop in about 2 weeks. Raise EC as mentioned in previous week. Values are average of the day. DATE - EC(us/cm) 20250719 1755 20250720 1798 20250721 1900 20250722 1998 20250723 2082 20250724 2094 20250725 2103 DATE - PH 20250719 5.93 20250720 5.78 20250721 5.80 20250722 6.00 20250723 5.83 20250724 5.74 20250725 5.83 DATE - ORP (mV) 20250719 -34 20250720 -82 20250721 -95 20250722 -94 20250723 -90 20250724 -76 20250725 -68 DATE - °C - RH% (Tent Temp/RH) 20250719 26.6 59 20250720 26.3 61 20250721 25.4 60 20250722 25.0 58 20250723 23.6 61 20250724 24.2 61 20250725 23.6 64 DATE - °C (Reservoir) 20250719 23.8 20250720 23.7 20250721 22.9 20250722 22.7 20250723 21.7 20250724 22.0 20250725 21.8 DATE - CF 20250719 17.55 20250720 17.98 20250721 19.00 20250722 20.00 20250723 20.85 20250724 20.97 20250725 21.06

Ran out of Sesni Grow today.. will begin using the Connoisseur A and B beginning Wednesday. we went a full 4 weeks of vegging these after germinating and seedling stage for 2 weeks. They were topped regularly. nice bushes.

Well, this is another new journey with @FastBuds, I know they are great, so this time I will grow 2 girls in a tent, each one will have a separate diary, and here her first week has already passed, everything looks pretty good, in a week she will be transplanted into a 15 liter pot :).