I added a humidifier, set between 60 and 65% humidity. The work in the room is almost complete. On December 27, day 19, I start the Biobizz fish mix with 2ml per litre

se ve un crecimiento rapido de ambas cepas, se espera que antes de terminar la 3ra semana se aplique el apical a cada una.

the week went great! blueberries are poured, cones swell bushes noticeably grown I hope this is their limit and then they will only gain weight

Flipped with net about 90% full almost full now after abit of stretch. Gots change the rez today.

5 semanas y 4 días de flora

July 4: topped both plants.

Plant is growing fast now. The hot days are back, but we are still going strong.

11/17 Week 10 Ripley - Starting her on the Soul Peak very soon, low dose 5ml see how she takes it will reduce CocoTek on just her by 3ml/gal at that dose. Keep defoliating her gently, dozen of so leaves every day or so just to keep buds open to light. No visible problems Tara - The Beast - Ok now it officially the largest plant we have grown to date. With the pot its hitting 4 ft 8 in without 3 ft 2 in. The stretch has finally slowed to a stop and buds are beginning to quickly build... thank you God. I was really wondering what I was going to do next. Am going to have to bind her up a bit just for support tomorrow as those buds get heavy and she needs to give Ripley some room. Also cleaning the heck out of the lower end tomorrow. Keeping her CocoTek at current level with a Cal-Mag foliar every few days 1/19 Foliar Cal-Mag feed on Tara Cleaned out the bottom of Tara, first pass at least see how it turns out. Decided to put Tara on the same feed as Ripley see what happens as Ripley is building buds faster with the PK cant say that would hurt Tara, No def so may as well May be early but heck what do I know, on new ground here 1/20 So far so good, cleaned up Tara a bit and bound her up to give support and room for Ripley. Buds building nicely crap load of them Ripley doing well in the pK so will continue her protocol by slowly reducing CT and inc PK 1/21 Noticing some mag def on Tara and random Ca spots so getting a dose of Cal-Mag 3ml/gal as well as the foliar. 1/22 3ml/gal CalMag added to Tara feed reduced CT 2ml/gal Ripley on 5ml/gal CocoTek AB and 10ml/gal Peak getting her ready for flush 1/23 Going to try alternating between adding 3ml Cal-Mag to Tara's feed and foliar with same. Not a bad Mg problem but obviously one I cant ignore given its Ca as well. Ripley on 6.1 Water and 15ml/gal Peak one more day then flushing to start week 11

Hey folks, I'm finally back at it again. It took me a while for a couple of reasons: 1) I usually only grow in the winter. 2) I completely revamped my grow room after the issues I ran into with the last setup. 3) It took me a while to brainstorm exactly what I wanted to do. I bought these seeds from D.C. Seeds and was very pleased with the experience. I'm very happy to give business to a fellow American and Veteran. I've only ever purchased seeds from the UK in the past and that experience has been "dodgy" to say the least (not the vendors fault, but the transit). I've only ever grown photo's, but chose to go with all auto's moving forward. After calculating the intensity of my current light, with it being on a 20/4 rotation I'm very close to hitting 40 moles per day, at least directly under the light. It doesn't quite cover my 2' x 5' trellis. I'll eventually upgrade my light, but auto's should get me the best bang for my buck with this light. Also, I spent a pretty penny building this new grow room. The other obvious reason for growing auto's is their shorter seed to harvest time. I've got a small grow area, and never plan on expanding. Theoretically, auto's will allow me to produce the most out of my room. A few things about my grow room: 1) I lined the whole closet with 1/2" plywood and put that piece of ply the air intake/outtake/power as the divider between each side of the closet 2) The grow room itself has ply on all wall surfaces so I could mount stuff to it and paint it 3) The other side of the closet is my storage/prep/power distribution/etc. area. Maybe I'll take a pic one of these days 4) My last grow my carbon filter/fan was venting into the other side of the closet. This created a headache for a number of reasons. I tapped a 4" hole through the floor and am now venting into my crawl space below the house. 5) I moved to bubbleponics to speed up my grows even more. I will be removing the drip system once the roots hit the water in the res. 6) The larger res. will hopefully make my life much easier. Late in the last grow I could only fit 3 gallons of water in the bucket and that sucker was pounding down at least a gallon a day. That required too much micro-managing for me (both ph and refills). 7) I no longer have a fixed trellis with chicken wire. The trellis is held in place by dowels that I can pull out by hand. The short sides of the trellis have hinges on the bottom, so I can fold it and pull it out easy-mode. Lastly, I'll be using string for the trellis so come harvest all I have to do is cut the string instead of dealing with trying not to destroy buds pulling them through chicken wire (it takes forever). 8) I built a light diffuser on the other side of the air intake 9) My res. is on a motorcycle lift I'm using a drill to move up and down I have now started using Jack's as my primary nutes. They tell you the full break-down of each macro and micro nute, giving me more control and understanding. I think House & Garden is a good product, but when stuff goes bad it's more difficult to troubleshoot when you have no idea what each piece of their full lineup contains. I'm assuming it's kind of a proprietary type thing, which I understand, but knowledge is power. I am still using their Drip Clean (while the bubbler is going) and Roots Excelurator Silver, both excellent products. I'm still using Hydroguard, and will FOREVER. I'm a true believer now of why Hydroguard is necessary for any hydro application, IMO. I also purchased water soluble fulvic acid, but have decided not to use it for this grow....or at least while the bubbler is going (I'll elaborate below). Ok...now that all that is out of the way.... I really wanted to use my well water instead of R/O to make my life easier. Soooo....I filled up my res., and put two seeds in the system immediately. Nothing happened after 1 1/2 weeks. I finally opened up the cubes and saw that the beans had popped, but it looked like maybe I drowned them, or they ddin't grow straight up or something. For round two, I didn't change the water out, and decided to soak the beans for 24 hours in R/O water first. I had the exact same problem. I'm still not really sure what happend, but I suspect it was the well water. My PPMs were sitting at ~500 with the well water, which was probably too spicy for the beans just starting. Also, my well water is questionable (even though it's at 165ppm), but I won't elaborate further....it's a long ass story and I've spent an absurd amount of money on it. Lastly, I did put the Fulvic acid in, and it was very messy. I really want to avoid having to clean my res. Once the roots get big it will be a real pain in the ass to clean. I'm leaning towards not using the Fulvic acid this grow just to see how things go. I had 10 beans total of the Sour Apple and have already ruined 4. So here's hoping third times the charm. So, I went back to my tried and true method: 0) R/O water for everything. Ditching the well water idea. 1) Soak beans in R/O water for 24 hours 2) Paper towel method between plates on a heating mat 3) Once the roots pop, I place them pointed down in the hole of the rockwool cube 4) Hand water once a day by dipping the cube in the pre-mix of 1/4 strength Jack's and everything else I've listed above. This put my PPMs at 300...a way more reasonable value for starts. It's been exactly 7 days since I followed the above. It's probably hard to see but the cotyledons came up, and multiple roots have come out the bottom of the cubes....way faster than I've ever seen since I started growing. That means even though I'm doing my old process this already shaved at least a week off of when I'd normally put it in my bucket in the past.

Juju grow 2ml Juju flowa bloom 3ml Juju Greenmystic 2ml 1l Water First flowers are incoming

Il "super cloner" aeroponico, svolge il suo compito eccellentemente!!!! Sviluppo vegetativo e radicazione esplosivi!!! I fertilizzanti"Advanced Nutrients" si confermano i migliori (la spesa vale l'impresa). Il controllo totale dei parametri di coltivazione, si confermano vincenti! I cloni sono pronti per essere trasferiti nell'impianto RDWC di crescita vegetativa e fioritura.

Hi Growmies, My apologies for the delayed update, but work life balance got a bit out of wack recently. Anyways, water was changed on time and general maintenance took place. Continued with very light defoliation to really guarantee that all the shoots get equal light exposure. She is turning out to be a real beauty and literally no Scr.O.G was necessary due to her natural structure. Buds are already forming very compact and dense to touch, something that’s always a good sign ;) Since this is my first proper DWC grow I am actually quite impressed by the root growth and the resulting nutrient uptake, as well as vigor in plant growth. Is it btw just me or is this website getting slower, buggier and laggier by the day? Videos won’t upload, weeks don’t reflect, diaries won’t update….

I cut this early and saved the genetics by re verging it out again I will run this again in a few months. All 4 plants I got 350 grams of dry flower

So she started to show signs of pre flower :D :D now Im going to be starting up the flowering regiment of nutrients getting her ready for her road home ! So far so good she's doing really well and I think Im going to get a decent harvest from her :D :D :D A big thank you to everyone who stops in to the diary's and show's their support you guys ROCK !!! -Happy Growing!

Another good week. Watered them twice. I'm not planning on feeding them again. A little defoliation. I definitely think they are in the last 2 weeks before harvest. Still seeing some nutrient burn developing on the leaves. I don't think I watered enough through the whole grow! I'd love to hear opinions on this! Took some videos of the buds with an iPhone 12 at 6X magnification. Decent quality! Otherwise, still looking to successfully harvest these plants! Thinking about the next grow. Probably going to be Auto Strawberry Cheesecake and Auto Anesthesia. Peace!

relaxing and enjoying the show almost at max watts SPIDER FARMER SF2000 is now maxed out at 207w , 16"-18" from the plants and I will need to keep up with pruning to allow more air flow and more light to penetrate deeper into the plant. 2, 6" oscillating fans on 100%, may be on low or just one stationary but at this point in the grow air flow is a MUST, specially for the thick, dense vegetation of the OG Kush. trying my hardest to stick with the 4" ventalation til the end of the grow. Right now I have to replace the exhaust ducting due to tiny pin holes leaking more than a bit of light.

Welcome to my Apricot Auto Diary sponsored by Fastbuds & Xpert Nutrients. Day 57-63 Week 9 Last of fattening & some of ripening left of this stinky colorful gem. Possibly the best auto I've done from Fastbuds. Plant reacted really well in her fattening stage. This is her last week. Just sugars/sticky fingers & enzymes. 450ppm. Still drinking good. And will let her finish up with what's left in the pot. She is stunning as is. Nutrients Pult off everything except sugars, and enzymes. 450ppm (no NPK ppm) ph from 6.1 to 6.7. 15c 700ml. And then just water, 700ml a day, slowing down to half that on her last days. DLI 49 959 ppf over 13hrs. Lowered from 55+. Harvest after 24hr dark rest. Thanks to my sponsors Fastbuds & Xpert Nutrients. Much appreciated to all my viewers. I look forward to seen your diaries. Either way thanks for dropping by. DISCOUNT CODE FOR XPERT NUTRIENTS CODE:GGST 20% OFF.

I gave this beautiful girl LST and defoliation, let's see how she copes with the sters, she feels good 💚🤘