🌿 LA Punch by The Cali Connection 🌿 Week 14 Flower week 8 Flower-day 1 3/12/25 ( pisitils showed 25th of October) im timing from pisitils showed but diary runs from 12/12 light flip No nutrients change today, I'm thinking about 2 weeks or so of feeding, maybe 2 more horti rawk doses before switching out to new millennium winter frost then onto flush with plain water/ph Not sure, not sure. Maybe even give LA and Grape an extra week to get Bellini over the end instead of pulling a little early or pulling her as shes finishing up. Next horti rawk dose probably saturday (48hr run ) then dump then new nutrients. 6/12/25 This is currently week7 day 1 flower from 6/12/25 ( pisitils first shown ) 8/12/25 Will dump nutrients tomorrow and refill with winter frost, run for 7 days then flush for 7ish days 9/12/25 Dumped nutrients, winterfrost 500ml ( 10ml a gallon) will use for 7 days then flush for 10 or so

It’s not getting attention. But I water it when it’s in need but I’m not sure how much light it gets. Putting the F1 Milkyway to the test! I may have to try it in a bigger pot at some time if it delivers under these circumstances. Update: While I lightburned my other plants, this must have been in a better position than i first thought. But it cost me alot on the other plants I got :/

Parti au séchage mercredi passé. Fleur bien compacte et de belle grosseur . Odeur de pelures d'orange très fort.

Después de qué las dos sherbet no se dieron, aprovechamos la llegada de un par de Gorilla auto BSF y procedimos a germinarlas. Asi van al dia de hoy! 8/07/2024

Day 36: "Hey everyone! Just a quick update: I removed a few more leaves here and there and did one last round of LST (low stress training). 🌿 The plants are looking great, and I'm going to let them recover now before sending them into the flowering stage. I'm really excited to see them start blooming in 2-3 weeks! Also, a quick update on our temperature issue: today, the temperature stayed below 26.8°C, which is great news! However, we still need to find a solution to keep the humidity levels up. Our 360 m³/h exhaust system isn't able to maintain the required humidity level. I've calculated that we need a humidifier that can evaporate 1800ml/h to maintain 60-70% humidity, which would help manage the temperature better. Does anyone have tips for a good humidifier or other methods to control the humidity and temperature? Any advice would be greatly appreciated! Day 37: Hey everyone! Tomorrow, we're planning to buy some Cal-Mag because we suspect the yellowing leaves might be due to a calcium-magnesium deficiency. We're also going to get a pH test kit to make sure everything is balanced properly. Do you think this is a good idea? Any tips or suggestions would be greatly appreciated! Day 38: Hey everyone! Quick update: it turns out the yellowing leaves were due to a nitrogen deficiency. We increased the fertilizer dosage today, so the plants should start looking better in 4 to 5 days. 🌿 Thanks for all the support and suggestions Day 39: Hey everyone! Another quick update: after increasing the fertilizer yesterday to address the nitrogen deficiency, it should take about 4 to 5 days for the yellow leaves to turn green again. 🌿 We're already seeing improvements! The plants have grown significantly and are developing a dense canopy once more. It's great to see them bouncing back so quickly! Day 41: "Hey everyone! Quick update: we've removed the bands we were using for LST (low stress training) and are now letting the plants grow freely. 🌿 We plan to keep them in the vegetative phase for about one more week before transitioning them to the flowering phase. Excited to see how they continue to develop!"

Getting close. It’s extremely sticky snd smells divine.

Hi Guys. Here we are starting week two, the news is: - My 60x60x140 Senua tent, 3gl pots, VIPAR P1000 Light, and the fan have arrived. So, two of the little ones I put in the new pots, the other one I will try to grow as a Bonsai, the bonsai pot will arrive in two days, so I am really excited to start the bonsai project, I am thinking about creating a Diary for that. :-) The biggest one (in the photo) is showing some yellow parts in the leaves, is that an issue? Another question, I used the Nutrients as the information on the label, is that too much? Thanks guys, I will appreciate any help :-)

Last week, 2 irrigations, gave her plain water. Beautiful colours, it was a pleasure to grow such a pretty plant, production is going to be like 10 grams i expect, Cloudy days and bad weather while growing and flowering, but quality seems pretty good, she is so frosty and smells like fruits. 1 week of drying, and curing at the moment. Put the weed in jars with Boveda 62. Im making a harvest post with the smoke effects flavour and all the stuff, so you can get more details about the high, flavour and quality. Harvested 1/07/2018 Good vibesss

Unfortunately, I had to find out that my account is used for fake pages in social media. I am only active here on growdiaries. I am not on facebook instagram twitter etc All accounts except this one are fake. Flowering day 20 since time change to 12/12. Hi everyone 😃. The lady continues to develop very nicely :-). The buds get thicker and look tastier 😅. This week it was poured 2 times with 1.2 l each time. The tent was cleaned and everything checked for functionality. Have fun and stay healthy 🙏🏻 You can buy this Strain at : www.Zamnesia.com Type: Runtz ☝️🏼 Genetics: Zkittlez x Gelato 👍 Vega lamp: 2 x Todogrow Led Quantum Board 100 W 💡 Bloom Lamp : 2 x Todogrow Led Cxb 3590 COB 3500 K 205 W 💡💡☝️🏼 Soil : Bio Bizz Coco ☝️🏼 Nutrients : Green House Seeds Company Powder Feeding Bio ☝️🏼🌱 Water: Osmosis water mixed with normal water (24 hours stale that the chlorine evaporates) to 0.2 EC. Add Cal / Mag to 0.4 Ec Ph with Organic Ph - to 5.8

Bubba Kush Mintz great great. She has some nice dense looking colas on her. Lots of frosty goodness awaits. She will be going to ph water in a few days. Then the next update will be her harvest time. The grow has gone well, Bd now time to reap the rewards. Thank you Aeque Genetics, Athena, and Spider Farmer. 🤜🏻🤛🏻🌱🌱🌱 Thank you grow diaries community for the 👇likes👇, follows, comments, and subscriptions on my YouTube channel👇. ❄️🌱🍻 Happy Growing 🌱🌱🌱 https://youtube.com/channel/UCAhN7yRzWLpcaRHhMIQ7X4g

Well I chopped this lady today at week 11 day 5 she smells and looks fantastic Smoke review : The hit is very smooth due too the extra long flush I did , and although the smell isn't great yet because it's now right at the start of cure , It's a nice body glow with an intense head trip with a mellow bubble , And that is after a small bong , I really like it , I would recommend growing this and would grow again , thanks for reading and following if that was you , Stay medicated and be bless Jah Rastafari blessing and love And the buds are nice and dense , will update once dry and cured :)

420Fastbuds FBT2309 Germination Week Time has come yet to start another amazing Tester strain from 420Fastbuds FBT2309. Started germination on 2/7 by soaking the seed in just water for 48hrs then planting it directly in the soil (Roots Organic 707) in a 3gal fabric pot. I spray the top soil with my gallon sprayer keeping it moist for the next week. After 48hrs in the soil we have sprouts that emerged that appear to be healthy and happy. All in all Happy Growing

They are looking good. I have not been changing reservoir as often as I should be. They have bulked up faster than any other plant I have grown. She looks frost. Smells nice. I changer nutrient solution today.

Update 12/8/2021 Keep on Rocking!😎 having a hard time getting the climate at a constant lvl. doing the best I can with the equipment I have🙌 Update 15/8/2021 from day 43 on i've started to add Calmag to each watering. but after a couple of day's it seems new leaves are still getting brown spots. not really sure what to do.. The nutrient schedule I'm using 1/4 of what is recommended by the Bio-bizz schedule. all plants are given the same amount.. 3 of them are showing some deficiency's and 1 plant is looking really healthy. Update 18/8/2021 Hello Folks.. pffff deep breath My plants are really suffering.. only 1 is doing a really good job. the others really look sick. leaves starting to yellow cetting curly and crunchy.. I did pluck away most of the dead leaves but at this rate there is going to be nothing left 1 one week. I have no real clue what's going on as it's looks it could be several things. it really feels i'm constantly running behind the facts. I know this is my first grow and all and every decision I make will teach me a great deal for the future. Today I ordered a digital PH/EC/PPM meter so I can actually see what exactly is going on and make decisions from there. I am afraid the PH of 7 really blocked out the Nudes that have been given but I am not really sure so let's wait like 2 more days so i can start measuring stuff. the past 2 days it only flushed the plants with water at an estimated guess of 6PH. but the crappy analogue PH meter that i put in the soil still tells me the the soil has a PH of nearly 7. What I really don't understand is how 1 plant really doesn't show any symptoms while i gave every plant the exact same water/nutrients etc. Well fingers crossed. what a hobby🙌💪

Bonjour à tous les padawans et maîtres jedis jour84 arrosage avec 25 centilitres d'eau ph6.3 Jour87 arrosage avec 30 centilitres d'eau ph6.3 Jour88 pratique de la techniques du tronc fendu (videos explicatives) et arrosage avec 20 centilitres d'eau ph6.3 COMMENT FENDRE LES TIGES DE VOTRE PLANT DE CANNABIS Pour fendre les tiges de votre plant de cannabis, il vous faudra : Une lame propre et aiguisée (une lame de cutter fonctionne bien) Un mètre ruban Une ficelle ou un adhésif pour marquer les coupures que vous ferez le long de la tige Un crayon, une baguette ou une brochette pour séparer la tige une fois fendue 1. Tout d'abord, commencez par mesurer la partie de la tige que vous allez fendre. Il faut faire une incision d'environ 10–20 cm juste sous la branche la plus basse de votre plant. Utilisez un ruban adhésif ou de la ficelle pour marquer le début et la fin de l'incision. 2. Ensuite, prenez votre lame et faites une incision en travers de la tige, en commençant par le haut. Attention à faire une coupe propre, jusqu'au centre de la tige. 3. Utilisez votre lame pour tailler en descendant vers le bas, jusqu'à la marque inférieure de la mesure que vous avez prise auparavant. Essayez de tailler aussi droit que possible. Une fois que vous avez atteint votre marque du bas, laissez la lame au centre de la tige, puis utilisez un crayon/baguette/brochette pour ouvrir la partie coupée, puis sortez votre lame. QUEL EST LE MEILLEUR MOMENT POUR FENDRE LES TIGES ? Il existe de nombreuses théories sur le meilleur moment pour passer votre tige au couteau, mais la plupart des cultivateurs suggèrent de le faire à la dernière semaine de floraison. Même si certains cultivateurs recommandent de le faire dans les 3 derniers jours avant la récolte, nous recommandons de le faire un peu plus tôt (7–10 jours avant la récolte). QUELS SONT LES RISQUES À FENDRE LES TIGES ? Fendre les tiges est une technique à stress élevé très agressive que nous ne recommandons qu'aux cultivateurs expérimentés. Nous ne recommandons également pas de fendre les tiges sur les variétés à autofloraison, car cela peut être bien trop intense pour elles. FENDRE LES TIGES, ÇA MARCHE VRAIMENT ? Il existe un solide ensemble de cultivateurs expérimentés qui déclarent que le fait de fendre les tiges peut produire de bons résultats. Malheureusement, peu de données qualitatives le prouvent. Cependant, il semble que la fente des tiges soit originaire des Pays-Bas, où elle est pratiquée par des cultivateurs néerlandais experts depuis les années 1970.

Hi!!!! week #12. 1-2 weeks lefts Im waiting for the lower buds to fully flower. Stopped fertilizing 1 week ago, harvest is coming. ...........

Will post bud shots this evening. Overall royal queen seeds critical kush is a great strain! Would grow again. 0