Likes
Comments
Share
Hallo zusammen 🤙. Sie wächst sehr schön und macht keine Umstände
Likes
24
Share
Not really updated anything Things are looking dank
Likes
18
Share
10/23: Fed today with one, signal, sweet & sticky, silica, beastie bloomz, and a little ca/mg. 10/27: Fed today with one, signal, sweet & sticky, silica, beastie bloomz, kangaroots, and humic acid. Lowered the lights to no more than a foot from any cola..most are 7-9" away.
Likes
3
Share
I did a major defoliation and she took it perfectly…Her smell is slightly increasing as matures.
Likes
8
Share
@Cadman
Follow
So the nuggets are dense and doubling in size every few days, the trichomes are cover the plants and they are sticky. The Girls are thirsty, I'm topping them off every other day with 1.5 gallons of nutes, at this point I feel like all i'm doing is mixing nutes in the reservoir. By the time I switch over season two to the grow room, i'm going to increase the size of my reservoir to 10 gallon so I can spend less time mixing. I'll be flushing out the buckets in 2 weeks to give the girls fresh water for the final 2 weeks! My Burp bucket project worked out great. Thanks to several youtube videos those videos are much appreciated! I made a few modification to what I saw online. so here's the parts list: (1) 3.5 gallon Menards Bucket (1) Gamma Bucket Lid 18" Black Irrigation drip tubing 12" Fish tank air hose (2) Fish tank check valves (1) tee for air line (1) small fish tank pump I started out modifying the input, most of the videos I saw had a hose with a check valve just poked in the lower part of the bucket with pin holes and end tied off. What I did is I took the black tubing and circled the bottom of the bucket, then I took a small drill bit and drilled holes through the tubing about every 2 inches to disburse the air all the way around the bucket then I used a tee to connect the 2 ends of the circle and connected that to the tube entering the lower portion of the bucket. the next change I made was instead of having a short hose poke through the upper portion, I drilled a small hole and hot glued the check valve inside the bucket with only the top of the valve sticking out of the bucket. After you get all the hoes and check valves in snap on the Gamma Lid, Tighten it up and turn on the pump. I added the hoses going into the water so you could actually see that its working I plugged the pump into a smart outlet and set it to run for 20 min 3 times a day, so no need to manually burp your nuggets while they are curing. You'll also need to put a 62% boneva 2 way pouch in the bucket with the nugs to keep the humidity correct and optionally have a small hydrometer to verify, I'm going to mount one on the lid to be able to check it without having to open the bucket. unless curiosity gets the best of me....
Likes
11
Share
First sights of trichomes on leafs (sugar leafs)! No issues she’s growing good just a few yellow leaves on gc2. Looked like she needed cal mag, chopped the yellowed leaves and put cal mag 6 ml. Usually give cal mag every other watering but ima give them more often since I’m using dechlorinated tap water.
Likes
3
Share
Wir sind nun an Tag 14 angekommen. Heute habe ich mit dem LST angefangen. Temperatur bei 24C und eine LF von 65-70%%. Die Lumatek ist 40cm entfernt und auf 75% gedimmt.
Likes
10
Share
First week of flowering coming along slowly. Decided to get a second SF-2000 as it is really needed to flower what I have decently, on order hopefully I can get it before next week.
Likes
2
Share
Presadil som defčátka do finálneho 5.7l potu. Pustil som im zvlhčovačku a vlhkosť kontroluje senzor 65 Max 70% aby im bolo príjemné a mali radosť a samozrejme som im dal preventívne ochranu lepové dosky. Lepšie si dať ochranu ako mať potom trpkú zábavu. Zálievka 0.5l
Likes
26
Share
What a joy this grow has been. She was a real beauty. Absolute joy to grow...strong branches but she likes to stretch a lot. I knew wat to expect. I have grown Lemon Kush outdoors 3 times. The scrog this year was the perfect solution. I will not grow her again outdoors. This was my first time to see her finish. Seeing her flower this year, she just needs the warmth in the end. The climate here rarely offers that. I must say the dense flowers are amazing also size and yield is incredible. Update about that later. Trichomes were underdeveloped. I had to harvest early because of mould. The last 3 weeks of flower the temperatures were very low 10-15 C daytime and very very wet. I believe this stunted the plants. They made a full stop in development and exploded again in the last week. 3 days of sun did more than the 2 weeks before. Weather forecast were bad so big buds were harvested 25 september. We eventually had more sun than expected and bottom half was left until 2 october. That week made sooo much difference!! Those bottom buds finally developed some nice trichomes and turned purple. Of course I wish the big buds could have enjoyed the sunshine during that last week as well. Most of you will know, being an outdoor grower...Every year is about compromises. This year was so hot during growth and cold and wet in bloom that mould was unstoppable. After all I am very pleased with this grow and cant wait to taste some of this. Probably needs al long cure though to bring back that lemon scent. Almost seems like all that the rain washed the scent right off her😪 Keep growing y'all!
Likes
2
Share
@Kirsten
Follow
26.1.25: I have had a mistake 😕 i spilt some Fish Mix as I was experimenting with a syphon from some aquarium tubing I have. Unfortunately, I forgot to take the syphon out! Ugh 😣 However, it is fish emulsion and very thick consistency. Therefore, I was able to scrape it up with 2 of my business cards up off the counter. So added this extra into the next 2 ltr solution I mixed. All plants were watered with at least 1ltr of dechlorinated water PH'd to 6.3. Containing the following nutrients;- ♡ 3ml Seachem Seaweed ♡ 4ml Biobizz Fish Mix ♡ 4ml Biobizz Bio-Grow ♡ 3ml Biobizz Bloom ♡ 2ml Xpert Nutrients Bloom Booster ♡ 2ml Xpert Nutrients Cal-Mag ♡ .25g Ecothrive Biosys. ♡ 2.5g of Bicarbonate of Soda as PH UP. Unfortunately I have broken my PH pen too. Accidentally submerged it under water, then the readings went crazy. I'm leaving it to dry by standing it up but I'm most likely going to need a new one, which is extremely annoying 😑 I'm going start implementing the Scrog net probably some point next week if I let the plants that are in flower to just grow up now, as I do believe that I stunted Watermelon 🍉 by using too strenuous LST. Hopefully the plants still are able to grow upwards at this stage during flower for all the Purple Punch P1, P2 and P3. We will soon see! 28.1.25: My PH pen has packed up 😣 I've got to wait to get another. It's super annoying 😑 so I'm just judging by memory how to regulate it. Unfortunately, that's my only choice! I'm also out of the dechlorinator 😕 things are not going very well this week so far 😅 I guess we will have to make do, until I can get replenished. 29.1.25: I removed all the plants, hoovered, and disinfected the tent. There were several accidents when watering, causing some debris and splashes. I decided to just go ahead and get a few other things done. It's crazy how quickly things can become neglected! 😣 So I defoliated moderately on all plants except Gorilla Cookies seedling. I have absolutely dropped the ball on my lighting situation! My light was much further away than I thought! I turned it up to 100% and dropped it down to just under 2 feet away. After I reset the tent, I set up my scrog net. I removed 80% of all LST pegs. I am planning on letting the scrog net take over the training from here. I really want to minimise the risk of mould, so I decided to start using my dehumidifier. It has raised up to 73% RH this week, so it's necessary. Hopefully, I will be able to get my dechlorinator and PH pen soon! That's kind of essential to me. It's been a little bit of a stressful day in the garden, to be honest 😅 30.1.25: So I am expecting the arrival of my new PH pen today, as well as my new bottle of Ecothrive neutralise. It is supposed to measure the TDS and EC in addition to the standard TEMP and PH, which I had previously. Obviously, time will tell if it's any good or not. I realise, much too late now, that my lighting is very insufficient for this many plants. I need double the watts at least, and coverage is very poor. I remembered I had an old LED floor lamp, which was in a corner being unused. I decided to take the stand off, and Zip tied the pole onto the tent pole at the back left corner. I have no idea what the wattage is, and it's quite pathetic 😅 but I mean, I might as well use it, being as I definitely cannot afford more lights! 😣 Next grow, I will probably only grow 2 plants, max 4, and just use larger 7-10 Gallon pots. Being as I ran out of dechlorinator, I only watered some plants properly because I only had enough to make 6 litres. When my pen arrives, I will get everything properly watered. 31.1.25: The leaves of several plants are showing signs of iron deficiency. This is likely due to my PH pen packing up earlier. I now have a new pen. Due to this, I decided to use my Seachem Prime, which I use for my aquariums. As I wanted to get them watered properly, and my Ecothrive Neutralise hasn't arrived yet. I watered each plant with 1ltr of dechlorinated water PH'd to 6.0. I added .25g Ecothrive Biosys to the water. May give them a breather on the nutes and just use the Cal-Mag and Biosys. Being as I've just topped dressed with rich fertilisers, I'm sure that will be OK for the next several waterings. Bubble Kush
Likes
69
Share
1/24 Seeing balls I think :( - Welp - Confirmed they are balls, #2 has them also, not sure if LST caused to much stress or what. To much pride to just kill them all. I will continue this grow concealed in the 3x3. Honestly thought I was doing everything right. Going to leave them together, I got a auto water system to help keep tent closed more often. Doing this for the experience, will deep clean tent and all equipment after. I guess my goal now is to just finish her up, I'm 4 weeks through, going to try to use this bud for edibles, etc. This is for the people who had a hermie, wanted to continue growing it, but couldn't due to there conditions. Here ya go, this will be a fun run. If this isn't a good idea let me know LOL. 1/25 - (early morning) after a little researching and thinking, I think I'll just kill the hermies out. #2 had the same sacks. Going to keep a close eye on #3,#4, but so far they haven't sexed yet, ended up chopping #1, #2 for the better. Done buying cheap seeds, I have went through recommendations to find the best genetics and a more reputable breeder, very soon will start diary on that which I am very pumped for. With 2 of these out now, Planning on putting another strain in with them. I got a little unmotivated experiencing this, but figured rather fix it now then set my self back another 4 weeks. Hopefully we still have luck with #3, #4 will hope for the best! 1/30 - Since chopping #1, and #2 due to them becoming hermie, I definitely lost some motivation on this run. I still have been watering and adjusting canopy with trellis. They have definitely blown up since 1/25, and are giving me much more motivation moving forward. I gave them recharge today. I have started slight LST again but just bending the top cola so it won't grow higher then other colas. I have started another run with Brother Mendel Genetics, and will be starting another grow diary series on them. Look out for it. I do apologize for the late updates, I hope you enjoy the updated documentation. Closing this week out, Definitely had a roller coaster typa week but things are starting to look up. 👉Check out My Instagram for daily updates @Seed2Weed_YT👈 Will Follow Back, Let's Grow Together 💪
Likes
10
Share
21 days of flower.. getting some frosting on the upper fan leaves.. happy that the stretch was minimal and the canopy is pretty flat.. I think the super soil is a little hot but there’s a way to go yet 🤞😉👊
Likes
73
Share
Likes
5
Share
Diese Woche gab es ein paar Probleme, sowohl Salzaufbau im Substrat sowie Stress durch zu viel Licht. Der EC im Drain lag bei 3,0 mS und der Ph bei 7,5, dadurch ist die Kaliumaufnahme blockiert. Um da dagegen zu steuern habe ich ein Mal 6l Wasser mit CalMag und Ph 5,7 gegossen, um die Salzablagerung abzubauen. Außerdem habe ich das Licht wieder auf 75% gedimmt. Salzablagerungen sind zu diesem Zeitpunkt der Blüte relativ häufig, in Coco!
Likes
13
Share
Everything is going ok no roots yet on the clones but we got a week b4 we need to worry Temps steady humidity steady will be topping of res with more nutes todau
Likes
116
Share
@GMSgrows
Follow
Girls are growing strong another 1500 ppm 3.0 ec feed yesterday. Im not feeling well today so just a quick update. Thanks for all the looks and likes. It's a great growmunity here.
Likes
70
Share
Ich warte 10 -12 Tag für netto gram.