More defoliation and nutes this week, they are seriously getting hungry now! I ordered a new 30cm honeywell ground fan and dehumidifier to quickly solve the RH issues, I don't want to risk mold or other surprises.

7-600w led viperspectra 2-3500btu a/c units 1-6inch intake 1-6inch exhaust/carbon filter 1-4inch intake 1-4inch exhaust/carbon filter 21- mix bag plants / alien,granddaddy purple,hashplant,og kush 1-General hydroponics feed 2ml veg and bloom 1-first time grower

Some browning from start but cleared up in the next week

Esquejés

Welcome growers We finished week n°5 with these three SORBET#4 🌿🌿🌿🍧 The whole family reacted pretty well after last week's topping and looks very healthy and happy They have some differences, especially in terms of height.. There are two fairly identical phenotypes, small in size with close internodal spacing and deep green leaves The other, on the other hand, is visibly more grown in height and has a more "open" structure, typical of specimens that tend to have a profile more on the Sativa side. However, I am giving everyone the same amount and type of nutrients, which I will report later 😉 In this week i have reduced the lights cycle from 16/8 on/off to 14/10 on/off 💡 At the same time i have increase the intensity of my two led SP3000 from 50% to 75% and im going to put them at the maximum potency after the switch at 12/12 The two led panel are connected with a cable and i have only to adjuste the dimmer of one of them for change the intensity of each one, in just one move.. About nutrients 👇 In this seven days i still giving their always organic/veganic nutrients.. A little bit of silicium (Bionova) / Activator (Biomagno) / Crescita (Biomagno) / Activera (Biobizz) / Grow vegan (Bionova) / The Missing Link (Bionova) / X-Cell (Bionova) / Bioheaven (Biobizz) for the first time and a little bit of P-K 3-5 (Bionova) {not in spray solution but mixed with the othersone in to the water} Like i usually do, a little bit of everything at any watering 💧 Anyway.. I decided to take both photos and videos, basically so as not to bore you and me with the same things over and over again.. Hope you enjoy This was the last week before it officially went into bloom.. So stay tuned, the show is going to start soon 🎬 Thanks for watching 😎👍👍 FC ✌️ 🇮🇹

Already week 7, and it’s starting with much better air humidity which makes it easier for me to stay in the recommended VPD range – currently 54% at 25 °C at canopy height. With 58, 67, 78 and 80 cm plants’ average height is about 71 cm. Odour has increased, and sometimes, but only shortly, I get the feeling the coal before the blowers cannot eliminate all of it. While the smell was a bit strange sometimes one and a half week ago, it’s now absolutely yummy, sweet and promising. As is all the sticky stuff adhering to my folding rule when I measure their size. I am a bit confused about the amount of yellowing leaves. That would indicate a nutrition deficit. On the other hand, last feeding (yesterday it was only calmagged water) brought some brown edges to their tips as I wrote. Which could indicate a slight over-nutrition. I am not *that* worried as leaves around the buds all look great (except for mentioned, but not youngest tips), and mature plants obviously tend to concentrate on bud production solely. But week 7 is quite early, or isn’t it? Any recommendations? Maybe I should go with organic fertiliser next time to avoid being stuck between two options ;) As they had run dry already, I gave each one another round of drink. Slightly less fertilised than last week. And I removed the lowest yellow branches and tiny buds that would not make it into the light in time. The Pineapples must have some mimosa genes crossed in. Each time I touch them they bow away their heads in deep dislike. The taller one looks like her head would be too heavy now … It is not, and usually they recover after an hour or so. The Sherbets are pretty unimpressed by all I do. Meanwhile I’ve been working on the Raspberry Pi BoxControl that should help me stay in better VPD ranges in the future. I am not sure how to translate this all into a more stable solution than based on a breadboard, but the state so far (and how it is supposed to work): Raspi runs headless with control software on autostart. Every minute temperature and humidity are received from a GY-21 I2C chip that should be hanging around plant tops. Data is saved in a database, VPD is calculated and signalled in form of a RGB LED color. Additionally, LCD display rotates through current stats. 3 relay modules can en- or disable misting, dehydration or an additional blower. Maybe I can add a CO2 sensor just for the fun of it (but I’d have to develop a device protocol myself), maybe even one or two soil moisture sensors. Theoretically you could also have a lighting control, but then, GPIO ports are all used. The display needs a lot of them, and while I can log onto the Raspi on my local network and view its desktop, I’d prefer to have a quick overview at place. I am not really informed about current models. Are some GPIO extensions or Raspis with extended GPIOs on the market? But so far, that’s all theory. I never had a PCB developed for my hobbyist projects, I am not the best with a solder station. Never had a Raspi run 24/7 for a really long time. Did a bit more lollipop ping in the evening. Especially tallest Shepard had fun building some more very low buds and branches. I think it can investigate its powers better on different places. Day 51: It’s getting hard to measure soil humidity with my low tech device. Soil must be full with roots and I don’t want to hurt them much. I can see them at the outlets of their pots too, sometimes a bit dry of course as these parts run dry earliest. Experiments to include the CO2 sensor in my test setup failed. I can read and reset it, but setting measurement mode and reading values don’t work. Maybe because my I2C library cannot use ClockStretchLimit. Running out of GPIO ports anyway and seeing that the soil sensors are analogue devices, I’ll probably revive my Uno too and have discovered some clever Raspi heads that should make a more stable setup (and some cooling) possible while also adding a handful of PWM ports and an integrated display. I’d like to include a camera module too and it would be great to have some ports available. A final setup would obviously include a Raspi 4 or 5 to easily enable secure online access. But so far, all working nicely in test setup. Day 54: Sometimes I wonder if they’re still growing at all, but then it’s good to have the daily pictures to compare bud width which now seems to be the main interest of the ladies, although differences are now clearer to tell between two day intervals. The taller ones look like they are one week ahead of the smaller plants, with even higher fan leaves turning pale now. Which at an estimated seed–harvest time of 8–11 weeks for both strains should be pretty common, I guess. Or am I wrong? Summerly temperatures make the temperatures at canopy level sometimes reach 31 °C, but at least the simple ultrasonic diffusers arrived and I am getting closer to a better environment control. I can at least switch the diffuser inside the tent remotely from my phone, and a deep bowl of water with a lid so the "fountain" produced will not wet the tent floor and one of the fans placed at the bottom now to lift its mist upwards seems to do the trick. Humidity increases while temperature drops, getting the plants into a better VPD level, so all I have to do is wait for the evil A to deliver the necessary Raspi components to have this automated, maybe still while this grow runs. At the end of this week, there was just a bit of height gain for the two smaller ladies who now approach their next 10 cm mark. Overall, I get the feeling it won’t be that long until harvest. Maybe with the taller ones a week earlier than the others. There’s really not that much bud growth anymore, rather refinements – like buds getting more nodes and color. I’ll investigate the trichomes every few days but would welcome your estimation.

Thanks again for all the love and support Thank you Seedman for providing the seeds and allowing me to be a part of the #Seedsman420GrowOff. It was a great experience which j hope to be a part of again! I plan on doing my content in ny next grow. I have a bunch of ideas for timelapse videos and cool other videos of the grow. Stay tuned and follow for more Highgrade Harvests! Follow me on YouTube and Instagram for more content! @highgradeharvests

Today 7/30/19, day 57 and the start of week 9. I'm still continuing to alternate between days with my pesticide treatment (especially after finding that bug living on one of hulkberries fan leaf) and thrive alive green daily foliage spray as a prophylactic solution against any possible pests or mold going into these last few dog days of veg. I will flush them with distilled ph'd water for two days this weekend in preparation for flower. Then I'll start them on some "flower fuel" bloom booster on top of my secret for success flower recipe at 1/4 of the recommended strength. Outside of that still no adverse issue to report for the end of the 8th week. After my last trim, they both have responded very nicely, I was kind of worried about fat banana stalled growth. But one thing I noticed when I topped her at the 6th node, yes the main stem stopped growing but it developed many bud sites up and down every stem. Whereas hulkberry was topped at the 8th node, she has mainly focused on developing long stems and only 2 or 3 bud sites along her stems. Even though hulkberry in structure, is much bigger than fat banana and has a way bigger root system. Fat banana is bushier and has developed way more bud sites than hulkberry. I can't tell which strain will yield the most at this point only time will tell! Also, a big shout out to "J"@RQS, thank you for the excellent customer service. Another reason why Royal Queen Seeds is top 3 in breeding!!

Hello my friends growers This week I've got more and more yellow leaves, Do you think it's a carence, water excess, precose senesence? I don't what I need to think, or if just normal, I just give her water two times per week. 0.6l x 2. Fertilizer 1/2 times. I think I'll harvest end of this month or start December. If no, bud are biggest each day, and smeel really sweet. I've also started pk 13 14 this week. Sorry not lot pic's this week , I've broke my phone and lost several pic's. Have a good week 😁😁

Ok my dear fellows. I've upgraded my tent in a 1m X 2m. With this setup and a high potent dehumidifier I should be able to keep the humidity low. Unfortunately this high humidity was going too kill two other crops. With this setup I should reduce that risk again. So the RHC is now together with the others. She is bulking a lot. There have been a little discoloration on the upper leaves. It might have been the light too strong. This is weird because I'm providing 1500 ppm CO2. All the other parameters are ok so it must have been a little lack of water some days ago. Smell starts to be very noticeable BUT it doesn't reminds me weed but instead citronella. I thought that's why I don't see mosquitos in the room. To the next week *Changed nutrients ratio to meet to lower the EC but keeping PK at the level of (40ppm - 100 ppm). *Next upgrade will be a tower fan to increase the airflow

Gave her a pretty good haircut around the base and took off anything that wasn't going to have a big top bud and opened it all up for better airflow so come flowering I won't have any stagnant air in the center causing bud rot. She is just starting to show preflowers so I went ahead and started hitting her pretty heavy with organic bloom nutes like fish bone meal,seabird guano and fox farm fruit and flower and then fed her a nice healthy dose of FOOP canna bloom 1 & 2

Trichome in kurzer Zeit auf Bernstein umgeschlagen. Ernte Signal. Ausbeute eher klein, wenn man bedenkt, wieviel da Weg trocknen wird. Aber egal. Mine is mine.

Semana del 5 de enero al 11 de enero 2026

hi guys, although the plant was born at the end of summer it is growing well and fast, the vegetative growth lasted about 4 weeks

HO-HO-HO! 😀 Final week of flowering for this girl! She got a nice ice bath before going into darkness for 72 hours. This is the third time I've done this (been increasing from 24 hours - 48, and now 72) and I'm seeing a huge difference every time. Most will call this bro science, but hey, whatever works for you! And in this case, whatever works for me :) I can definitely say the red came out a LOT more with the lower temps from the lights off period, so can't wait to see how she'll look once trimmed up. Stay tuned for my harvest week post!

Blooming along well now. Only vertical height has been bud mass. Happy and healthy and been very easy going so far. She got treated with Dr zhymes as a preventative. That will basically wrap up her treatments ...possibly once more with lost coast. Upped the pk intake as she is blooming strong now. Gotta keep her engine well fuelled. Response was stellar. Happy happy happy lady. Until next update. Happy growing and stay lit fam.

Seems I was letting the temp get to low during the night.. I noticed some slow growth did some investigating and that was it. During the day 86/87 and at night it was hitting like 60 and 50’s.. So I’m hoping that was my issue.. But other then that they look beautiful and healthy.. Nutrient burned Red D is 100% now and growing.. I defoliated both of them yesterday, mostly cleaned the Red D’s branches. Just want all her energy going up not out.. But the slow growth sucks hoping it changes now..

Sa fleuri tranquille, rien a signaler, très belle plante