The Grow Awards 2026 🏆
Likes
Comments
Share
@Neo09
Follow
This week we solved a problem with high temperature and we had instaled a clima. IT Works perfect! Ladys are Just happy as you can see on videos😎happy growing to all of us😎🙋‍♂️🙌
Likes
13
Share
Everything is going ok no roots yet on the clones but we got a week b4 we need to worry Temps steady humidity steady will be topping of res with more nutes todau
Likes
16
Share
@Mrg7667
Follow
Day 15 of flower! Kinda goofed this week i gave the babies week two nutes after the last post wich was like day 10 and i noticed a little bit of nitrogen over dose. I think the Powersi is also helping nutrients absorption! So i actually did this week a little different then i planned just cut the bio bloom in half because i didnt realize the powersi npk ratio inceases p and k Havent seen anymore aphids might do another couple sprays to be safe. Grow safe allows full spray through flower
Likes
59
Share
@Salokin
Follow
These ladies are developing very nicely, the left and middle one already started to bulk heavily over the course of the last week, while the one that got wind stress is trailing a little behind and will probably take a little longer. For the other two I would guesstimate that I can start flushing by the end of the week. The trichomes on the two are completely milky, however with no signal of amber yet
Likes
Comments
Share
Wow the growth difference over this short time a week is insane I couldn't believe it the genetics are dead on here and she loves the environment.The plans has allready made me want to start there z skittelz strain in auto flowering version ..cheers
Likes
43
Share
~Entry for the 'Best Rarest & Smallest Pot by Seedsman' contest~ Starring 🤩.... ~ Seedsman Zkittlez Auto ~ Zkittlez (Grape x Grape Apple) Auto x Auto Fruit (Auto Fruit Cheese x Auto Blueberry) Zkittlez Auto is one of the very sweetest-tasting auto strains available anywhere. It is a sativa-dominant (60%) strain that was bred from Zkittlez (Grape x Grape Apple) Auto crossed with a male Fruit Kush Auto, the latter a remarkable fruity strain bred from Fruit Cheese Auto and Blueberry Auto. Growers can expect to harvest some good yields of high-THC buds. Zkittlez Auto remains a fairly short plant, rarely exceeding 120 cm. in height wherever it is grown. This is a vigorous plant which is able to metabolize a high level of nutrients and she's a thirsty girl too! If growing indoors close to neighbors it is strongly advised to ensure good and effective carbon air-filtration in order to neutralize powerful odors. This strain's life-cycle is approximately 90 days from seed to harvest. The leaves on this plant are big and wide serving to convert every lumen available into Zkittlez goodness. Indoor growers should obtain between 400 - 500 gr/m2 while plants cultivated outdoors will produce slightly more at 500 - 600 gr/m2. Lateral branching is very good and it is recommended to use supports/ties to prevent snapping and keep buds close to the light source. This strain's scent is sweet and fruity with candy and berry notes. Its high-THC has been measured at between 21 - 24% with less than 1% CBD. The effect is well-balanced, cerebral and euphoric, and is very good for social situations as well as for relaxing in front of the TV either alone or with company. It also has the added effect of helping to relieve chronic pain, helping with nausea, insomnia and depression as well as stimulating the appetite.** **Credit to Seedsman.com ______________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________ ~ The Setup ~ ~ Grown in a 2qt plastic popcorn pot filled with Mother Earth Grow 70/30 Coco/Perlite with Xtreme Gardening Mykos added. ~ Seed was germinated directly in the medium without any 'pre-soak' ~ Feeding will be by Dutch Pro Nutrients ~ 24hr light cycle while germinating ~ 20/4 light cycle after first leaves appear. ~ 4x8 Gorilla Tent ~ HLG 650R w/ 30w Supplemental UVA Bar controlled by a Trolmaster Hydro X controller set for a 15min Sunrise/Sunset simulation. (also a HLG Blackbird for additional side lighting if necessary) ~ Supplemental co2 controlled by an AutoPilot APC 8200 co2 controller ~ AC Infinity Cloudline T6 with Controller 67 using a Terrabloom 6x24" carbon filter ~ De-Humidifier and Humidifier when needed. ~ 14k BTU IdealAir portable A/C unit plumbed into tent for temperature control. ~ BlueLab testing instruments ~ Two Hurricane 18" oscillating fans ~ Two 6" Clip-on fans ~ Two 10" floor mounted fans ______________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________ The Harvest: After checking her trichomes which were at 90% milky, I placed the Zkittlez Auto into complete darkness for 72 hours. While in the dark I maintained a temperature of 65-68℉ and a RH of 40%. After three days in the dark I removed the Zkittlez Auto and all I can say is WOW! All of the flowers on the Zkittlez were just covered in trichomes and it had a super strong sweet/fruity aroma that hit me right in the face!😍 I cut the Zkittlez and hung her in two sections as the flowers were huge, and I wanted to make sure that there wasn't going to be any issues with air circulation around them possibly causing issues. It's wintertime here now so I took advantage of the low temp's and RH hanging the Zkittlez Auto in my attic. I sealed off a section of the attic from any light leaks and installed a de-humidifier, fan and humidifier along with a hygrometer which I suspended at the same level as the plant was hanging which give the most accurate reading of temp/RH. After hanging the Zkittles, I adjusted the fan direction so that it was not blowing directly on the hanging plant, but kept the air slightly moving in the room. I set the de-humidifier for 50% which I run for the first 24hrs to knock down some moisture in the plant, then set it to 60-65% for the remainder of the drying time. The Zkittles Auto hung for a full 12 days, during which I checked on it daily to empty the de-humidifier and make sure that the environment stayed on point. After hanging, it was time to trim this beauty up and get her flowers into glass jars to begin the curing process which I prefer to take at least one month, preferably 2-3 months to really get a good cure and allow all the starches to convert to sugars, the remaining chlorophyll to metabolize and the terpenes to form their bouquet! Trimming the Zkittlez Auto by Seedsman was a breeze and resulted in some tightly stacked and absolutely gorgeous flowers that are loaded with shiny trichomes that sparkle, and a sweet and fruity aroma that will make your mouth water!😍 I was super stoked to harvest almost 100g from this beautiful autoflower that was grown in a little .5g plastic popcorn pot that I had saved from a trip to see 'Top Gun Maverick' at the theater and I can attest from cultivating Seedsman's Zkittlez Auto in the past, that with a bigger pot, it is capable of some incredible yields! All in all, this grow was super fun and easy! I highly recommend Seedsman's Zkittlez Auto to everyone from novice's to master growers as it NEVER disappoints to produce some mind blowing fruity buds! ❤️❤️❤️
Likes
19
Share
@Barb420
Follow
👋Hi 👋 So ive moved things around, repositioned the dehumidifier away from the exhaust fan 💨👌working much better,, Added 📽️cam.. I’ve also brought from living soil,,,Bloom🌸x Barley x Myco Boost Fed them half strength and 🤩 WOW they loved it . .Tran Siberian lower leafs 🍃 are getting there green colour back 🌱🌱..very happy with the changes. Next top feed is this Thursday, will use full strength and let’s 👁️👁️ see what happens … 🤔 👩‍🌾👋👋
Likes
13
Share
@Droot
Follow
im not training these at all im strictly watching them grow and studying how they are naturally. messing with the lights a little, and got some light burn on both plants cause the lights were wayy to close. but all that being said im recalibrated with the lights, added in the blurple light just because i wanted more specrtum. growth has been explosive. i incorporated fish shit into every feeding and watering this week and i love it so far.
Likes
9
Share
@Rizik86
Follow
Day 36 - Checked PPM 400. Plant is wide and bushy. Day 37 - Plant is 28 inches tall and 10 inches from the light. Day 38 - Plant is 29 inches tall. Root system is almost maxed out for 5 gallon bucket. Checked PPM 700. Built a new light stand/grow area. Now bigger then 4 by 4 foot area. Day 39 - Started a new bucket of water and nutes. Added 20 mL of CalMag Micro Grow and Bloom. Added 10 mL of each additive. I didnt add the rooting additives Tarantula Piranha and Voodoo Juice. PPM is 1,600. Plant is 32 inches tall. Different looking growth forming. Day 42 - Checked PPM 1,520. Added RO water. PPM is 640. Added 10 mL of CalMag Micro Grow and Bloom. Added 5 mL of each additive. PPM is 1,300. Plant is 34 inches tall. Noticeable bud development started.
Likes
32
Share
@BB_UK
Follow
So we’ve come to a slow down on the stretch and they’ve started to work n creating flowers, I defoliated about 10-15% of the fan leaves and removed stems that had less vigor or was too under the canopy and wouldn’t of created any good flowers as these plants are a whopping near 50” so proud to be a loyal Martian! The lights are so powerful and provide the plants with the power of the sun ☀️
Likes
11
Share
@Kirsten
Follow
18.1.25: Gorilla 🦍 Cookies 🍪 is firmly in week 2. The plant is looking very good, sturdy. I have been feeding with about 200 ml of dechlorinated water PH'd to 6.3 with the following nutrients;- ♡ 4ml Biobizz Bio-Grow ♡ 4ml Biobizz Fish Mix ♡ 2ml Cal-Mag and ♡ 1/4 g sprinkling of Ecothrive Biosys. Trying to give the extra boost of Nitrogen to keep vigorous growth, and maintaining the nice lush green 💚 Cal-Mag was used from the beginning of this week. Thanks for checking out my diary 🍃 ✌️
Likes
13
Share
Likes
Comments
Share
@Kardo
Follow
Diese Pflanze wird sehr schön sie bildet über all schöne Triebe zeigt eine schöne Farbe und wird nur noch größer schaut euch wie viele Triebe das sind
Likes
18
Share
Hanging tight with this kiddo... If one thing is for certain, she is dedicated to her life as a bushy Betty. Having to so often defoliate has stressed this lady out. Despite that, she is surprisingly still hauling strong. I have to say, in my experience Fastbuds genetics really take a beating. My cycle with her goes something like, bush out, defoliate, stress, bounce back with full on bush, repeat.
Likes
30
Share
Simply put I am so very pleased with the way this plant has performed my only worry is how to properly dry and cure this magnificent specimen
Processing
Likes
3
Share
Great plant man I am loving her she is growing like a champ even after all i put her thru and snapped one of her colas but all good she bounced back like nothing happened will be growing more Fast Bud strains