The Grow Awards 2026 🏆
Processing
Likes
Comments
Share
She's doing well so far. I gave her another tps of Bat guano to increase the grow during stetching stage. I also switch my 7L pot to a 13L one. Next week she's gonna get only daylight so 11/12h a day in my area. The rain is falling every 3 days so when she's out she get an extra watering
Likes
7
Share
4/8 - They are doing great. PPFD at 800. Debating if I want to do CO2 this grow, because I could easily get 1000 PPFD out of this light. That means adding a dehumidifier to keep a sealed environment, but don't think there's enough of a cost benefit. Might just add more far red at lights on and lights off to try and get a little more vegetative stretch before I switch over to 12/12. Clock is ticking. Mother-in-law shows up 6/15, and I'll want it chopped by then. 4/8 - on further calculation, I'm switching to flower today. Never switched this early before, but we'll see how it goes, eh? 4/9 - prepping for vacation. Bought new 10 gal Roughneck storage container, mixed new nute mix 2:1:2. EC 1.40 with 0.3 tap water. 11ml of pH down to get PH from 6.4 to 5.8. Ditching the auto fill. Too high risk for flooding without flare fittings. Don't trust cheap-ass quick connect push fittings. 4/10 - turned off "seedling vpd mode" which kept humidity artificially high. Turned on 2nd bank of LED lights, so system is pulling about 370W with lights on, still significantly dimmed down. Turned on light cooling circ fan, which is a sealed aluminum labyrinth tied to two 4"vents. Although, almost all the heat this lamp generates is from radiation, not thermal loss of the LEDs, so the heat sink is barely warm. Lights up to 16" over canopy to allow growth while on vacation. Ppfd at canopy 800. Room temp 81, humidity 73. Auto water time is 30 sec per pot.
Processing
Likes
6
Share
@oP41No
Follow
I got a double scrog setup and I'm gonna let it grow into it. This is my first grow and I'm excited. General Hydroponics nutes (Flora series). Kingbrite QB 288 v3 from alibaba. I'm just gonna let her do her thing until about week 3.
Likes
6
Share
@Growin_it
Follow
Needed to defoliate to create airflow and start shaping the ladies. Stretching out the lower colas across the base. Fimmed the ends of the longer stems to get a split going for more colas. Recharge added to feed after stripping 30%+ of the lower canopy. Will turn to flower in a week or too. Notes: slow growth due to the lower heat in the tent. Okay with that because the Lecky bills have been huge with all the price gouging going on.
Likes
10
Share
@6toecat
Follow
Using a Rhaspberry Pi 4 to automate the watering and a TP-link 105 smart plug to automate the Viparspectra P2000 LED grow light. You can see how I automated it here: https://hackaday.io/project/188129-rhaspberry-pi4-basic-watering-system-for-balcony Basically, this is an "Automated Watering how-to Guide for Dummies" - as simple as technically possible. You still require some basic command line expertise, but the steps have been proven and I provide links to the gear I used AND the Node Red code, making this EASIER than anything else I've seen online.
Likes
7
Share
Still feeding nutes plant decided it wants to extract stored energy from fan leafs that's fine that why I left some. I won't be doing a full flush. Amber trichomes are appearing on oldest trichome locations so one more week and that's it.
Likes
9
Share
Ya es el día 60 y el tono amarillo en las hojas anuncia que se aproxima el final. Espero todo siga su curso normal y poder terminar bien este cultivo que me ha gustado bastante.
Likes
21
Share
@hyphen420
Follow
Viel gibt es nicht zu berichten auser das ich es kaum abwarten kann zu ernten 😍😬
Likes
3
Share
@Organic_G
Follow
Ich hasse es wie die Pest, schlimmste was es auf der Welt gibt, Harvest… 😭 3 Tage meines Lebens schon in die kacke versenkt… denke für die nächsten Ernten wird eine Trimm Maschine angeschafft
Likes
5
Share
@Major
Follow
I made a big mistake when editing my new week I erased my first weeks 😤😤 but I don't have to complain about everything is fine for my plants 🤗😂😂
Likes
22
Share
Beginning of week 8. Cutting down the feed strength by half before going full flush mode week 9+. Starting to look at tricnome color to determine final day to cut. How long do you flush with rockwool?
Likes
15
Share
Moved into 2x4 - adjusted PPFD from 250 to 190. Light stress. - worried over red Clover mites. Captain Jack’s,
Likes
12
Share
Was a good productive week. I did give them a 30hr dark period before switching to 12/12 to really try to take advantage of the red spectrum on my light. (I read this somewhere so giving it a shot!) Also waiting to install second scrog, waiting for them to fill out a little more to help me guide the canopy as even as possible. The insides of both plants have new tops to fill in the gaps. The defoliation last week was the right move. The slower of the two up to this point is the front runner now so let's see how they continue to fill out. Temp finally dipped here so able to keep a more regulated temp. The 77-79 range seems to be what the girls are liking the most so I added a second fan to try and keep the night time humidity lower as well. Any comments or tips are much appreciated! Really enjoying learning all the steps/processes along the way so far! Cheers!
Processing
Likes
34
Share
D33 (24/12/2020): First week of flowering. Both officially went into flower 4-5 days ago but I decided to finish the week before starting first flower week. I fed around 3L of water today, they were thirsty. I mixed full recommended dose of nutrients for last week of veg in 1,75 gal. of water. I want to go slow in reintroducing nutrients after 2 flush last week. - temp: 25C - water: approx. 3L per plant, PH6.4. 600 PPM - run off: 900 PPM for Banana Kush and 800 PPM for Glue Gelato - RH: 54% D34 (25/12/2020): Nothing special today except that it's Christmas, everything is going well. RH is higher today since higher temperature where I live but nothing crazy. - temp: 25C - no water - RH: 58% D35 (26/12/2020): I removed leaves under canopy today and fed with a gallon of water + minerals each plant. - temp: 25C - water: approx. 3,75L per plant, PH6.8, 350 PPM - run off: 750 PPM for Banana Kush and 600 PPM for Glue Gelato - RH: 55% D36 (27/12/2020): I readjusted some ties because they are stretching like crazy! The buds are forming and more pistils are showing. - temp: 25C - no water - RH: 53% D37 (28/12/2020): Still readjusting the ties and removed leaves today. The lights are now at 24 inch and plants receive around 495-525 PPFD (38 0000 to 40 000 lux). I'm aiming to go above 600 PPFD in the next week. I will check how they react with more light. - temp: 24C - no water - RH: 54% D38 (29/12/2020): I gave approx. 3.5 L of water per plant. I used 3/4 of the recommended dose for transition week. - temp: 25C - water: approx. 3.5L per plant, PH 6.4, 720 PPM - run off: 900 PPM and PH6.8 for Glue Gelato; 800 PPM and 6.8PH for Banana Kush - RH: 54% D39 (30/12/2020): Removed more leaves under canopy. - temp: 25C - no water - RH: 54%
Processing
Likes
3
Share
@camo420
Follow
NEW BOX: 130x60x120 DIY: storage shelf, solid sheet metal ELECTRO ################################ thermometer top thermometer bottom hydrometer wlan ip cam (+ir filter) ---------------------------------------------------------------- input: x2 USB PC fan exhaust: x2 USB PC fan circulation: x2 USB fan ---------------------------------------------------------------- led panel 1: 300W ASUNDOM LED (Veg/Bloom/Full) led panel 2: 300W XHGrow Reflector-Series LED (Full) ---------------------------------------------------------------- studio light 1 (vegetation): 36W TaoTronics LED Gold studio light 1 (vegetation): 50W Balai LED full studio light 2 (vegetation): 8W VINGO LED blue ligh studio light 2 (vegetation): 50W Balai LED full ---------------------------------------------------------------- studio light 1 (bloom): 36W TaoTronics LED Green studio light 1 (bloom): 36W TaoTronics LED Gold studio light 1 (bloom): 50W JADIDIS LED IR full studio light 2 (bloom): 36W TaoTronics LED Green studio light 2 (bloom): 36W TaoTronics LED Green studio light 2 (bloom): 36W KINGBO LED Deep red 660nm 3x PLANTS ############################### FastBuds Girl Scout Cookies pots: 14L soil: plagron grow mix
Likes
15
Share
Esa familia, otra cosecha más, no tan contento esta vez la variedad en si está buena pero su cultivo es algo complicado y no está estabilizada la genética, los días de floración son más de 55 días como dice el banco,más de 3 meses de floración con estos ejemplares... Pero mereció la pena esperar el colocón es bastante fuerte, para mi que , sativa dominante a mi parecer, 24% de thc , cruzada entre cookies x OG Kush , muy productora en general. Así esto es todo , pronto más trabajos, buenos humos familia.
Likes
50
Share
@D33jW
Follow
🌸 Runtz - Week 2 of Flowering Update 🌸 This plant continues to impress me! 💜 The structure is beautiful, and it’s growing strong with a healthy appetite. I can already see the first signs of fading, which tells me it's hungry for more nutrients. Everything is progressing smoothly, and I’m really happy with how it looks at this stage. For the last feeding, I gave it Plagron Terra Bloom with an EC of around 1.3. The plan moving forward is to maintain stable conditions around 1.2 VPD until the first signs of frost appear on the buds. Regular feeding will continue, keeping EC above 1.0 to support healthy flower development. Grow Conditions (FLO Week 2): 🌞 Light schedule: 12/12 🌱 PPFD: 750 µmol/m²/s 💧 VPD: ~1.2 kPa Can’t wait to see how it stacks up in the coming weeks! 🔥