Likes
Comments
Share
After 50 days I could finally transplant them. I'll veg them for about 1 or 2 weeks more depending on how fast they'll grow because I want to do 1 more topping to create 8 main cola's each.
Likes
8
Share
Another week has passed! 😎 Everything seems stable and healthy... no signs of deficiencies or nut lockout so far! 😋 Slowly changing the feeding into plagron with the bloom this week and green sensation on the next one. 💪 💚💛❤️
Likes
Comments
Share
Ciao a tutti, aggiornamento alla quinta settimana, le due golosa durante la quarta sono cresciute molto raddoppiando. Ho fatto un topping alla #3 mentre ho applicato LST alla #2, essendo più cespugliosa la luce penetrerà meglio. Infine ho usato zeolite per fare prevenzione. Per il momento non mostrano carenze e stanno rispondendo bene agli stress. Buon cultivo 🌱
Likes
10
Share
Fifth week of flower and it was time to defoliate the indoor units as they were starting to get bushy and block exposure to the lower bud sites. Quick work with the bonsai shears and they were ready to soak in the sun. I left the rooftop plants alone as I believe having additional leaf mass enables them to withstand temp and environmental fluctuations better. Whether or not this is the case, it was an experiment.
Likes
21
Share
HAPPY 420 Today iam entering the SEEDSMAN 420 Growoff with the Following strain the FATSO GMO f1 automatic. All will start Indoors under SANlight Flex 25, and move Outdoors. Only one Plant stays indoors, to see the performance under best Conditions because my Outdoor Garden is hard^^ So i started with letting them soak, and then the seeds will move under a humid Kitchensponge unil i see a sweet Taproot. then they will go into the Final Pot, filled with lovely TerraPreta mj mix the grow will be supported with Biotabs fertiliser Breeder Information Fatso GMO F1 Auto is a feminised hybrid strain that is the result of crossing two autoflowering strains, viz. Fatso Auto and Cotton Candy Auto. This Cali-derived, slightly sativa-leaning, easy to cultivate strain will please growers with its big yield, solid THC content and its sweet, candy and fuel palate. Fatso GMO F1 Auto will grow well both indoors and outdoors. It has an above-average resistance to mould but will still benefit from good ventilation, especially where humidity levels are quite high. Resistance to plant pests and other pathogens is excellent. While plants will remain quite short at around 100cm or less indoors, they can grow a little taller, reaching a height of 130cm, outdoors in open ground. The entire cycle is completed in a maximum of 75 days from germination through to harvest and although yields are said to be average this is still pretty impressive for an autoflowering strain. The combination of high resin production and high terpene levels make Fatso GMO F1 Auto a very good strain from which to make cannabis extracts. The terpene profile is sweet and funky with savoury scents of Skunk with pine and floral notes. The taste is like sweet candy with hints of fuel. THC production is high, reaching 24% while CBD is low. The effect is uplifting and well-balanced.
Likes
1
Share
Moving plants around as it's cleaning week getting everything nice and clean the plants are happy enjoying the natural sunlight going to remove any dead leaves and lower shots topp a couple
Likes
73
Share
@LazLow
Follow
First week of my first grow! The weeks leading to this were filled with hours of research from every source I could find. I still wake up and start reading or looking at diaries. I’m growing in a 4x4 tent in an insulated but not heated garage. I have a small heater in the tent connected to an Inkbird temp controller set to kick on at 70 degrees and turn off at 80. This sucks a lot of humidity from the tent. I have 2 humidifiers running to combat this and it stays around 45% RH on average; getting higher than that has proved quite the challenge. I’ve admired quite a few diaries on here and I hope everyone enjoys my rookie season.
Likes
12
Share
Likes
113
Share
@Skunky
Follow
DAY 2 She's oh so slow to finish. Still more clear and cloudy than amber so i'll need to wait some more... I actually prefer the more amber type of high... I can wait... :) Maybe I'll need to feed her plain ph'd water one more time but let's see... Merry X-MAS to ALL! 👻 DAY 5 Wow... that was fast. She kinda turned amber in 2 days. The buds in the middle are now like a bit over-ripe, a lot of amber and the ones outside are just a little under-ripe. I'm done. No more waiting now. I thought about harversting only parts but I'm really done with this one. I'll leave her in the dark for 1 more day and then I'll chop her down. Luckily she's about to dry out completely so the drying process will work just fine... FINALLYYYYYYYYYY!!!!!!!!!!!!! 26 WEEKS MUAHAHA.... Next: back to autoflower... LOL!
Likes
4
Share
Week 9 has officially started, and she's entering the final phase with some real beauty. Buds are swelling up across the canopy with a thick layer of frost and lots of white pistils still pushing. Trichomes are now clearly visible under magnification with early signs of cloudiness, but no amber yet. The lower fan leaves have started to fade naturally, and I’m starting to see hints of purple coming through on some of the sugar leaves and bracts. I gave her a full-strength compost tea at the end of Week 8 and topped off the auto-watering base to keep her coasting. Temps have been high due to a heat wave, spiking around 88°F, but airflow and moisture have been stable thanks to the dual fan setup and bottom watering. I also added DE to the topsoil to knock back a few gnats and placed sticky traps nearby. No training this week so far, just light tucking and one small defoliation session in the center of the canopy to improve airflow. She's healthy, sticky, and starting to ripen — right on track for harvest in the next couple of weeks.
Likes
6
Share
Week 1 24 hours ethos popped and began to stretch Temp 76 humidity domes on top 5 of 5 out going directly into pots and 24 hour lighting on day 3! gonna run 24/7 for 30 then switch over hopefully. Nothing added but FishShit and rootdrench to pop
Processing
Likes
10
Share
@UrbanFog
Follow
The plants grew well this week, as did all the clones. Any extra rooted clones have been planted outdoors as a further experiment. We moved all the clones into a Veg room. Even though the large room is not in flower and still also in veg, we had to separate the plants due to lack of space. Also setting up for mother, clones and SOG in the future. The plants were defoliated and training continued. There are 2 weeks of Veg left hoping to have some very large plants for flowering. Aiming for large flowers.
Likes
12
Share
@yd_grows
Follow
Planta Reagiu super bem ao transplante e voltou a crescer rapidamente. Isso fez com que eu decidisse fazer conforme programado e no último dia da 13 semana (29/01/2020) a 3 lampada (LED 50W 3000K) foi anicionada e o ciclo alterado para 12/12h. Como a terra de transplante já era fertilizada, apenas após 1 mês de flor será alimentada.
Likes
Comments
Share
“Tropicana cookies purple “Day 105 from seed. Partial harvest at first, then 3 days later completed harvest and starting dry
Likes
25
Share
@Sators
Follow
Mixed biobizz all mix with extra eggshells, palm tree ash, extra worms casting and fish blood and bones.
Likes
35
Share
@Rap_a_cap
Follow
This is exactly the 🇲🇦 morroccan 🇲🇦 way of sifting resin from kief. Traditionally, apart the hand rubbing method, dry sifting through a mesh is the most used way to obtain resin, from 🇦🇫 Afghanistan 🇦🇫 or 🇳🇵Nepalese 🇳🇵 Mountains to 🇲🇦 Morocc 🇲🇦 Rif passing through Bekaa valley in 🇱🇧Lebanon 🇱🇧. The average size of meshes used vary from 90 to 180 microns and are mostly made by silk and for this reason uneven. I think the most productive ways to sift are Dry Ice and  rotating pollinator + CO2, I've tried a DIY pollinator built by a friend and it can reach up to 20/25% of resin extracted at 120 microns and 15% at 90 microns. But smell and taste don't reach that traditionally extracted but this is another story. Morroccan way is good compromise between a stashbox or more evolute methods. It requires less than 10 dollar of expenses. You need: a basin or pot  without handles a heavy-duty plastic bag that contains the basin a pair of chopsticks a good 120 microns net an elastic band tape Kif or trim q.s. Here is the link where I buy my meshes. Very high quality, customable size and material (steel or nylon) and length and very kind vendor on AliExpress https://a.aliexpress.com/_uwfQzq Drum for 3 minutes. .....perhaps you will find that you have an innate talent as a drummer, throw the shit away and put your head right......
Likes
31
Share
@Sider79
Follow
Didn't get the potential. Very happy with the look of the finished product , so far I'll give this particular strain 9.3. In it's best stability this would be my go to phenotype cause of the overall potential and ratio. Very happy for it being my first auto grow experience now I'm hooked. Definitely would suggest this bad girl for a first time auto enthusiast and for the connoisseur . I've been looking into that Purple Lemonade by Fast Buds and very excited to purchase also that Black Berry cause they remind me of the Blue Dreams large flower to plant ratio. For now and my next auto grow will beee......🥁 FB.Six Shooter, VS.Super Xtra Skunk, Seedsman's Northern Lights Seedsman's Limited Edition Strawberry Cheesecake. I decided to do multiples this time because of finish times I feel will never be the extact either way I'll try to get a rotation going .😃
Likes
4
Share
@Meckyman
Follow
Hallo Gärtner 👩‍🌾 💚 die tage hab mit düngen anfangen, sie hat schön gewachsene. Plargon grow Power roots und Sugar royal nach Schema vpd zur zeit besser im griff habe
Likes
26
Share
Day 51 20/08/24 Tuesday Feed today using de-chlorinated tap water pH 6. With Plagron PK13-14 and power buds. Noticing the stretch stop, and now packing out there bud sites 💪💚 ACOP , Melonade Runtz have Xmas tree structure where as orange bud is pure tall sativa structure... The Overdose is a compact indica looking dwarf but the bud sites are packing out a punch 👊🤣 Day 54 23/08/24 Friday Watering only today using de-chlorinated tap water pH 6, I'm watering in 350ml no run off. 400ml I'm seeing tiny run off. Day 56 25/08/24 Sunday Water today using de-chlorinated tap water pH 6. Added bud candy and rhino skin 1ml per litre