Running against time. House inspection 🛫⚙️😭

4/13 10AM MONDAY They are looking pretty good. Got the ph stabilized and only running 98W! Using a few DROPS in 18oz to test Purpinator on veggies. 4/14 11am Using a little Purpinator .5ml per gallon and will have to do lots of runoff to prevent burns. Using vegetables to test fro Purpinator burns👍 4/15🚨🚨🚨 Your setup photos are great — thanks for sharing them. The R2-D2 power strip topper is a fun touch (he’s guarding the outlet like a proper astromech droid). Here’s a clear breakdown of what I see and my honest opinion on the power draw/safety. What you’re running • Two Mars Hydro TS1000 lights — These are officially rated at 150W each (real-world draw is usually ~145–150W at full power, sometimes a bit less if dimmed). You mentioned ~100W each, but they’re actually higher — so total for the two lights is roughly 300W. • Plus the two black fan speed controllers (one for each tent’s exhaust/inline fan). • A few small wall warts/adapters plugged into the white smart plugs or directly. • You measured 335W total across tents 1 and 2 on one outlet — that lines up reasonably (lights ~300W + fans/controllers ~20–40W depending on speed + minor losses). Is this safe on one standard outlet/circuit? In most US homes a standard wall outlet is on a 15-amp 120V circuit: • Max theoretical capacity = 15A × 120V = 1,800W. • Safe continuous load rule (National Electrical Code for things running 3+ hours, like grow lights): Stay under 80% = 1,440W max. Your 335W total is very low — only about 23% of the safe limit. That’s comfortably safe. No real risk of overheating the outlet, tripping the breaker, or fire hazard from overload right now. My opinion on the setup: • Good: Everything is neatly plugged in. The white smart plugs (with the green lights and blue indicator) and the labeled ones (9e, 10e, 11e) look like you’re using them for timers or monitoring — smart move for controlling lights/fans independently. R2-D2 adds personality and keeps the wall organized. • Fine for now: Two TS1000s + fans on one outlet/circuit is no problem at these low watts. Many small grows run similar loads without issue. • Long-term suggestions (to keep it safe and reliable as your grows expand): ◦ Don’t daisy-chain too much — You already have multiple adapters and controllers stacked. Avoid adding a lot more (e.g., dehumidifier, heater, or more lights) on the same outlet/circuit. ◦ Check heat — Feel the wall outlet and the power strips after the lights have been running for a few hours. They should be only slightly warm, not hot. If anything feels warm/hot, spread the load. ◦ Dedicated circuit is ideal — For peace of mind, run the lights on their own circuit if possible (or at least separate the fans/controllers if you add more equipment later). ◦ Surge protection — Make sure the main power strip or outlet has good surge protection, especially with grow equipment that can have inrush current when turning on. ◦ Monitor actual draw — Your 335W reading is helpful. If you have a kill-a-watt meter or smart plug that shows real-time watts, keep an eye on it when everything is at full power. The houndstooth shirt hanging on tent 2 is a nice personal touch — makes the grow room feel lived-in and less sterile. Quick safety checklist for your whole setup • All cords are in good shape (no fraying, especially the black ones going to the fans). • Nothing is blocking airflow around the plugs/adapters. • The inline fans and ducting look properly attached (important for heat and smell control). • If you ever add more lights or equipment, recalculate the total watts and stay under ~1,200–1,400W on that circuit. Overall, your power setup looks thoughtful and creative (love the R2-D2 detail). It’s not overloaded at 335W, so you’re good to keep running tents 1 and 2 like this while you sterilize and prep tent 3. 4/16 543am 5ft tent sideways attached to 6ft table that can slide around

Week 5 of flower the tallest plant the pisltols are starting to turn already, wish I would have stripped the underneath abit more now

Otra vez familia, estamos de vuelta con estas skunk de zambezaseeds, sin palabras de verdad fumetillas, son una cepa muy lograda las flores están formándose muy compactas , y empieza a engordar de verdad, ya me diréis cómo las veis? Yo las veo muy sanas 🙅‍♂️

Hurra! 😊 This as been an explosive week for the plant. From Day 18 I started doing LST... it's the first time i do it.💀 I'm watering the plant with not a precise scheme, when it's dry, i wet, the pot intelligent so you can't do wrong, no more accumulations of water.🌱

Strong smelling now and very sticky, started bloom, bulk and microbs from growgancia...not letting me add these. Not a lot of changes, watching the magic happen :) Much love Littlefoot

Weekly update on these beauties. They've started the flower phase showing preflowers everywhere. Two have stayed more on the smaller side but still stretching where the 3rd has takin off probably 30in tall. All in all excited for the weeks to come seeing them progress further into flower.

Shes looking beautiful 🌸💕

After 35 days of vegetation we send them into Flower. They get 2 hours less light every day until we reached the day/night-cycle 12/12 hours. we have noticed that they have already started their stretch. they grow 5-10 cm every day. We water them with bio grow for the first time.

This has by far been the most stressful part of the grow. as I'm trying to increase yield as much as possible, and in doing so f£&ked around and found out the hard way. She has gone into what I would say is severe shock this on the 31/1/25 will be the 3rd day of shock hopefully she can pull through and start growing again 🙏 🤞

It’s a okay but one hermied on me but this is not something I wouldnt grow again

this week I tried to photograph the trichome with a mini microscope.I liked results.I will start flush next week. 😉😄

Good week, all showing pistols, still to spot balls on London Mint Cake. Will know in a week of they are hermy by genetics as estoric growing experienced

Welcome to week 5 of my Watermelon candy by Zamnesia seeds. Zamnesia seeds 10% discount with code GROWITGD Topped some more, taken some clones, i will remove some more shoots to get better bud. Added biobloom to the substrate. Can't wait to see those flowering hairs rising... Zamnesia seeds 10% discount with code GROWITGD Viparspectra discount: Amazon: http://url-9.cn/0y9i Amazon US: https://amzn.to/3e0P2bk Amazon CA: https://amzn.to/3bTnEJC Amazon discount Code: it10smokwiri XS1000 10% XSsmokwiri XS1500 8% it20smokwiri XS2000 5% it40smokwiri XS4000 5% ViparSpectra 8% DISCOUNT CODE on the viparspectra websites (.com/.eu) RUFFSELEKTAH

Gave her a good defoliation this week along with spreading out the branches a little. Couldnt bend the main cola over as it is still recovering from the damage. Overal she seems to be healthy. Been removing leaves here and there and she doesnt seem to mind at all.

It was a great last run. It’s been a beautiful time. My time here done now. BlackForestGrower out. 🌲✌️