Lollipop the bottom 1/3. Plants are around 18" tall. Looking great. These girls look like they are ready to begin flower so they got flipped day 45.

Granddaddy plant in week 6 of flowering. She is in full bloom. Bugs Issue: There are some old caterpillar holes on leaves but I think bugs situation improved. The smell from plant dropped last week after first round of insecticide spray. Smell is like plant crying out in pain after being attack by bugs. I sprayed spinetoram one more time in the beginning of the week. Late in the week, I used a USB microscope to check. And there was a Protoss tank patrolling a leaf on plant 2. On the bigger plant, I just saw carcass of dead mites strewn around. Prepping plant 2 for an early harvest. I am always happy on harvest day. Trim her and let the pot dry out for a couple of days. And plan to spray my garden with third and last round of spinetoram. Next week, I am going back to microbes. Plant 1 is doing fine. She is bigger and handles pests better. Her flowering cola’s also smell nicer. Plant 1 phenotypes is much better than plant 2. And I removed some leaves. This past week, I fed both plants with half strength potassium based orchid fertilizer. Plant 2 shows slight tip burn. So, this is the feeding limit. Plant 1 leaves are nice and green. A few leave started to yellow but I am not bothered by that issue at late flowering stage. Next week I’ll just give plant 1 a dose of yogurt and start pre-harvest preparations. Trimming, flushing, and all that. Transplanted a clone to 25-liters basket. She started to put our pistil. This is one issue with Mycorrhiza. It over stimulate the root. And root tips put our too much cytokinin that signals flowering.

10 September Harvest - see pictures. While some growers leave the plant whole when they cut, I do not. It is a personal preference and situational convenience if your a home grower. I chose to cut large, long branches, and remove any whole water leaves, as long as it doesn’t interfere with the bud formation. I don’t trim yet. This is done for a few of reasons: 1) It’s my last good close-up look at her until another 5 days or more, 2) I don’t want wet leaves drying on my buds if I can help it, and 3) I occasionally like being able to shine a small LED flashlight on the flowers while its drying. Mold is our greatest problem as growers, it can destroy a beautiful grow right up until the end process. Then I hang it in a dark closet, provide circulation and ventilation. Light and heat, anything above 80 degrees F, will start a break down in cannabinoids during the dry, it is ideal to stay away from both. I’m fortunate that a humidity level of 50- 55% and temperature of 65-70 degrees F is fairly consistent and easy to maintain. Anything below 60 degree F will prevent the adequate drying out of chlorophyll. Almost all my flower routinely take 5-7 days, some a little longer, to properly dry out. 15 September Trim - see pictures. First you’ll notice the buds have shrunk up to half their original size. This is just a fact that we growers have to deal with. Due to evaporation without uptake of water, it takes about 3 days for the chlorophyll to dry up, then slowly go through a chemical change. Along with the leaves, cannabinoids also begin a chemical change after 3 days called decarboxylation. A slow process where the THC level increases while curing. You want the leaf to be dry so they can be hand trimmed easily, but you do not want that bud so dry that it starts to fall apart in your hand. Try to handle carefully by the main stem to avoid touching the bud all together. A lot of these cut leaves will be covered with trichomes, good for making oils, or other products, it’s an option worth looking into keeping it. After trimming, I do separate a few premium flowers for my first smoq. Then loosely fill wide mouth quart mason jars with about 1 oz/28 gr of product per jar. I seal the lids for a few hours to determine what relative humidity they are at, see hygrometer pic, before making a decision to put in a 62% humidity control pack of my choice or to wait, then place in secure in a cool dark place with stable humidity and temperature. It is very important to then observe/burp or exchange the air as needed, up to several times a day, until 62% rh is achieved. Once your close to to your mark, put in your desired RH level control terpene shield. If you have a problem getting there: 1) it has dried out too much, no real solution, try to put several large cut stems left over from harvest into the jars with the buds to try and increase humidty, 2) it has not dried out enough, in this case no problem, just remove and dry out a little more. This is also a personal choice, some people like it drier in the 50% plus range. Whatever you do, research and preserve. At that time burping is no longer required. Cannabis will reach its peak potency potential at about 40 or so days into the cure. The finished product should be a perfect grind when cured correctly without clogging up your grinder, this could take a month. Now that I’ve said that, I’m sure someone has grown something that they have not been able to grind. It can remain in this state for an easy 6 months with little change, locking in all the terpenes and potencies. All you need to do is occasionally check the product to ensure there are no molds. If your grow/harvest/cure techniques are good this should not be an issue. It would not be uncommon to find many cannabis strains will last, with small degradable change, for up to one year after being stored this way. Using an airtight glass container, controlled relative humidity, maintained low temperature, and kept in darkness will equal maximum shelf life. Always avoid direct sunlight and temperatures above 80 degrees F. The reasons I’ve ultimately chosen Deep Water Culture as a grow medium. Each has their own pros and cons indeed. I found the most efficient, less maintenance and ideal solution for my situation was DWC. Burdens to overcome depend on size up set-up; initial equipment cost, size of containers, ph monitors, air pumps, type of water to use-reverse osmosis, RO cost/set-up/maintenance, ways to transfer/change water and nutrients, what nutrients to use and schedules, takes several grows to learn and understand, a 1 year learning curv, easy to nutrient burn. The Benefits of growing in water; no dirt, no bugs, no diseases, rare nutrient deficiencies/toxicities, steady and rapid growth that enables the plant to reach its genetic potential. After harvest, there is about a 1 hour equipment cleanup, sterilization and turn around process before replanting. Cannabis will perform in so many different ways and mediums, no one way is the best and the best way is the one you are using, right. Chose what works for you in the long run. There will always be an initial cost in set-up. My advice if one were in need to cut corners, I would not recommend cheap lights. This single factor is the most critical, afford for the best. The notion that organic and water has a different taste, flavor and potency effect is absolutely debatable. The more we learn the better we grow and experience is always the best teacher. This is what works for me and my methods of growing in general from beginning to end. A BIG “Thank You” to everyone who stopped by to take a look. My next diary will start at the beginning of October 2023 with a Forbidden Runtz Auto. There will be minor differences during the grow. I enjoy Auto strains simply by what can be achieved in a short time. No matter the strain they will unveil one thing in common, the demand for attention. Many times over it is the anecdotal gardener that surmount plant scientist. Last should I mention, do not forget to stop and enjoy the fruits of your labour...

Plantas muy facil de cultivar y muy rapida .. en solo 9 semanas me saque en la #1 85g y en la #2 - #3 unos 50 cada una... en cada foto teneis el seguimento de cada planta desde la semilla a los cogollos.. consejo para todos de el banco de sweets seeds ✌️✌️

De esta semana destacaré el cambio de luminaria, los Cob por el ATS Pro 300W. al 75% que vendrian a ser 225W. áprox. Algo menos de W de lo que estaban pero al tratarse de una nueva luminaria con más umoles no creo que se me estresen mucho. Más adelante cuando ya estén floreciendo subiré al 100% 300W. Riego cada 3 dias , a final de semana 900ml / planta. Último dia de la quinta semana poda de bajos , añadido unos tutores y el esperado 😜CAMBIO DE FOTOPERIODO a 12/12h. 🙏

Hallo zusammen 🤙. Habe heute das Männchen geerntet. Das Weibchen wächst sehr schön und macht keine Umstände.

Skywalker putting on tons of frost and seems to be happy with the status quo so no more compost teas for her. Starting to have a distinct Kush scent filling the tent now. In the future I’d probably LST this from the start to increase yields but other than some defoliation throughout, I haven’t done any training which has been nice. Blueberry impressed me with the size of the buds starting to form. Signs of frost for sure. Not very aromatic yet at this point. Stem rub is a different story. She has been showing some signs of calcium/mag deficiency in some of the leaves which seemed to improve with top dressing/Recharge. Been drinking a steady liter minimum daily Glueberry OG continues to explode in growth. I’ve done quite a bit of defoliation to keep tops exposed and it has bounced back quick each time. I can see why this would be a fun strain outdoors, as it is slowly taking up a solid 4 square ft of the tent. I may end up finishing this outdoors depending on its desire to consume the canopy space. Due to the longer flower period, I’ll keep up with compost teas to support all that growth. So far, it seems to be working Week ended 7/20

*English below* La planta está terminando su sexado, comenzando flora, día 2. El stretching fue una locura, de una planta de 70 cm (que use la mitad para hacer esquejes), en solo 15 días crecio arriba de 1.5 m. La primavera en buenos aires acompaño con un clima perfecto los últimos dos meses. La planta tuvo 70 días de vegetativo. 2 day blooming, the stretching was massive, the plant was 75cm and now it's more than the double of that size. Half of the plant was used for clons, so in 15 days of stretching, 35 cm of plant became this.

El color amarillo que se muestra en una de las calamity jane es debido a un mal riego ya qué pasó a llevar las hojas y por el efecto lupa 🔍 quedaron quemadas y de ese color

5/10-Last week went well. She is still growing like crazy! The clones are growing super fast also. I can't imagine what it will do once put into the ground. It's a super drinker and is a very vigorous grower. It takes all forms of training with ease such as topping, lst and supercropping. Hope it's a colorful plant so it will look nice when done. Will be going outside in the next 2-3 weeks from today. Until next time happy growing to everyone!

Geht gut ran

Tag 21 - Ende der 3. Woche. In dieser Woche habe ich den Wachstumsdünger nochmal ein bisschen erhöht. Die Pflanze entwickelt sich sehr gut und voraussichtlich werde ich im laufe der nächsten Woche das Licht auf 12/12 umstellen und die Pflanze in die Blüte schicken. An Tag 15 wurde die Pflanze gedüngt. Nährstofflösung: 2 ml/l - B-52 Advanced Nutrients. 2 ml/l - Voodoo Juice Advanced Nutrients. 2 ml/l - pH Perfect Sensi Grow Part A 2 ml/l - pH Perfect Sensi Grow Part B Davon hat die Pflanze 500ml an Tag 15 erhalten.

topman! For so long there was no answer for weeks, because at the time when I could take pictures and write, ultraviolet worked - you should not interact with it without protection, and there it is +30 ... heat, even more so in clothes! All the leaves were burned, but how the firebrands swelled !!! Flushing is over, today or tomorrow we will “cut down”. I was glad to work on the bugs with this strain, it showed how cool and persistent it can be, it is the strongest in the box (unlike him, Amnesia and Tutankhamon did not cope with 2 hour UV and were “cut off” a week and a half earlier ). After preparing the crop, I will give data on the wet and dry components! Thank you for your attention! Further-more. (s)

Did a light feed flush on Saturday 10-11 and started her on 12/12. Got her first Bloom feed on 10-14. Shes already moved, from 3 days to every other for water. also did a light foliar spray of epson salts. the day she flipped, so it wouldnt affect the sites. after 2 days, she already showing hairs in her bud sites. much quicker than my first time. it took a week. im happy with her space, hopefully don't have to do much till, day 21ish! Oh and Silly kitty! 😻😹

First day for my mac stomper clones from roots_farms 💚

Candy gas ⛽️ 🍬

64 days after i planted her seed directly in a pot outside 😱the reaper came, i hung her upside down for 6days then cut her &put her on a net to dry some more While cutting I found some little catterpillars about 5 guess that were the eggs that I found on some of the plants last week.☺️ After a few days drying on the net i weighed it:53,6gr The taste is great I'm very happy with the result catterpillars included☺️

27/04/2021 (Day 42) Todo viene muy bien, las plantas están comiendo con muchas ganas y consumen unos 15L de solución diario. La preflora está comenzando! Ya se puede observar como van estirando y mostrando bastantes pelos! Los Citizen x 8 están trabajando a un 80% rondado los 500W. 28/04/2021 (Day 43) Se realizo un nuevo cambio de solución, las plantas ya están tirando pelos y los leds están al 80%, se observo un gran crecimiento radicular y las paredes del tallo son increíblemente gruesas y duras. 03/05/2021 (Day 48) Las plantas vienen con un crecimiento optimo pero la flora se está tardando demasiado en hacerse presente, se estima que es debido al estrés que tuvo en semana 3 de vege produjo un retraso de algunos días. Esta semana se incorpora Safe Roots al sistema con la finalidad de que deje la solución lo mas limpia posible. También se realizaron bastantes defoliaciones ya que no existía penetracion de luz teniendo en cuenta el tamaño que están ocupando (85% del espacio de cultivo a 30/35 cm de altura)