Vote Now 🏆 for the Grow Awards 2025!
Likes
84
Share
@Hempire
Follow
Nice buds growing :D I’m quite impatient ! I will put PK at the 30th 35th day I wait the buds bigger ! I do defoliation a lot and every day it’s insane how it grows every day ! I pinched the apex of the plants which I didn’t cut the apex.
Likes
20
Share
Day-43. Girls looking good. Still in the transition. One of the StarD girls has really had a growth spurt. Using next to no nutrients. 02/05/18-Day 48- Very pleased with fast buds, my first AUTO grow and they are taking off a treat, much easier to grow than photoperiods. But then again I treat them similar in terms of just defoliating as normal and LST'ing. Probably a little bit more sensitive to nutrients.
Likes
20
Share
Day-43. Girls looking good. Still in the transition. One of the StarD girls has really had a growth spurt. Using next to no nutrients. 02/05/18-Day 48- Very pleased with fast buds, my first AUTO grow and they are taking off a treat, much easier to grow than photoperiods. But then again I treat them similar in terms of just defoliating as normal and LST'ing. Probably a little bit more sensitive to nutrients.
Likes
8
Share
@Eauderay
Follow
Dinafem Critical Cheese is one of the best plants I have grown! Resistant to mold ( at night sometimes the humidity reached 99.9% and so the wall started to show fungus marks, the situation was rectified by adding an extra fan) . Critical cheese is a pleasure to grow, especially one of them who smells like strong lemony cheesy goodness and is very sticky, my room smells so strong when i open the grow room door! I will try all of Dinafem seeds in the future!
Likes
29
Share
Feed Started With Tap Water Left Overnight For Chlorine/Chlorides To Evaporate. Next Day. Starting EC of our water is 0.15. I added 1ml of Rhiz Per Litre. Then Used Canna Terra Vega Until EC measured 0.4. I then used the mighty growth enhancer drop by drop until my EC measured 0.7 Finally i PH'd the mix to 6.2. Made sure the feed was of adequate temp and continued to feed. Next Two Feeds Are Just PH Water with a few drops of Rhiz 😎
Likes
10
Share
This girl was a treat to grow. A little scary when I first broke her branch but she recovered well. She is pungent and quick to stink up a room. Covered in trichomes. I have sifted her trim for kief and it was very flavorful through my vaporizer. She is a couple rh% points away from curing. Can't wait until I get to really smoke/vape and enjoy her. She was so delightful that I decided to do a really slow dry and cure. All is well :)
Likes
6
Share
@jazzbass
Follow
Hello again, since it's been so fun so far I've decided to give it another shot and threw two more seeds in some cups of water: #1 Sweet Mango Automatic by Green House #2 Royal Jack Automatic by Royal Queen After 36 hours the Sweet Mango had popped beautifully and was ready to be transferred in some juicy soil, didn't have the same luck with the Royal Jack tho 😕 I'm really curious about this strain so I'm a tad disappointed by it (also about the price 😓). I'll leave it in the cup and hope it will do its magic. - update 2 #1 SMA everything is going as planned, the stem looks really good and the first fresh leaves are coming out. aaaal good #2 RJA guess what? the little bastard is slowly slowly and slowly breaking and a little root is coming out, maybe I haven't lost it just yet.... still in the cup :D
Likes
6
Share
We are in the first week where the growth was good, watering was done only with water without adding fertilizers.
Likes
52
Share
2nd week complete! Its growing day to day, with noticeable changes. Im waiting one more week before I switch to 12-12 and change it to the 12L container. I've been watering every 2 days, about 50 ml each time I water. One feed, one water, thats the schedule. I noticed that there are a lot of bud sites developing in the branch formation, so excited!! 👻
Likes
3
Share
@Fergie
Follow
Hey guys so here is my blue cheese mutant starting to beef right out ww . some pure dank smells coming from her am super phyced to taste this girl .
Likes
2
Share
Day 44 - Some lower leaf issues on the Sour Stompers, mostly #1. I've switched to just pH'd water the last 2 waterings, might continue to hold off on nutes until the roots are strong enough. Some minor burning on 4AM as well but not as bad.
Likes
8
Share
@Fergie
Follow
hey guys so here arw my 2 LSD 25 coming along nicely . 1 is in a 5 gal and 1 is in a 10 gal smart pot , awaiting new tent arrive in a few days so can re home and allow to florish .
Likes
88
Share
@Fergie
Follow
hey guys so finally the swap to flower is here . these girls are expolding . i am waitinf on one 20 gal pot and a new tent to move rest autos in should be here in a few days fingers croseed . All going really well on this clean run with no nutrients so far .til next week 😀
Likes
82
Share
Week 7 Flower We've finally started flush 💦 on Day 43. I still run EM1 at 1ml/ltr as it goes a long way once activated/stretched. It's always going to be a benefit to keep any microbes you can in the coco. You can also use Mammoth P throughout flush, but due to its price I just stick to EM1 in flush. There's plenty of other microbes that can be used too. I flush around twice the pots' volume at 6pH. But before flooding the pot I slowly pour water through the centre of the pot, around the stem, in order to take a true reading of the ppm and pH of the run off. If the ppm/ec reads a lot higher than your average feeding throughout bloom, then there's been issues such as a lockout, incorrect pH, over feeding etc. This wasn't the case, as this girls' was at the right level. If the pH is too high or low, I adjust the pH of the rest of the water that'll be flushed to try to fix it. Again, this wasn't the case with this girl as she had a perfect pH 👌👍 Just before all of the water has gone through the pot, I take one last reading from her last bit of run off. The ppm should be down to no more than 100ppm for the first flush (+starting ppm of water if using tap water). After the first flush the ppm value of the run off will quickly go all the way down to 0, or at least below 50ppm (+tap water ppm). I use tap water that is between 150-190ppm, but I'm looking to switch to RO as soon as I can. I still get a very good flush, but I think using RO water will be the next step in getting a more thorough flush as it won't contain even the small amount of nutrients and metals that tap water contains (along with any harmful chemicals). Always remember to bubble or let the water sit for 24-48hrs before feeding to your plants. That goes for all feedings in every stage of growth if using tap water. Because I keep fairly low temps in the Den she's starting to turn a beautiful dark purple. Her buds are still swelling and smelling like a nice gassy OG, with hints of citrus/tropical fruits. I'm really looking forward to taking this girl down, but after at least another week! Thanks for following and happy growing! 🐺
Likes
82
Share
Week 7 Flower We've finally started flush 💦 on Day 43. I still run EM1 at 1ml/ltr as it goes a long way once activated/stretched. It's always going to be a benefit to keep any microbes you can in the coco. You can also use Mammoth P throughout flush, but due to its price I just stick to EM1 in flush. There's plenty of other microbes that can be used too. I flush around twice the pots' volume at 6pH. But before flooding the pot I slowly pour water through the centre of the pot, around the stem, in order to take a true reading of the ppm and pH of the run off. If the ppm/ec reads a lot higher than your average feeding throughout bloom, then there's been issues such as a lockout, incorrect pH, over feeding etc. This wasn't the case, as this girls' was at the right level. If the pH is too high or low, I adjust the pH of the rest of the water that'll be flushed to try to fix it. Again, this wasn't the case with this girl as she had a perfect pH 👌👍 Just before all of the water has gone through the pot, I take one last reading from her last bit of run off. The ppm should be down to no more than 100ppm for the first flush (+starting ppm of water if using tap water). After the first flush the ppm value of the run off will quickly go all the way down to 0, or at least below 50ppm (+tap water ppm). I use tap water that is between 150-190ppm, but I'm looking to switch to RO as soon as I can. I still get a very good flush, but I think using RO water will be the next step in getting a more thorough flush as it won't contain even the small amount of nutrients and metals that tap water contains (along with any harmful chemicals). Always remember to bubble or let the water sit for 24-48hrs before feeding to your plants. That goes for all feedings in every stage of growth if using tap water. Because I keep fairly low temps in the Den she's starting to turn a beautiful dark purple. Her buds are still swelling and smelling like a nice gassy OG, with hints of citrus/tropical fruits. I'm really looking forward to taking this girl down, but after at least another week! Thanks for following and happy growing! 🐺