Day 36 to 42
I haven't been able to strap down Stardawg #2 (bottom left) much because I cracked the stem slightly. It's healing fine and not a major concern but I'd rather hang on a bit.
# Day 36
- Fed 410ppm full strength to FR1
- Fed 360 ppm half bloom(1:2 bloom:veg) to rest until they are flowering more.
# Day 38
- Fed 710 ppm full strength to FR1
(I am going to start boosting higher now, I should have been at this strength at week 3-4
- 360ppm half bloom to the rest
# day 40
- 810 ppm to FR 1
- 610 ppm to rest 5:1 veg to bloom. See nutrients ratios above
# Day 41
- Plants were looking dry and I was nervous about how many nutes I fed them so I fed them water PhD to 5.8.
- FR1 FLUSHED with 5.8. I chickened out 🐔
Hi, I want to mix up a strong (let's say 3000+ ppm) solution in say a 2L bottle at the correct ratios. When I need to feed, I pour it into a fresh jug of water until I reach the desired PPM, then close up the 2L and repeat. Any downside? Does the solution get "weaker" that way?
as long as your ph is meeting correct levels for nutrient absortion and your ppm/ec isnt too high upon that jug give her a good stir make sure not too cold and just observe how your girls react!, this is how i did it for abit there but i just stick to my 1L phd 6 rain water then add my nutes and double check ppm/ec but its usually was spot on majority of time. just make sure you double check and shake the bottles before pouring nutrient liquid into the jug so it can be evenly dispersed among pour (y) looks great mate
@Ararhiel, yes sir!
2x Mars Hydro TSL 2000
Each is 300w. For most of this grow I ran them at 100%. I think I can reduce down to about 500w (250w each) and lower height a a few inches and get the same result.
Thanks for stopping by 😎
Happy growing! I hope you get some good results! Take care and stay lit! I will drop by sometimes to check on your process! Say hello if you ever visit my page!
Peace & Love - L.S.T 🙏🏼🌟
Login
