The first issue has popped where I noticed some brown spotting on some of the leaves. Given the timing/symptom, I thought it most likely they've burned through the P from the basic nutes and were begging for more. I've added the PK nutes into the mix at roughly half the dose as I've done with the Canna A & B but went a little over as there's a really high density of bud sites.
I checked in after quiet time a few hours later and saw a swell on the main Colas immediately. I'll probably be keeping them on this mix right up til harvest but will be watching out for any more spotting.
Update day 53 - No more spotting showing so its seeming I diagnosed the problem right! They've all launched into heavy pistil production but no obvious signs of trichomes yet. Still an amazing smell coming off them and plenty of big healthy Colas. Marge doesn't seem to be stretching as much as the other two but I can't tell a cause for certain so I'll just carry on as usual and keep a close eye for any other signs.
Nice my friend, I would definitely recommend topping as it can seriously increase yield and I find it easier to lst.
Buy if your gonna top then do it just before you feed then it helps with the stress πππ
@Kommandant666, never fimmed mate only ever topped and trust me I wouldn't go back to natural.
Key is nice healthy plant growing day by day top between the 2nd or 3rd week depending on growth and after you do it feed them it helps with the stress
I seen a guy put a small bucket in his tent with a towel half in and out if the bucket, pointed the fan at it and the towel acted like a wick and brought water up then when the fan air hit it presto it raised it and in the plus side if it goes up to much you can lift it out πππ
@Green_fiend, I actually tried the towel method with my NLA grow but it didn't work so well, a lot of hovering over it and making sure it didn't dry or get too humid. Wound up just placing a water dish in the corner and letting the heat from the lights do the work. Normally sit around 35% and that raised it to a nice 42 - 48% pretty reliably. Think there needs to be a pretty specific temp range for it to work like this tho, just been super lucky π