First hydro and led setup.

Hi! I have modified a similar system. It is the nutriculture's version of the Wilma. I drilled extraholes for the roots to go in to the solution and I leave the pumps on 24/7. I change the solution once per grow cycle. The continuous flow oxygenates the solution, though it releases moisture too. Just keep the plants happy, and when flowering begins, I believe the systems makers also recommend to leave the pumps on for the whole time the lights are on. I may recall wrong. If you leave them on, you can spare the pumps by setting them to go on for 15 min few times during the dark period. Experiment, the interval will reveal itself. Also, you will probably get better answers here too ☺️

They seem fine like this, plus the dripper isn't too close to the stems, i'd let them like this for a week maybe. Then slowly increase the watering schedule. And after a few sets of leaves, they should be big enough to take away the timer. But from my experience in this system, and no matter your watering schedule, the roots WILL grow in the reservoir and clog the drain holes. So drilling extra holes is, to me, needed, and the plants will be able to grow their roots in the solution like in a hybrid dwv - air pump is required though.

Depends if the other room is on a diff circuit breaker. Your upstairs will be on one breaker downstairs will be on another. Should be on a 32 amp breaker anyway so I think you'll be fine.

You should be fine at that rate for watering, you just want to make sure you have your PPM on point for feeding and to make sure your PH is correct, they look good and healthy for sure, keep up the good work

As for ur light if its a 600w. 100% is far to much. 35k max lux is all tats needed. So use a phototone app use it from 30cm away at 100% this will give you the heighest value & from there you'll know how powerful r have a kinda guess that'll allow u to make up ur height. But 100% at 60cm is far too high.

Huh. Different spectrums have dif luxs. All you need is a full spectrum veg/bloom. Leds today are all in 1. Anything with 630-660nm reds and 3500-5000 blues/warms these are the norms. You can get old spectrum like mars & spider farmer use to use IR/UV in their spectrums but found a much better one. And as of mid 2022 most if not nearly all led makers are following this suit. In ambient conditions all u need is 800-1000ppfd tats 40-55k lux depending on ur light. Specialty leds out there u can control like medic grow u either use Veg r Bloom. Hmmm. Again..a good light maker nowadays with a full rounded spectrum will allow you to run vegging plants as well as fems tat are in flower r what if you have autos and 1 flips a wk earlier. Tis why I like an all rounded spec like for this reason.. tat and I my tent does be rocking 18/6 24/7 with fems and autos at all varies stages. Yes/ its key for me to have a lux meter. But for reg grows that are all r near the same stages a photone app will di..

The proper LUX or Light requirement for our plants are as follows. If you don't have a LUX meter you need to get one. It's probably the most used/useful growing tool I have. Seedlings, 10-15k LUX Veg, 20-30k LUX Flower, 35-45k LUX Do NOT go over 50k LUX you will bleach your flowers. -damianfox

High Roope, you give the Blooming nutrient solution when you see the first white hairs (pistils). And you can use the net to make a SCROG and cut away the growth that doesn't reach the net to support airflow and let the plants focus on the larger buds. Enjoy your grow!

It'll help with the overcrowding issue. You'll be able to take a lot of bottom growth. That will basically need to go regardless as you're gonna find. They'll double in width and so on. Really there should be 2 buckets in there. Then you'd get a full length grows. But as they're setup. Real issues on the way. With larfy airy bottoms etc. A net will help you build a base and enable you to grow closer to the bud sites rasing the height of the bottom of the canopy without sacrificing bud. Really is your only option. Either then or you get a bigger tent. Or consider taking one out,,r lollipop.

I really don't get much of what you're saying to be honest. But here goes. 0 I see you're already giving high bloom. Really, it's not needed, any change in NPK until you're just leaving pre flower..as it uses a lot of N in pre flower .probably more so, depending on the foliage growth of your plant going into pre flower and during. So, you actually should have a grow Npk.Or something more on a 3-1-3 ratio. You'll get through it o reckon. As for your space. You're going to have so many possible issues. Its way too crowed for hydros imao.. I really would consider throwing a net over that..as you said. They're all pretty even. Any that stretch mad can be pult down.

I truly don't understand the question your asking. if it is a question. Maybe try again with less google translate? Plants are looking good, you can always use 2 SCROG nets if the other one is to low and can raise it anymore. Keep up good airflow in a tightly packed tent like that. and defoliate when needed. Good Luck!

If you have no choice but to use that plant, by all mean attempt to clone it brother. The longer it has been in the flowering stage the harder it will be to transition back into a vegetative stage. I would recommend you turn the cloning lights on for 24/7 until it takes root and begins to grow.

I don't recommend that you take clones from blooming plants because it's jeopardizing the original plant. but its doable and you can force the clones back into veg (I believe, but I have never tried it myself) Good luck with the rest of your grow

Puedes hacer clones con esquejes en vegetación y con esquejes en floración. Los esqueje en floración van a tardar un poco más en enraizar por que tienen que cambiar su fase de floración a vegetativa. Procura tener la humedad en 90% es lo primordial para hacer esquejes. Suerte

while it takes longer, i don't see a huge difference in success rate with flower plants. i do take a couple extra as an insurance policy. keep the water fresh and should be fine. the healthier the plant is, the better the chances clones root.

You will need to re-veg them, toss them into a moist medium with some rooting hormone under 18/6 dimmed low lights and manage the heat. As long as you can get some roots forming then your ok. Re-vegging cannabis can get funny growth. be aware of it. Once they are back into veg you can grow it out and start the flowing process all over again. Good Luck!

It's worth a try. First put them in water to give them a boost, then move them to a separate pot. I think they will have a bit of delay behind the rest of the plants but they will grow and give you more buds. Good luck with the rest of your grow

Your plants look good and your SoG looks amazing. In regards to the last image (the close up one) you have nutrient burn so maybe tone down the amount of nutrients you're giving the plant. Good luck with the rest of your grow and enjoy the yield.

Ich glaube er meint: er hat Clone von seiner Mango genommen und die sind in 2 Tagen verschimmelt. Er will wissen warum die Clone schimmeln und wie er checken kann, ob die Roots anfangen zu wachsen. 😎

what?

Why not let it grow naturally? why stress the plants? :)

I think it's a bit late to defoliate more , you could remove some small buds where light does not reach , but seems you fed them properly , they will be a pain at harvest , but it is what it is 😂

You must clean plants legs around week 3 of flowering. It’s going to be a nightmare to harvest.

Hey mate, you can find proper cooking instructions: oil, butter, alcohol,... on youtube... just search for them and you will find a lot of them, basically whatever you want you can find on youtube...

Repeating leads to Perfection. Legs trimming is very important to avoid wasting energy on fluffy popcorns buds. Looking at your pictures, the light seams to be very close, be careful to not cook the terpenes.

Defoliation to hide mistakes and for esthetic- DOESN'T WORK. Its heavy technique for healthy big plants, more comercial use than home. And i am big fan of defoliation.

look into bubble hash, making it is worthwhile when you got a lot of extra plant material.. can still smoke it or cook with it. Best thing to do with weed that's got no bag appeal but still has purpose and trichomes. Good Luck!

They looked f@cked, degrading leaves will bring mould and rot. First on the left done 4sure. If they consume water , they will live if no or almost none , all done .

Oo 😮 what's your EC? Check the roots, download the ppfd meter, and do the DLI12 with the light, looks like you are burning them with nuts or with your light, did you lower your light close to the plants? Did you make your feed stronger?

What the hell have you done to those!? 😂😂 stick to buying bud dude

Dammn they look toast. How did this happen was it heat ? What a shame as they looked good and it's a good set up .

Das ist sehr traurig. 😞

Absolutely! Learning often involves making mistakes, and it's important to stay positive and resilient. Keep that determined spirit 💪😎, and you'll continue to grow and improve. If you ever need advice or encouragement, feel free to reach out!

Mistakes makes us stronger. Sad ending, but i think you learned a lot. I screw up with grows during holidays or sudden offs almost each time. Plan life better if you can .... All was very nice, youll do better - no doubts !!!

Lo lamento mucho amigo. Buena suerte para la proxima

You can either make some fire hash or press it. It's gonna be some night time COUCH lock medicine for sure growmie. Well you never selected a answer. I'm just here asking for it to be me lol. I would appreciate it, I'm trying my best to get a chance to win grower of the month.

Turn it into hash. its going to couch lock you good when you smoke it. Lots of CBN in that,

i think your plant partially died. looking over the last couple diary weeks.. when it turned brown was that immediately following your pump issue? the outer portion likely died. if this is the case, harvest asap.. just inviting some sort of rot or worse... i'd thoroughly inspect it for issues as is. something isn't right... maybe ask someone you don't like to test smoke it, first :P jk Some plants don't amber up, fyi. always good to use more than one observation to pick your harvest date. though due to pump malfunction and potential damage that did, hard to tell if that was the case here. your plants went from green to brown in a short period of time, it seems.

Yeah things were outta hand for a while they looked dead for some time there

F

It looks like you let things dry out. It's not the end of the world if you were doing your pre-harvest flush. Just pick off all the buds, trim them up best you can. Toss all the bud into a ziplock bag and spray distilled water inside and close it up and put it in the cupboard for 24 hours. After that open it up and check the feel of the flowers. If they still crispy dry add more distilled water and close for another 24 hrs. Keep doing that process till the flowers feel the right consistency. If you want to make them really hydrated like fresh cut bud, spray a lot of water in there so they are quite soft and not feeling crispy at all. Then you can lay them out on a rack and dry them slowly and carefully as you would have under normal circumstances. Then you can slow dry it and gas off your flowers. Then bag them up in a grove bag with a small humidity monitor. Try to aim for 62% humidity. The grove bag will ensure 62% humidity. Then just keep it in the grove bag. It will cure right in the bag. No need to open and burp it.