By continuing to use the website or clicking Accept you consent to our cookies and personal data policy and confirm that you are at least 18 year old. For details please see Privacy Policy and Terms
ReeferRiz Lights 16 inches away at 50% dimming humidity low (30-50%) will be adding humidifier next week. Seed successfully sprouted out at day 4. Temperature has been maintained between 70-75 degrees.
likes
2 comments
Share
Used method
Rockwool Cube
Germination Method
1
Week 1. Vegetation
2y ago
2.54 cm
17 hrs
23 °C
6.3
No Smell
500 PPM
40 %
24 °C
18 °C
19 L
40.64 cm
Nutrients 2
V2 Vegetative Part 2 5.208 mll
V1 Vegetative Part 1 5.208 mll
ReeferRiz Seed casing stuck on till day 7 I decided to pull it off after soaking with some water. Added nutrients at beginning of week 1 veg. Lights in same spot dimmed at 50%
1 like
1 comment
Share
2
Week 2. Vegetation
2y ago
5.08 cm
17 hrs
22 °C
6.4
No Smell
600 PPM
70 %
23 °C
18 °C
19 L
40.64 cm
Nutrients 3
Cal-Mag 1.057 mll
V2 Vegetative Part 2 5.859 mll
V1 Vegetative Part 1 5.859 mll
ReeferRiz Roots have yet to hit the water probably within the next couple days! Running the new humidifier its making a very stable environment i went with the ac infinity I believe its the t3? It goes with the new controller i just purchased planning to make my entire system automated. I have inline fan with filter bringing in clean air and an exhaust with a carbon (to eliminate smell) both are 4 inch s4 ac infinity as well. (Also just purchased 2 of the new oscillating fans from ac infinity as well and they also tie into said controller) 😎
2 likes
2 comments
Share
3
Week 3. Vegetation
1y ago
7.62 cm
17 hrs
24 °C
6.4
No Smell
600 PPM
60 %
18 °C
18 °C
19 L
40.64 cm
Nutrients 4
Hydrogen peroxide 3% 5.208 mll
Cal-Mag 1.057 mll
V2 Vegetative Part 2 5.859 mll
ReeferRiz Plant is doing well we are at node number 4 I plan to top this week at the end of the week to give the plant some time to make sure I top and dont miss 😉 upped the lights to 75% dimming for veg and noticed the water had changed temp and had begun to rise over 70 degrees to combat this i froze water bottles and use 2 of them to bring temps down to as low as 65 but never lower than 60 to make sure we dont disrupt the growing process. I havent changed the mixture yet i plan to push more ppm next week! Also dialed back humidity about 10% were sitting between 50-65% humidity now.
4 likes
1 comment
Share
Used techniques
Topping
Technique
4
Week 4. Vegetation
1y ago
12.7 cm
17 hrs
24 °C
5.8
No Smell
400 PPM
60 %
18 °C
18 °C
19 L
40.64 cm
Nutrients 3
Hydrogen peroxide 3% 1.302 mll
V2 Vegetative Part 2 1.302 mll
V1 Vegetative Part 1 1.302 mll
ReeferRiz Upon changing water last week I began to notice burning on the tips of the leaves… at first I had thought it was ph problems and an iron deficiency since it had began on lower portion of plant my hypothesis seemed correct but I had found otherwise throughout the week that had just not been the case… upon more research on floraflex I found that it calls for no cal mag and that is now what I suspected to be the culprit of my problem is now nutrient burn… i gave her a flush at beginning of this week as well as a new set of nutrients our ppm is half of what it was now im sitting at .8 ec and kept the ph lower to 5.8 to ensure we can intake all the nutrient value needed… still adding frozen water bottles to the bucket as the temps are still high but also noticed my peroxide has gone bad so I fetched a new bottle as i began to notice root rot beginning… cookies strains are tough to grow! I knew this would be a challenge and im still up to the task! I will be ordering some hydrogaurd as for once peroxide is not doing the trick! Anyway im expecting at least another week of recovery so probably not much in the upcoming diaries but i will keep you updated!
Get a chiller for that water or you’re gonna have issues man. I tried the exact same setup. The black buckets attracted heat and make it impossible to keep cold enough to not have bacteria.