tsf_homegrow In this grow, I'll test my new setup and see how it works. The changes affect everything except the light and the tent; all other components have been replaced with AC Infinity products. Additionally, I now have the Autopot Flexi 4 system to optimize irrigation, and thanks to Athena, I have a fully blended program as a year's supply for testing. 🎉💛🏽
8/29/25 - 1x Frost Banger, 2x Z-Up, 1x Papaya Cookies in pH-adjusted tap water for germination. The jars are placed on a stainless steel tray placed on a heat mat set to 25 degrees.
8/31/25-10:48 AM - 100% germination, I'll pot them up this evening or tomorrow at noon. They'll then go directly into the 20-liter fabric pots from the Autopot system. I'll fill these with a roughly 55/45 mix of Canna Coco Professionel plus/perlite from Knauf as substrate. I use the Autopot Airbase for drainage.
8/31/25-8:18 PM: All planted and watered with 50 ml per pot each with 4 ml/liter of root juice pH 6.0. I hope the roots will sprout well, quickly, and properly. Mycorrhiza was also added to each pot per eyeball measurement. 😂
3 likes
2 comments
Share
Used method
Glass Of Water
Germination Method
1
Week 1. Vegetation
1y ago
1/11
2 cm
Height
19 hrs
Light Schedule
27 °C
Day Air Temp
5.6
pH
No Smell
Smell
630 PPM
TDS
80 %
Air Humidity
19 °C
Solution Temp
22 °C
Night Air Temp
20 liters
Pot Size
0.02 liters
Watering Volume
65 cm
Lamp Distance
Nutrients 4
CANNA pH- Grow
1 mll
Grow B
0.5 mll
Grow A
0.5 mll
tsf_homegrow 🇬🇧 2/9/25 - they’re all above the substrate. 🎉 The Papaya Cookies are in a hurry and arrived first. The Frost Banger came next, and the two Z-Ups were also in action yesterday evening and this morning.
On their third day in the ground, it was time to water them again today. I added a little more this time, a good 200ml per pot, perhaps a bit much, but it distributes well in the pot, and I also want to avoid the roots coming into contact with dry substrate. 😅💛
9/8/25 - Cancelled after realizing I hadn’t done enough research beforehand about coco as a substrate. As a result, I watered too little. After 5-6 days, I noticed something was wrong and couldn’t really save it. I’ll start again at the end of September on soil (light mix). 💛🏽
@@Yan420, unfortunately, I went with coco due to lack of experience. 😅💛🏽 But at the end of September, beginning of October, I'll be back at it with lightmix again.
@tsf_homegrow, I didn't understand, bro, what do you mean exactly? I've been growing only with Coco coir for the last 5 years and I've always been satisfied.
@@Yan420, I don't really have a green thumb when it comes to watering. And I noticed the difference between coco and soil, and my few successes were with light mix from Canna or Biobizz, which is underrated. I don't know exactly what the issue is, but every time I've tried a change in substrate, I've had problems and ended up going back to the light mix. In this case, the plants also died on me. They were very slow, and I ended up giving up.