The Agnostic Church 01

Target Vapor Pressure Deficit (VPD): 1.3-1.4kPa Letting the plant do its own thing, keeping the environment in check, and letting it defoliate itself. Sure, some lower leaves are yellowing, but I am going to let the plant go through its normal life cycle so that I don’t screw up its chemical balances. Stretch has slowed, and flowers are forming. There isn’t much for aroma yet though. I forgot to mention the other week that I figured out how to take somewhat okay pictures. I have been putting my green gardening LED sunglasses in front of the lens of my camera. It takes out the weird red/purple of the LED grow light pretty well and corrects the coloring of the environment virtually perfectly. RECAP OF THE GROW SO FAR: Target VPD for the week 1-2 seedling cycle was 0.7kPa. Target VPD for the week 3-4 veg cycle was 1.0kPa. Target VPD for the week 5+ flower cycle is 1.3-1.4kPa. I am using KIS Organics Water Only Soil with Biochar. This is a living organic compost soil that theoretically should be enough nutrients for the plant through the whole grow. The Nutrient Pack will be used on week 4 (was going to be weeks 4 & 6, but don’t need to now with the shorter veg cycle), Recharge will only be used if growth slows down too much, and Mammoth P will be used one week before and during flowering (was going to be 2 weeks before, but couldn’t because of the shorter veg cycle). The Autopot is a bottom watering unit that uses a float system to turn the water flow on and off, and I won’t need to manually water the plant, but you do need to top-water for the first 7-10 days until the roots get low enough to reach the Autopot tub. Also the supplements mentioned above need to be top-watered on because you cannot run organic supplements through the Autopot lines. Important to note though: do not top-water your Autopots when using synthetic nutrients. Every light cycle stage is/will be programmed with a sunrise and sunset mode where the light intensity starts low and increases, peaks, and then gradually dims before shut off. During week 1 and 2 I ran with a lower intensity and bluer color, and the actual watt average during the light cycle was only at 238W. For week 3 and 4 I changed my light to autorun mode, which is a stronger intensity but still has more blue during the light cycle, and the average light wattage in this cycle is 451W. Autorun mode is the Kind LED K5 XL1000’s default factory setting for a standard sunrise to sunset veg cycle. When I changed to the flower cycle at week 5 I programmed for full spectrum and intensity, but still with a sunrise and sunset ramp up and down. The actual average wattage during the flower cycle is 525W. I really like the Pulse One monitor. It really helps me to keep everything dialed in at all times. The graphing feature is a really great addition because I can now see how bad the environment of the tent would have been without some fine tuning. I fimmed about a week before flipping the lights, but it seemed to be recovering nicely. I’m still on the fence about fimming at this time though, since I think the plant would have turned out about the same anyway. GROW SETUP (For extended explanations of why I went these routes see my Week 1 entry): GROWING MEDIUM: - Kis Organics: Water Only Soil with Biochar (50%) - Espoma: Organic Perlite (50%) TENT: - Gorilla Grow Tent: Lite Line, 4’x4’ WATERING SYSTEM: - Autopots: Smart Pot XL SUPPLEMENTS: - General Hydroponics: CaMg+ (just a little bit) - KIS Organics: Nutrient Pack (4th week top dressing) - Real Growers: Recharge (only if needed) - Growcentia: Mammoth P (1 week before & during flower) LIGHTING: - Kind LED: K5 XL1000 HUMIDITY CONTROL (I usually run dry): - Elechomes: UC5501 Ultrasonic Humidifier VENTILATION: - AC Infinity: Cloudline T6 CO2: - 2x Exhale: The XL MONITORING: - Pulse One: Temp, RH, and VPD monitor over WiFi - Hydrofarm: CO2 Monitor Please also check out my other journal, Holy Grail Kush, by DNA Genetics: https://growdiaries.com/diaries/29541-holy-agnostic-grail-kush-01