White Widow fem CropKingseeds

[6/9] - I may have Mainlined a bit too early on 2 or all plants. There are little nubs that count as 3rd nodes, but they so tiny! I wanted to get it done to allow time to recover and veg. One or two leaves on a plant look like nutrient burn, but I thing it may be stress or pH problem on that plant. I don't know it is new growth. Also, I expect to see problems this week as I did not use my pH meter but I guessed based on what I had been doing last week. I just hope the plants forgive me! It was challenging to put enough pressure to LST well without breaking the stems. Some I was able to be aggressive others not as much. It will take daily to every other day adjustment and moving of tie downs for the foreseeable future. I used 10 gauge spool wite, but its stranded wire so it kind of sucks. I would prefer solid piece wire. I had turned down the heat because it was getting in the 90s, but then it dropped to 75, so up it goes again! Today I added 1 gallon of nutes to each plant; will water again on Saturdsay I think. [6/10] - LST snapped Plant B's 2nd node today. All other LST good. Removed LST from Plant B until its determined if I have supercropped unintentionally or reduced by Colas from 8 to 6 lol. Also, wtf! The light and heat are off! Who what and how!? It comes back to the timer/constant power strip being off. It must have been triggered somehow. I removed any tension on the device to eliminate what may have been the problem. Hopefully Flowering or hermis were not triggered. The humidity was 100% with a temp of 55 degrees. Jesus!!! I guess I am checking the plants before work at 5:30am now. Loverly. [6/12] - When waiting for the 4th node on the second cutting during Nebula, wait 1-2 more days if its too close to call and you risk cutting the nodes you need. Now I have a plant with only 5 node points which will make the colas either taller or fatter or both making it harder to dial in temp humidity and light during flowering.